An official website of the United States government
Abstract On 19 September 2022, a major earthquake struck the northwestern Michoacán segment along the Mexican subduction zone. A slip model is obtained that satisfactorily explains geodetic, teleseismic, and tsunami observations of the 2022 event. The preferred model has a compact large-slip patch that extends up-dip and northwestward from the hypocenter and directly overlaps a 1973 Mw 7.6 rupture. Slip is concentrated offshore and below the coast at depths from 10 to 30 km with a peak value of ∼2.9 m, and there is no detected coseismic slip near the trench. The total seismic moment is 3.1×1020 N·m (Mw 7.6), 72% of which is concentrated in the first 30 s. Most aftershocks are distributed in an up-dip area of the mainshock that has small coseismic slip, suggesting near-complete strain release in the large-slip patch. Teleseismic P waveforms of the 2022 and 1973 earthquakes are similar in duration and complexity with high cross-correlation coefficients of 0.68–0.98 for long P to PP signal time windows, indicating that the 2022 earthquake is a quasi-repeat of the 1973 earthquake, possibly indicating persistent frictional properties. Both the events produced more complex P waveforms than comparable size events along Guerrero and Oaxaca, reflecting differences in patchy locking of the Mexican megathrust.
more »
« less
The 2021 M W 8.1 Kermadec Earthquake Sequence: Great Earthquake Rupture Along the Mantle/Slab Contact
Abstract Most great earthquakes on subduction zone plate boundaries have large coseismic slip concentrated along the contact between the subducting slab and the upper plate crust. On 4 March 2021, a magnitude 7.4 foreshock struck 1 hr 47 min before a magnitude 8.1 earthquake along the northern Kermadec island arc. The mainshock is the largest well‐documented underthrusting event along the ∼2,500‐km long Tonga‐Kermadec subduction zone. Using teleseismic, geodetic, and tsunami data, we find that all substantial coseismic slip in the mainshock is located along the mantle/slab interface at depths from 20 to 55 km, with the large foreshock nucleating near the down‐dip edge. Smaller foreshocks and most aftershocks are located up‐dip of the mainshock, where substantial prior moderate thrust earthquake activity had occurred. The upper plate crust is ∼17 km thick in northern Kermadec with only moderate‐size events along the crust/slab interface. A 1976 sequence withMWvalues of 7.9, 7.8, 7.3, 7.0, and 7.0 that spanned the 2021 rupture zone also involved deep megathrust rupture along the mantle/slab contact, but distinct waveforms exclude repeating ruptures. Variable waveforms for eight deep M6.9+ thrusting earthquakes since 1990 suggest discrete slip patches distributed throughout the region. The ∼300‐km long plate boundary in northern Kermadec is the only documented subduction zone region where the largest modeled interplate earthquakes have ruptured along the mantle/slab interface, suggesting that local frictional properties of the putatively hydrated mantle wedge may involve a dense distribution of Antigorite‐rich patches with high slip rate velocity weakening behavior in this locale.
more »
« less
- Award ID(s):
- 1802364
- PAR ID:
- 10611472
- Publisher / Repository:
- American Geophysical Union
- Date Published:
- Journal Name:
- Journal of Geophysical Research: Solid Earth
- Volume:
- 130
- Issue:
- 4
- ISSN:
- 2169-9313
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
The role of upper‐plate faulting in the seismic cycle of large megathrust earthquakes remains poorly understood. We use quasi‐dynamic numerical simulations of seismic cycles to analyze the interaction between crustal faulting and the foreshock sequence of the 2014 Iquique (Mw 8.2) earthquake in Northern Chile. Multi‐cycle models incorporating upper‐plate faulting align better with coseismic displacements, replicating events akin to the Iquique earthquake. Upper‐plate faulting significantly influences foreshock seismicity and deformation patterns. By calibrating the average hydraulic state—varying the effective normal stress—along the megathrust with pre‐earthquake seismicity, we find that lower pore pressure ratios result in more seismicity before the mainshock. This implies that the hydraulic state of the megathrust is critical for foreshock activity. This comprehensive modeling approach underscores the importance of the mechanical interplay between the megathrust and upper‐plate faults in precursory sequences of large subduction zone earthquakes.more » « less
-
