ABSTRACT
Hot spring travertine and sinter deposits record discharge from hydrothermal systems through evolving hydrothermal, hydrologic, and tectonic regimes. The location and volume of the largest deposits may reflect persistent or particularly robust periods of hydrothermal
flow. As part of a broader investigation into the chemical evolution of travertine deposits, we used unoccupied aerial vehicles (UAVs) coupled with high-precision GPS surveys to collect and assemble orthorectified photomosaics and high-resolution digital elevation models (DEMs) using structure-from-motion (SfM) software for eight sites in the northern Central Nevada Seismic Belt. These sites range from large, intrabasin travertine mounds to travertine and sinter deposits offset by Quaternary faults. Some highlights of the research made possible by the acquisition of these topographic datasets include: 1) geomorphic evidence that hydrothermal flow at Hyder Hot Springs has persisted since at least the last highstand of glacial Lake Dixie, 2) documenting the impact of hot spring sinter and hydrothermal alteration on the preservation and morphology of Quaternary fault scarp profiles, 3) mapping the extent of a large extinct travertine deposit in the Stillwater Range, and 4) constraints on the offset of hot spring deposits affected by Quaternary faulting at Kyle Hot Springs. Areas between 0.51 – 1.23 km^2 (126-303 acres) were easily acquired with less than half a day of surveying and flying, and models capable of producing orthorectified photomosaics and DEMs with average resolution of 2.5 cm/pixel and 9.7 cm/pixel, respectively, were built on a desktop computer with 1-10 days of processing time. In desert landscapes, the resolution of the resulting DEMs approaches that of bare earth LiDAR datasets at a fraction of the cost, with little to no special permitting in most cases, and with limited preplanning. The imagery and models described herein are freely available from the NSF-EAR-funded data facility OpenTopography
(https://portal.opentopography.org/datasets) for use in commercial, academic, and educational applications with proper attribution.
more »
« less
Airborne Lidar and Electro-Optical Imagery along Surface Ruptures of the 2019 Ridgecrest Earthquake Sequence, Southern California
Abstract Surface rupture from the 2019 Ridgecrest earthquake sequence, initially associated with the Mw 6.4 foreshock, occurred on 4 July on a ∼17 km long, northeast–southwest-oriented, left-lateral zone of faulting. Following the Mw 7.1 mainshock on 5 July (local time), extensive northwest–southeast-oriented, right-lateral faulting was then also mapped along a ∼50 km long zone of faults, including subparallel splays in several areas. The largest slip was observed in the epicentral area and crossing the dry lakebed of China Lake to the southeast. Surface fault rupture mapping by a large team, reported elsewhere, was used to guide the airborne data acquisition reported here. Rapid rupture mapping allowed for accurate and efficient flight line planning for the high-resolution light detection and ranging (lidar) and aerial photography. Flight line planning trade-offs were considered to allocate the medium (25 pulses per square meter [ppsm]) and high-resolution (80 ppsm) lidar data collection polygons. The National Center for Airborne Laser Mapping acquired the airborne imagery with a Titan multispectral lidar system and Digital Modular Aerial Camera (DiMAC) aerial digital camera, and U.S. Geological Survey acquired Global Positioning System ground control data. This effort required extensive coordination with the Navy as much of the airborne data acquisition occurred within their restricted airspace at the China Lake ranges.
more »
« less
- Award ID(s):
- 1830734
- NSF-PAR ID:
- 10163192
- Date Published:
- Journal Name:
- Seismological Research Letters
- ISSN:
- 0895-0695
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
ABSTRACT The July 2019 Ridgecrest, California, earthquake sequence involved two large events—the M 6.4 foreshock and the M 7.1 mainshock that ruptured a system of intersecting strike-slip faults. We present analysis of space geodetic observations including Synthetic Aperture Radar and Global Navigation Satellite System data, geological field mapping, and seismicity to constrain the subsurface rupture geometry and slip distribution. The data render a complex pattern of faulting with a number of subparallel as well as cross-cutting fault strands that exhibit variations in both strike and dip angles, including a “flower structure” formed by shallow splay faults. Slip inversions are performed using both homogeneous and layered elastic half-space models informed by the local seismic tomography data. The inferred slip distribution suggests a moderate amount of the shallow coseismic slip deficit. The peak moment release occurred in the depth interval of 3–4 km, consistent with results from previous studies of major strike-slip earthquakes, and the depth distribution of seismicity in California. We use the derived slip models to investigate stress transfer and possible triggering relationships between the M 7.1 mainshock and the M 6.4 foreshock, as well as other moderate events that occurred in the vicinity of the M 7.1 hypocenter. Triggering is discouraged for the average strike of the M 7.1 rupture (320°) but encouraged for the initial orientation of the mainshock rupture suggested by the first-motion data (340°). This lends support to a scenario according to which the earthquake rupture nucleated on a small fault that was more optimally oriented with respect to the regional stress and subsequently propagated along the less-favorably oriented pre-existing faults, possibly facilitated by dynamic weakening. The nucleation site of the mainshock experienced positive dynamic Coulomb stress changes that are much larger than the static stress changes, yet the former failed to initiate rupture.more » « less
