An official website of the United States government
Oxidation of isoprene, the biogenic volatile organic compound with the highest emissions globally, is a large source of secondary organic aerosol (SOA) in the atmosphere. Organosulfates, particularly methyltetrol sulfates, formed from acid-driven reactions of isoprene epoxydiols (IEPOX), a key oxidation product, are important contributors to SOA mass. To date, most studies have focused on organosulfate formation on ammonium sulfate particles at low pH. However, recent work has shown sea spray aerosol (SSA) in the accumulation mode (~100 nm) is often quite acidic (pH ~ 2) and IEPOX-derived organosulfates have been identified in marine environments. Herein, we demonstrate that substantial SOA, including organosulfates, are formed on acidic sodium sulfate particles (pH = 1.3), representative of marine aerosol heterogeneously reacting with H2SO4 to form Na2SO4. For acidic sodium and ammonium sulfate particles, 31 and 28% (±1%), respectively, of inorganic sulfate is incorporated into organosulfate species, even though acidic particles with sodium versus ammonium as the primary cation formed 5% (±0.2) less SOA volume and 45% (±6%) less methyltetrol sulfates, suggesting other organosulfates may form. Even though both exhibited core-shell morphology after IEPOX uptake, physicochemical differences were observed via Raman microspectroscopy, with organosulfates identified in both the core and shell of acidic ammonium sulfate SOA particles, but only in the core for acidic sodium sulfate SOA via Raman microspectroscopy. Our results suggest that isoprene-derived SOA formed on aged SSA is potentially an important, but underappreciated, source of SOA and organosulfates in marine and coastal regions and could modify SOA budgets in these environments.
more »
« less
Fine-particle pH for Beijing winter haze as inferred from different thermodynamic equilibrium models
Abstract. pH is an important property of aerosol particles but is difficult to measure directly. Several studies have estimated the pH values for fine particles in northern China winter haze using thermodynamic models (i.e., E-AIM and ISORROPIA) and ambient measurements. The reported pH values differ widely, ranging from close to 0 (highly acidic) to as high as 7 (neutral). In order to understand the reason for this discrepancy, we calculated pH values using these models with different assumptions with regard to model inputs and particle phase states. We find that the large discrepancy is due primarily to differences in the model assumptions adopted in previous studies. Calculations using only aerosol-phase composition as inputs (i.e., reverse mode) are sensitive to the measurement errors of ionic species, and inferred pH values exhibit a bimodal distribution, with peaks between −2 and 2 and between 7 and 10, depending on whether anions or cations are in excess. Calculations using total (gas plus aerosol phase) measurements as inputs (i.e., forward mode) are affected much less by these measurement errors. In future studies, the reverse mode should be avoided whereas the forward mode should be used. Forward-mode calculations in this and previous studies collectively indicate a moderately acidic condition (pH from about 4 to about 5) for fine particles in northern China winter haze, indicating further that ammonia plays an important role in determining this property. The assumed particle phase state, either stable (solid plus liquid) or metastable (only liquid), does not significantly impact pH predictions. The unrealistic pH values of about 7 in a few previous studies (using the standard ISORROPIA model and stable state assumption) resulted from coding errors in the model, which have been identified and fixed in this study.
more »
« less
- PAR ID:
- 10087853
- Date Published:
- Journal Name:
- Atmospheric Chemistry and Physics
- Volume:
- 18
- Issue:
- 10
- ISSN:
- 1680-7324
- Page Range / eLocation ID:
- 7423 to 7438
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
The formation of inorganic fine particulate matter (i.e., iPM2.5) is controlled by the thermodynamic equilibrium partitioning of NH3-NH4+. To develop effective control strategies of PM2.5, we aim to understand the impacts of changes in different precursor gases on iPM2.5 concentrations and partitioning of NH3-NH4+. To understand partitioning of NH3-NH4+ in the southeastern U.S., responses of iPM2.5 to precursor gases in four seasons were investigated using field measurements of iPM2.5, precursor gases, and meteorological conditions. The ISORROPIA II model was used to examine the effects of changes in total ammonia (gas + aerosol), total sulfuric acid (aerosol), and total nitric acid (gas + aerosol) on iPM2.5 concentrations and partitioning of NH3-NH4+. The results indicate that reduction in total H2SO4 is more effective than reduction in total HNO3 and total NH3 to reduce iPM2.5 especially under NH3-rich condition. The reduction in total H2SO4 may change partitioning of NH3-NH4+ towards gas-phase and may also lead to an increase in NO3− under NH3-rich conditions, which does not necessarily lead to full neutralization of acidic gases (pH < 7). Thus, future reduction in iPM2.5 may necessitate the coordinated reduction in both H2SO4 and HNO3 in the southeastern U.S. It is also found that the response of iPM2.5 to the change in total H2SO4 is more sensitive in summer than winter due to the dominance of SO42− salts in iPM2.5 and the high temperature in summer. The NH3 emissions from Animal Feeding Operations (AFOs) at an agricultural rural site (YRK) had great impacts on partitioning of NH3-NH4+. The Multiple Linear Regression (MLR) model revealed a strong positive correlation between cation-NH4+ and anions-SO42− and NO3−. This research provides an insight into iPM2.5 formation mechanism for the advancement of PM2.5 control and regulation in the southeastern U.S.more » « less
