An official website of the United States government
Abstract Bedforms of Thwaites Glacier, West Antarctica both record and affect ice flow, as shown by geophysical data and simple models. Thwaites Glacier flows across the tectonic fabric of the West Antarctic rift system with its bedrock highs and sedimentary basins. Swath radar and seismic surveys of the glacier bed have revealed soft‐sediment flutes 100 m or more high extending 15 km or more across basins downglacier from bedrock highs. Flutes end at prominent hard‐bedded moats on stoss sides of the next topographic highs. We use simple models to show that ice flow against topography increases pressure between ice and till upglacier along the bed over a distance that scales with the topography. In this basal zone of high pressure, ice‐contact water would be excluded, thus increasing basal drag by increasing ice‐till coupling and till flux, removing till to allow bedrock erosion that creates moats. Till carried across highlands would then be deposited in lee‐side positions forming bedforms that prograde downglacier over time, and that remain soft on top through feedbacks that match till‐deformational fluxes from well upglacier of the topography. The bedforms of the part of Thwaites surveyed here are prominent because ice flow has persisted over a long time on this geological setting, not because ice flow is anomalous. Bedform development likely has caused evolution of ice flow over time as till and lubricating water were redistributed, moats were eroded and bedforms grew.
more »
« less
Bed-type variability and till (dis)continuity beneath Thwaites Glacier, West Antarctica
Abstract Recent seismic measurements from upper Thwaites Glacier indicate that the bed-type variability is closely related to the along-flow basal topography. In high-relief subglacial highlands, stoss sides of topographic highs have a relatively higher acoustic impedance (‘hard’ bed) with lower acoustic impedance (‘soft’ till) on lee sides. This pattern is similar to observations of many deglaciated terrains. Subglacial hydraulic-potential gradient and its divergence show a tendency for water to diverge over the stoss sides and converge into the lee sides. Convergence favors a thicker or more widespread water system, which can more efficiently decouple ice from the underlying till. Under such circumstances, till deformation does occur but, fluxes are relatively small. Till carried from the lee sides onto stoss sides of downstream bumps should couple to the ice more efficiently, increasing the ability for transport by till deformation. In turn, this suggests that steady-state till transport can be achieved if the stoss-side till layer is thin or discontinuous. In addition, the large basal shear stress generated in the highlands seems too high for a bed lubricated by a continuous although thin deforming till, suggesting till discontinuity, which would allow debris-laden ice to erode bedrock on stoss sides, supplying additional till for transport.
more »
« less
- Award ID(s):
- 1738934
- PAR ID:
- 10139852
- Date Published:
- Journal Name:
- Annals of Glaciology
- ISSN:
- 0260-3055
- Page Range / eLocation ID:
- 1 to 9
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Subglacial till can deform when overriding ice exerts shear traction at the ice–till interface. This deformation leaves a strain signature in the till, aligning grains in the direction of ice flow and producing a range of diagnostic microstructures. Constraining the conditions that produce these kinematic indicators is key to interpreting the myriad of features found in basal till deposits. Here, we used a cryogenic ring shear device with transparent sample chamber walls to slip a ring of temperate ice over a till bed from which we examined the strain signature in the till. We used cameras mounted to the side of the ring shear and bead strings inserted in the till to estimate the strain distribution within the till layer. Following the completion of the experiment, we extracted and analyzed anisotropy of magnetic susceptibility (AMS) samples and created thin sections of the till bed for microstructure analysis. We then compared the AMS and microstructures with the observed strain history to examine the relationship between kinematic indicators and strain in a setting where shear traction is supplied by ice. We found that AMS fabrics show a high degree of clustering in regions of high strain near the ice–till interface. In the uppermost zone of till, k 1 eigenvector azimuths are generally aligned with ice flow, and S 1 eigenvalues are high. However, S 1 eigenvalues and the alignment of the k 1 eigenvector with ice flow decrease nonlinearly with distance from the ice–till interface. There is a high occurrence of microshears in the zone of increased deformation.more » « less
-
null (Ed.)Abstract Rapid ice loss is facilitated by sliding over beds consisting of reworked sediments and erosional products, commonly referred to as till. The dynamic interplay between ice and till reshapes the bed, creating landforms preserved from past glaciations. Leveraging the imprint left by past glaciations as constraints for projecting future deglaciation is hindered by our incomplete understanding of evolving basal slip. Here, we develop a continuum model of water-saturated, cohesive till to quantify the interplay between meltwater percolation and till mobilization that governs changes in the depth of basal slip under fast-moving ice. Our model explains the puzzling variability of observed slip depths by relating localized till deformation to perturbations in pore-water pressure. It demonstrates that variable slip depth is an inherent property of the ice-meltwater-till system, which could help understand why some paleo-landforms like grounding-zone wedges appear to have formed quickly relative to current till-transport rates.more » « less
-
Abstract Subglacial seismicity presents the opportunity to monitor inaccessible glacial beds at the epicentral location and time. Glaciers can be underlain by rock or till, a first order control on bed mechanics. Velocity-weakening, necessary for unstable slip, has been shown for each bed type, but is much stronger and evolves over more than an order of magnitude longer distances for till beds. Utilizing a de-stiffened double direct shear apparatus, we found conditions for instability at freezing temperatures and high slip rates for both bed types. During stick–slip stress-drops, we recorded acoustic emissions with piezoelectric transducers frozen into the ice. The two populations of event waveforms appear visually similar and overlap in their statistical features. We implemented a suite of supervised machine learning algorithms to classify the bed type of recorded waveforms and spectra, with prediction accuracy between 65–80%. The Random Forest Classifier is interpretable, showing the importance of initial oscillation peaks and higher frequency energy. Till beds have generally higher friction and resulting stress-drops, with more impulsive first arrivals and more high frequency content compared to rock emissions, but rock beds can produce many till-like events. Seismic signatures could enhance interpretation of bed conditions and mechanics from subglacial seismicity.more » « less
-
Abstract Glacier-bed characteristics that are poorly known and modeled are important in projected sea-level rise from ice-sheet changes under strong warming, especially in the Thwaites Glacier drainage of West Antarctica. Ocean warming may induce ice-shelf thinning or loss, or thinning of ice in estuarine zones, reducing backstress on grounded ice. Models indicate that, in response, more-nearly-plastic beds favor faster ice loss by causing larger flow acceleration, but more-nearly-viscous beds favor localized near-coastal thinning that could speed grounding-zone retreat into interior basins where marine-ice-sheet instability or cliff instability could develop and cause very rapid ice loss. Interpretation of available data indicates that the bed is spatially mosaicked, with both viscous and plastic regions. Flow against bedrock topography removes plastic lubricating tills, exposing bedrock that is eroded on up-glacier sides of obstacles to form moats with exposed bedrock tails extending downglacier adjacent to lee-side soft-till bedforms. Flow against topography also generates high-ice-pressure zones that prevent inflow of lubricating water over distances that scale with the obstacle size. Extending existing observations to sufficiently large regions, and developing models assimilating such data at the appropriate scale, present large, important research challenges that must be met to reliably project future forced sea-level rise.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1017/aog.2019.32