-
The University of Alaska Fairbanks T Field is a legacy farm field that is part of the National Science Foundation (NSF) Funded Permafrost Grown project. We are studying the long-term effects of permafrost thaw following initial clearing for cultivation purposes. In this regard, we have acquired very high resolution light detection and ranging (LiDAR) data and digital photography from a DJI M300 drone using a Zenmuse L1 and a MicaSense RedEdge-P camera. The Zenmuse L1 integrates a Livox Lidar module, a high-accuracy inertial measurement units (IMU), and a camera with a 1-inch CMOS on a 3-axis stabilized gimbal. The MicaSense RedEdge-P camera has five multispectral bands and a high-resolution panchromatic band. The drone was configured to fly in real-time kinematic (RTK) mode at an altitude of 60 meters above ground level using the DJI D-RTK 2 base station. Data was acquired using a 50% sidelap and a 70% frontlap for the Zenmuse L1 and an 80% sidelap and a 75% frontlap for the MicaSense. Additional ground control was established with a Leica GS18 global navigation satellite system (GNSS) and all data have been post-processed to World Geodetic System 1984 (WGS84) universal transverse mercator (UTM) Zone 6 North using ellipsoid heights. Data outputs include a two-class-classified LiDAR point cloud, digital surface model, digital terrain model, an orthophoto mosaic, and a multispectral orthoimage consisting of five bands. Image acquisition occurred on 18 August 2023.more » « less
-
The Midnight Sun Golf Course in Fairbanks, Alaska is a legacy farm field that is part of the National Science Foundation (NSF) Funded Permafrost Grown project. This 65 hectare (ha) parcel was initially cleared for agriculture purposes but changed land-use practices to a golf course around 25 years ago. The land-use conversion was in part due to ice-rich permafrost thaw following clearing. We are studying the long-term effects of permafrost thaw following initial clearing for cultivation purposes. We are working with the current landowners to provide information regarding ongoing thermokarst development on the property and to conduct studies in reforested portions of the land area to understand land clearing and reforestation on permafrost-affected soils. In this regard, we have acquired very high resolution light detection and ranging (LiDAR) data and digital photography from a DJI M300 drone using a Zenmuse L1. The Zenmuse L1 integrates a Livox Lidar module, a high-accuracy inertial measurement units (IMU), and a camera with a 1-inch CMOS on a 3-axis stabilized gimbal. The drone was configured to fly in real-time kinematic (RTK) mode at an altitude of 60 meters above ground level using the DJI D-RTK 2 base station. Data was acquired using a 50% sidelap and a 70% frontlap. Additional ground control was established with a Leica GS18 global navigation satellite system (GNSS) and all data have been post-processed to World Geodetic System 1984 (WGS84) universal transverse mercator (UTM) Zone 6 North using ellipsoid heights. Data outputs include a two-class classified LiDAR point cloud, digital surface model, digital terrain model, and an orthophoto mosaic. Image acquisition occurred on 10 September 2023. The input images are available for download at http://arcticdata.io/data/10.18739/A2PC2TB1T.more » « less
-
Taken together, lakes and drained lake basins may cover up to 80% of the lowland landscapes in permafrost regions of the Arctic. Lake formation, growth, and drainage in lowland permafrost regions create a terrestrial and aquatic landscape mosaic of importance to geomorphic and hydrologic processes, tundra vegetation communities, permafrost and ground-ice characteristics, biogeochemical cycling, wildlife habitat, and human land-use activities. Our project focuses on quantifying the role of thermokarst lake expansion, drainage, and drained lake basin evolution in the Arctic System. We did this through a combination of field studies, environmental sensor networks, remote sensing, and modeling. This dataset consists of an orthomosaic and digital surface model (DSM) derived from drone surveys on 23 July 2022 at Derksen and Schmutz Basins on the Arctic Coastal Plain of northern Alaska. 6,158 digital images were acquired from a DJI Phantom 4 Real-Time Kinematic (DJI P4RTK) quadcopter with a DJI D-RTK 2 Mobile Base Station. The mapped area was around 580 hectares (ha). The drone system was flown at 100 meters (m) above ground level (agl) and flight speeds varied from 7–8 meters/second (m/s). The orientation of the camera was set to 90 degrees (i.e. looking straight down). The along-track overlap and across-track overlap of the mission were set at 80% and 70%, respectively. All images were processed in the software Pix4D Mapper (v. 4.8.4) using the standard 3D Maps workflow and the accurate geolocation and orientation calibration method to produce the orthophoto mosaic and digital surface model at spatial resolutions of 5 and 10 centimeters (cm), respectively. Elevation information derived over waterbodies is noisy and does not represent the surface elevation of the feature. A Leica Viva differential global positioning system (GPS) provided ground control for the mission and the data were post-processed to WGS84 UTM Zone 5 North in Ellipsoid Heights (meters).more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1785/0220190338