-
null (Ed.)Particle acidity (aerosol pH) is an important driver of atmospheric chemical processes and the resulting effects on human and environmental health. Understanding the factors that control aerosol pH is critical when enacting control strategies targeting specific outcomes. This study characterizes aerosol pH at a land-water transition site near Baltimore, MD during summer 2018 as part of the second Ozone Water-Land Environmental Transition Study (OWLETS-2) field campaign. Inorganic fine mode aerosol composition, gas-phase NH3 measurements, and all relevant meteorological parameters were used to characterize the effects of temperature, aerosol liquid water (ALW), and composition on predictions of aerosol pH. Temperature, the factor linked to the control of NH3 partitioning, was found to have the most significant effect on aerosol pH during OWLETS-2. Overall, pH varied with temperature at a rate of −0.047 K−1 across all observations, though the sensitivity was −0.085 K−1 for temperatures > 293 K. ALW had a minor effect on pH, except at the lowest ALW levels (< 1 µg m−3) which caused a significant increase in aerosol acidity (decrease in pH). Aerosol pH was generally insensitive to composition (SO42− , SO42−:NH4+ , Tot-NH3 = NH3 + NH4+), consistent with recent studies in other locations. In a companion paper, the sources of episodic NH3 events (95th percentile concentrations, NH3 > 7.96 µg m−3) during the study are analyzed; aerosol pH was higher by only ~0.1–0.2 pH units during these events compared to the study mean. A case study was analyzed to characterize the response of aerosol pH to nonvolatile cations (NVCs) during a period strongly influenced by primary Chesapeake Bay emissions. Depending on the method used, aerosol pH was estimated to be either weakly (~0.1 pH unit change based on NH3 partitioning calculation) or strongly (~1.4 pH unit change based on ISORROPIA thermodynamic model predictions) affected by NVCs. The case study suggests a strong pH gradient with size during the event and underscores the need to evaluate assumptions of aerosol mixing state applied to pH calculations. Unique features of this study, including the urban land-water transition site and the strong influence of NH3 emissions from both agricultural and industrial sources, add to the understanding of aerosol pH and its controlling factors in diverse environments.more » « less
-
Abstract We use observations from the 2015 Wintertime Investigation of Transport, Emissions, and Reactivity (WINTER) aircraft campaign to constrain the proposed mechanism of Cl2production from ClNO2reaction in acidic particles. To reproduce Cl2concentrations observed during WINTER with a chemical box model that includes ClNO2reactive uptake to form Cl2, the model required the ClNO2reaction probability, γ (ClNO2), to range from 6 × 10−6to 7 × 10−5, with a mean value of 2.3 × 10−5(±1.8 × 10−5). These field‐determined γ (ClNO2) are more than an order of magnitude lower than those determined in previous laboratory experiments on acidic surfaces, even when calculated particle pH is ≤2. We hypothesize this is because thick salt films in the laboratory enhanced the reactive uptake ClNO2compared to that which would occur in submicron aerosol particles. Using the reacto‐diffusive length‐scale framework, we show that the field and laboratory observations can be reconciled if the net aqueous‐phase reaction rate constant for ClNO2(aq) + Cl‐(aq) in acidic particles is on the order of 104s−1. We show that wet particle diameter and particulate chloride mass together explain 90% of the observed variance in the box model‐derived γ (ClNO2), implying that the availability of chloride and particle volume limit the efficiency of the reaction. Despite a much lower conversion of ClNO2into Cl2, this mechanism can still be responsible for the nocturnal formation of 10–20 pptv of Cl2in polluted regions, yielding an atmospherically relevant concentration of Cl atoms the following morning.more » « less
-
The pH of aerosol particles remains challenging to measure because of their small size, complex composition, and high acidity. Acidity in aqueous aerosol particles, which are found abundantly in the atmosphere, impacts many chemical processes from reaction rates to cloud formation. Only one technique – pH paper – currently exists for directly determining the pH of aerosol particles, and this is restricted to measuring average acidity for entire particle populations. Other methods for evaluating aerosol pH include filter samples, particle-into-liquid sampling, Raman spectroscopy, organic dyes, and thermodynamic models, but these either operate in a higher pH range or are unable to assess certain chemical species or complexity. Here, we present a new method for determining acidity of individual particles and particle phases using carbon quantum dots as a novel in situ fluorophore. Carbon quantum dots are easily synthesized, shelf stable, and sensitive to pH in the highly acidic regime from pH 0 to pH 3 relevant to ambient aerosol particles. To establish the method, a calibration curve was formed from the ratiometric fluorescence intensity of aerosolized standard solutions with a correlation coefficient ( R 2 ) of 0.99. Additionally, the pH of aerosol particles containing a complex organic mixture (COM) representative of environmental aerosols was also determined, proving the efficacy of using carbon quantum dots as pH-sensitive fluorophores for complex systems. The ability to directly measure aerosol particle and phase acidity in the correct pH range can help parametrize atmospheric models and improve projections for other aerosol properties and their influence on health and climate.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.5194/acp-18-7423-2018