ABSTRACT The July 2019 Ridgecrest, California, earthquake sequence involved two large events—the M 6.4 foreshock and the M 7.1 mainshock that ruptured a system of intersecting strike-slip faults. We present analysis of space geodetic observations including Synthetic Aperture Radar and Global Navigation Satellite System data, geological field mapping, and seismicity to constrain the subsurface rupture geometry and slip distribution. The data render a complex pattern of faulting with a number of subparallel as well as cross-cutting fault strands that exhibit variations in both strike and dip angles, including a “flower structure” formed by shallow splay faults. Slip inversions are performed using both homogeneous and layered elastic half-space models informed by the local seismic tomography data. The inferred slip distribution suggests a moderate amount of the shallow coseismic slip deficit. The peak moment release occurred in the depth interval of 3–4 km, consistent with results from previous studies of major strike-slip earthquakes, and the depth distribution of seismicity in California. We use the derived slip models to investigate stress transfer and possible triggering relationships between the M 7.1 mainshock and the M 6.4 foreshock, as well as other moderate events that occurred in the vicinity of the M 7.1 hypocenter. Triggering is discouraged for the average strike of the M 7.1 rupture (320°) but encouraged for the initial orientation of the mainshock rupture suggested by the first-motion data (340°). This lends support to a scenario according to which the earthquake rupture nucleated on a small fault that was more optimally oriented with respect to the regional stress and subsequently propagated along the less-favorably oriented pre-existing faults, possibly facilitated by dynamic weakening. The nucleation site of the mainshock experienced positive dynamic Coulomb stress changes that are much larger than the static stress changes, yet the former failed to initiate rupture.more » « less
-
Abstract Slow slip events (SSEs) have been observed in spatial and temporal proximity to megathrust earthquakes in various subduction zones, including the 2014Mw7.3 Guerrero, Mexico earthquake which was preceded by aMw7.6 SSE. However, the underlying physics connecting SSEs to earthquakes remains elusive. Here, we link 3D slow‐slip cycle models with dynamic rupture simulations across the geometrically complex flat‐slab Cocos plate boundary. Our physics‐based models reproduce key regional geodetic and teleseismic fault slip observations on timescales from decades to seconds. We find that accelerating SSE fronts transiently increase shear stress at the down‐dip end of the seismogenic zone, modulated by the complex geometry beneath the Guerrero segment. The shear stresses cast by the migrating fronts of the 2014Mw7.6 SSE are significantly larger than those during the three previous episodic SSEs that occurred along the same portion of the megathrust. We show that the SSE transient stresses are large enough to nucleate earthquake dynamic rupture and affect rupture dynamics. However, additional frictional asperities in the seismogenic part of the megathrust are required to explain the observed complexities in the coseismic energy release and static surface displacements of the Guerrero earthquake. We conclude that it is crucial to jointly analyze the long‐ and short‐term interactions and complexities of SSEs and megathrust earthquakes across several (a)seismic cycles accounting for megathrust geometry. Our study has important implications for identifying earthquake precursors and understanding the link between transient and sudden megathrust faulting processes.more » « less
-
null (Ed.)ABSTRACT We investigate the deformation processes during the 2019 Ridgecrest earthquake sequence by combining Global Navigation Satellite Systems, strong-motion, and Interferometric Synthetic Aperture Radar datasets in a joint inversion. The spatial complementarity of slip between the Mw 6.4 foreshock, Mw 7.1 mainshock, and afterslip suggests the importance of static stress transfer as a triggering mechanism during the rupture sequence. The coseismic slip of the foreshock concentrates mainly on the east-northeast–west-southwest fault above the hypocenter at depths of 2–8 km. The slip distribution of the mainshock straddles the region above the hypocenter with two isolated patches located to the north-northwest and south-southeast, respectively. The geodetically determined moment magnitudes of the foreshock and mainshock are equivalent to moment magnitudes Mw 6.4 and 7.0, assuming a rigidity of 30 GPa. We find a significant shallow slip deficit (>60%) in the Ridgecrest ruptures, likely resulting from the immature fault system in which the sequence occurred. Rapid afterslip concentrates at depths of 2–6 km, surrounding the rupture areas of the foreshock and mainshock. The ruptures also accelerated viscoelastic flow at lower-crustal depths. The Garlock fault was loaded at several locations, begging the question of possible delayed triggering.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript
- Journal Article:
- https://doi.org/10.1029/2024JB030926
