An official website of the United States government
Despite significant interest in their functional properties, the mechanical behavior of high-entropy oxides (HEOs) is not well studied, particularly at elevated temperatures. Bulk (Co,Cu,Mg,Ni,Zn)O (transition metal (TM)-HEO) samples were deformed under compression at applied stresses and temperatures ranging from 5 to 31 MPa and 600 to 850 °C, respectively. All of the deformation conditions result in creep stress exponents of n < 3, indicating that TM-HEO exhibits superplastic deformation. A transition from structural to solution-precipitation-based superplasticity is observed during deformation above 650 °C. Additionally, TM-HEO exhibits shear-thickening behavior when deformed at stresses above 9 MPa. The formation and behavior of a Cu-rich tenorite secondary phase during deformation is identified as a key factor underpinning the deformation mechanisms. The microstructure and phase state of TM-HEO before deformation also influenced the behavior, with finer grain sizes and increasing concentrations of Cu-rich tenorite, resulting in the increased prevalence of solution-precipitation deformation. While complex, the results of this study indicate that TM-HEO deforms through known superplastic deformation mechanisms. Superplasticity is a highly efficient manufacturing method and could prove to be a valuable strategy for forming HEO ceramics into complex geometries.
more »
« less
This content will become publicly available on October 28, 2026
Low‐Temperature Superplastic Forming of High‐Entropy Oxides
High‐entropy oxides (HEOs) are being extensively studied for various functional applications, but there is limited research into the mechanical behavior of these materials, especially at elevated temperatures. Bulk (Co, Cu, Mg, Ni, Zn)O (transition metal (TM)‐HEO) samples are formed into dome shapes at 800 °C and 70 kPa. Deformation experiments and finite element analysis (FEA) reveal that TM‐HEO has a creep stress exponent ofn = 0.6, indicating that TM‐HEO deforms through superplastic deformation and exhibits shear‐thickening behavior. Comparisons of experimental strain rates to those calculated using existing superplasticity mechanism models signify that TM‐HEO deforms through grain boundary sliding accommodated by a solution‐precipitation mechanism from a secondary phase. A Cu‐rich tenorite phase, commonly observed in the grain boundaries of TM‐HEO, is proposed as the secondary phase facilitating deformation. It is important to highlight here that the superplastic deformation behavior in TM‐HEO is active under modest temperature and pressure conditions, as noted above. Low‐temperature superplastic deformation will provide a powerful method of manufacturing HEO ceramics into net shape parts, greatly expanding their potential applications.
more »
« less
- Award ID(s):
- 2414950
- PAR ID:
- 10653463
- Publisher / Repository:
- Wiley-VCH GmbH
- Date Published:
- Journal Name:
- Advanced Engineering Materials
- ISSN:
- 1438-1656
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
High-entropy oxides (HEOs) containing five or more cations have garnered significant attention recently due to their vastly tunable compositional space, along with their remarkable physical and mechanical properties, exceptional thermal stability, and phase reversibility at elevated temperatures. These characteristics position HEOs as promising candidates for structural components and coatings in high-temperature applications. While much of the ongoing research on HEOs centers around understanding processing-structure relationships, there remains a dearth of knowledge concerning their mechanical properties, crucial for their prospective high-temperature applications. Whether in bulk form or as coatings, the efficacy of HEOs hinges on robust mechanical properties across a spectrum of temperatures, to ensure structural integrity, fracture resistance, and resilience to thermal stress. This review offers a succinct synthesis of recent advancements in HEO research, spanning from processing techniques to mechanical behaviors under extreme conditions. Emphasis is placed on three key aspects: (1) Investigating the influence of processing parameters on HEO crystal structures. (2) Analyzing the interplay between crystal structure and mechanical properties, elucidating deformation mechanisms. (3) Examining the mechanical behavior of HEOs under extreme temperatures and pressures. Through this review, we aim to illuminate the effective control of HEOs’ unique structures and mechanical properties, paving the way for their future applications in extreme environments.more » « less
-
The strength of lithospheric plates is a central component of plate tectonics, governed by brittle processes in the shallow portion of the plate and ductile behavior in the deeper portion. We review experimental constraints on ductile deformation of olivine, the main mineral in the upper mantle and thus the lithosphere. Olivine deforms by four major mechanisms: low-temperature plasticity, dislocation creep, dislocation-accommodated grain-boundary sliding (GBS), and diffusion-accommodated grain-boundary sliding (diffusion creep). Deformation in most of the lithosphere is dominated by GBS, except in shear zones—in which diffusion creep dominates—and in the brittle-ductile transition—in which low-temperature plasticity may dominate. We find that observations from naturally deformed rocks are consistent with extrapolation of the experimentally constrained olivine flow laws to geological conditions but that geophysical observations predict a weaker lithosphere. The causes of this discrepancy are unresolved but likely reside in the uncertainty surrounding processes in the brittle-ductile transition, at which the lithosphere is strongest. ▪ Ductile deformation of the lithospheric mantle is constrained by experimental data for olivine. ▪ Olivine deforms by four major mechanisms: low-temperature plasticity, dislocation creep, dislocation-accommodated grain-boundary sliding, and diffusion creep. ▪ Observations of naturally deformed rocks are consistent with extrapolation of olivine flow laws from experimental conditions. ▪ Experiments predict stronger lithosphere than geophysical observations, likely due to gaps in constraints on deformation in the brittle-ductile transition.more » « less
-
Advanced structural materials are expected to display significantly improved mechanical properties and this may be achieved, at least in part, by refining the grain size to the submicrometer or the nanocrystalline range. This report provides a detailed summary of the role of grain size in the mechanical properties of metals. The effect of grain size on the high temperature behavior and the development of superplasticity is illustrated using deformation mechanism maps and the development of exceptional strength through grain refinement hardening at low temperatures is also discussed. It is shown that the deformation mechanism of grain boundary sliding, as developed theoretically, can be used to effectively predict both the high and low temperature behavior of metals having different grain sizes. This analysis explains the increase in strain rate sensitivity in ultrafine-grained metals with low and moderate melting points and the ability to increase both the strength and ductility of these materials to thereby overcome the strength-ductility paradox. The recent development of hybrid materials is also reviewed and it is demonstrated that, although these hybrids have received only limited attention to date, they provide a potential for making significant advances in the production of new structural materials.more » « less
-
Abstract The rocksalt structured (Co,Cu,Mg,Ni,Zn)O entropy-stabilized oxide (ESO) exhibits a reversible phase transformation that leads to the formation of Cu-rich tenorite and Co-rich spinel secondary phases. Using atom probe tomography, kinetic analysis, and thermodynamic modeling, we uncover the nucleation and growth mechanisms governing the formation of these two secondary phases. We find that these phases do not nucleate directly, but rather they first form Cu-rich and Co-rich precursor phases, which nucleate in regions rich in Cu and cation vacancies, respectively. These precursor phases then grow through cation diffusion and exhibit a rocksalt-like crystal structure. The Cu-rich precursor phase subsequently transforms into the Cu-rich tenorite phase through a structural distortion-based transformation, while the Co-rich precursor phase transforms into the Co-rich spinel phase through a defect-mediated transformation. Further growth of the secondary phases is controlled by cation diffusion within the primary rocksalt phase, whose diffusion behavior resembles other common rocksalt oxides. Graphical abstractmore » « less
