Explore Research Products in the PAR
It may take a few hours for recently added research products to appear in PAR search results.


Title: Hole transport layer selection for stable and efficient carbon electrode-based perovskite solar cells
This study compares Spiro-OMeTAD, CuSCN, and PTAA as hole transport layers in carbon-based perovskite solar cells. Spiro-OMeTAD showed best efficiency, CuSCN better stability, while PTAA underperformed, highlighting a performance-stability trade-off.  more » « less
Award ID(s):
2413632 2329871 2330738
PAR ID:
10608449
Author(s) / Creator(s):
; ; ; ; ;
Publisher / Repository:
Royal Society of Chemistry
Date Published:
Journal Name:
RSC Advances
Volume:
15
Issue:
17
ISSN:
2046-2069
Page Range / eLocation ID:
13681 to 13690
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. ; ; ; ; ; (, Energy & Environmental Science)
    null (Ed.)
    While typical perovskite solar cells (PSCs) with doped Spiro-OMeTAD as a hole transport material (HTM) have shown rapid increase in their power-conversion efficiencies (PCEs), their poor stability remains a big concern as the dopants and additives used with Spiro-OMeTAD have a strong tendency to diffuse into and degrade the perovskite active layer under normal operating conditions. Aiming to push forward the development of PSCs, many dopant-free small-molecular HTMs have been reported based on energetic considerations for charge transfer and criteria for charge transport. However, the PCEs of the state-of-the-art PSCs with dopant-free small-molecular HTMs are still inferior to those using doped Spiro-OMeTAD, and little attention has been paid to the interactions between the HTM and perovskite absorber in PSCs. Here, we report a facile design concept to functionalize HTMs so that they can passivate perovskite surface defects and enable perovskite active layers with lower density of surface trap states and more efficient charge transfer to the hole transport layer. As a consequence, perovskite solar cells with a functionalized HTM exhibit a champion PCE of 22.4%, the highest value for PSCs using dopant-free small molecular HTMs to date, and substantively improved operational stability under continuous illumination. With a T 80 of (1617 ± 7) h for encapsulated cells tested at 30 °C in air, the PSCs containing the functionalized HTM are among the most stable PSCs using dopant-free small-molecular HTMs. The effectiveness of our strategy is demonstrated in PSCs comprising both a state-of-the-art MA-free perovskite and MAPbI, a system having more surface defects, and implies the potential generality of our strategy for a broad class of perovskite systems, to further advance highly efficient and stable solar cells. 
    more » « less
  2. ; ; ; ; (, Materials Chemistry Frontiers)
    Thin films of amorphous small molecule semiconductors are widely used in organic light emitting displays and have promising applications in solar cells and thermoelectric devices. Adding dopants increases the conductivity of organic semiconductors, but high concentrations of dopants can disrupt their structural ordering, alter the shape of the electronic density of states in the material, and increase the effects of Coulomb interactions on charge transport. Electrical doping of the solution processable hole-transport material 2,2′,7,7′-tetrakis[ N , N -di(4-methoxyphenyl)amino]-9,9′-spirobifluorene (spiro-OMeTAD) was studied with 2,3,5,6-tetrafluoro-7,7,8,8-tetracyanoquinodimethane (F 4 TCNQ) as a p-type dopant. Infiltration of F 4 TCNQ from the vapor phase into films of spiro-OMeTAD provided a route to highly doped films with up to 39 ± 2 mol% doping. Structural characterization confirmed that the films remain amorphous even at the highest doping levels with no apparent phase separation. We quantitatively determined the carrier concentration using UV-Vis spectroscopy to interpret the evolution of the electrical conductivity. Over the range of carrier concentrations (10 19 –10 20 1 cm −3 ), the electrical conductivity increased no more than linearly with carrier concentration, while the thermopower had a small increase with carrier concentration. The trends in conductivity and thermopower were related to the unique electronic structure of spiro-OMeTAD, which is able to support two carriers per molecule. Temperature-dependent conductivity measurements were used to further analyze the transport mechanism. 
    more » « less
  3. ; ; ; ; (, Energy Advances)
    Photo-accelerated oxidization enables fast production of a Spiro-OMeTAD hole transport layer in perovskite solar cells. This strategy delivers high power conversion efficiency and overcomes barriers to mass manufacturing. 
    more » « less
  4. ; ; ; ; ; ; ; ; ; (, Applied Physics Letters)
    Hydrophobic and long-chain molecule oleylamine is used to modify the spiro-OMeTAD matrix, which is then adopted for the hole-transport layer in perovskite solar cells. It is observed that after moderate doping, the power conversion efficiency of the devices increases from 17.82 (±1.47)% to 20.68 (±0.77)%, with the optimized efficiency of 21.57% (AM 1.5G, 100 mW/cm2). The improved efficiency is ascribed to the favored charge extraction and retarded charge recombination, as reflected by transient photovoltage/photocurrent curves and impedance spectroscopy measurement. In addition, the grazing incidence photoluminescence spectrum reveals that oleylamine doping causes a blue shift of the luminescence peak of the surface layer of the halide perovskite film, while the Mott−Schottky study observes 100 mV increment in the built-in potential, both of which indicate possible defect passivation behavior on the perovskite. Moreover, an accelerated damp test observes that moisture resistance of the device is also upgraded, which is due to the improved hydrophobicity of the spiro-OMeTAD matrix. 
    more » « less
  5. ; ; ; ; ; ; ; ; ; (, Angewandte Chemie International Edition)
    Abstract The chemiluminescent light‐emission pathway of phenoxy‐1,2‐dioxetane luminophores attracts growing interest within the scientific community. Dioxetane probes undergoing rapid flash‐type chemiexcitation exhibit higher detection sensitivity than those with a slow glow‐type chemiexcitation rate. We discovered that dioxetanes fused to non‐strained six‐member rings, with hetero atoms or inductive electron‐withdrawing groups, present both accelerated chemiexcitation rates and elevated chemical stability compared to dioxetanes fused to four‐member strained rings. DFT computational simulations supported the chemiexcitation acceleration observed by spiro‐fused six‐member rings with inductive electron‐withdrawing groups of dioxetanes. Specifically, a spiro‐dioxetane with a six‐member sulfone ring exhibited a chemiexcitation rate 293‐fold faster than that of spiro‐adamantyl‐dioxetane. A turn‐ON dioxetane probe for the detection of the enzyme β‐galactosidase, containing the six‐member sulfone unit, exhibited a S/N value of 108 in LB cell growth medium. This probe demonstrated a substantial increase in detection sensitivity towardsE. colibacterial cells expressing β‐galactosidase, with an LOD value that is 44‐fold more sensitive than that obtained by the adamantyl counterpart. The accelerated chemiexcitation and the elevated chemical stability presented by dioxetane containing a spiro‐fused six‐member ring with a sulfone inductive electron‐withdrawing group, make it an ideal candidate for designing efficient turn‐on chemiluminescent probes with exceptionally high detection sensitivity. 
    more » « less
  • Citation Formats
  • MLA
  • APA
  • Chicago
  • BibTeX
  • Text Encoded Conversion
  • XML
  • Save / Share this Record
  • Send to Email