An official website of the United States government
A C-N cross-coupling approach involving oxidative amidations of aromatic aldehydes in the presence of an amide-based nickel(II) pincer catalyst (2) is demonstrated. Upon optimization, quick reaction times (15 min) and an ideal temperature (25 °C) were established and implemented for the conversion of 33 different amide products using only 0.2 mol% of catalyst. Moderate to good turnover numbers (TONs) were obtained for secondary benzamide products, and moderate TONs were obtained for tertiary benzamide products, with the highest turnover number calculated for the 4-chloro-N-(3-phenylpropyl)benzamide product (4i, 309). Gas chromatographic–mass spectrometric (GC–MS) analysis also indicates the formation of alcohols in different reactions, indicating an oxidative amidation process. Kinetic studies were performed by varying the amount of catalyst, aldehyde, LiHMDS base, and amine substrate to determine the order of reaction for each component. Benzaldehyde and benzaldehyde-d6 were reacted with benzylamine, and the kH/kD ratio was determined to understand the rate-determining step. Isotope labeling further revealed that deuterium was being transferred to both the alcohol side product and the target amide product. With the help of kinetic data and UV–visible spectra, a mechanism for the amidation process via the catalyst (2) is proposed through a Ni(I)–Ni(III) pathway.
more »
« less
Hydrogen Movements in the Oxidative Half-Reaction of Kynurenine 3-Monooxygenase from Pseudomonas fluorescens Reveal the Mechanism of Hydroxylation
Kynurenine 3-monoxygenase (KMO) catalyzes the conversion of L-kynurenine (L-Kyn) to 3-hydroxykynurenine (3-OHKyn) in the pathway for tryptophan catabolism. We have investigated the effects of pH and deuterium substitution on the oxidative half-reaction of KMO from P. fluorescens (PfKMO). The three phases observed during the oxidative half reaction are formation of the hydroperoxyflavin, hydroxylation and product release. The measured rate constants for these phases proved largely unchanging with pH, suggesting that the KMO active site is insulated from exchange with solvent during catalysis. A solvent inventory study indicated that a solvent isotope effect of 2 - 3 is observed for the hydroxylation phase and that two or more protons are in flight during this step. An inverse isotope effect of 0.84 0.01 on the rate constant for the hydroxylation step with ring perdeutero-L-Kyn as a substrate indicates a shift from sp2 to sp3 hybridization in the transition state leading to the formation of a non-aromatic intermediate. The pH dependence of transient state data collected for the substrate analog meta-nitrobenzoylalanine indicate that groups proximal to the hydroperoxyflavin are titrated in the range pH 5 - 8.5 and can be described by a pKa of 8.8. That the higher pH values do not slow the rate of hydroxylation precludes that the pKa measured pertains to the proton of the hydroperoxflavin. Together, these observations indicate that the C4a-hydroperoxyflavin has a pKa >> 8.5, that a non-aromatic species is the immediate product of hydroxylation and that at least two solvent derived protons are in-flight during oxygen insertion to the substrate aromatic ring. A unifying mechanistic proposal for these observations is proposed.
more »
« less
- Award ID(s):
- 1904480
- PAR ID:
- 10168001
- Date Published:
- Journal Name:
- Archives of biochemistry and biophysics
- Volume:
- tdb
- Issue:
- tbd
- ISSN:
- 1096-0384
- Page Range / eLocation ID:
- tbd
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
A direct, catalytic conversion of benzene to phenol would have wide-reaching economic impacts. Fe zeolites exhibit a remarkable combination of high activity and selectivity in this conversion, leading to their past implementation at the pilot plant level. There were, however, issues related to catalyst deactivation for this process. Mechanistic insight could resolve these issues, and also provide a blueprint for achieving high performance in selective oxidation catalysis. Recently, we demonstrated that the active site of selective hydrocarbon oxidation in Fe zeolites, named α-O, is an unusually reactive Fe(IV)=O species. Here, we apply advanced spectroscopic techniques to determine that the reaction of this Fe(IV)=O intermediate with benzene in fact regenerates the reduced Fe(II) active site, enabling catalytic turnover. At the same time, a small fraction of Fe(III)-phenolate poisoned active sites form, defining a mechanism for catalyst deactivation. Density-functional theory calculations provide further insight into the experimentally defined mechanism. The extreme reactivity of α-O significantly tunes down (eliminates) the rate-limiting barrier for aromatic hydroxylation, leading to a diffusion-limited reaction coordinate. This favors hydroxylation of the rapidly diffusing benzene substrate over the slowly diffusing (but more reactive) oxygenated product, thereby enhancing selectivity. This defines a mechanism to simultaneously attain high activity (conversion) and selectivity, enabling the efficient oxidative upgrading of inert hydrocarbon substrates.more » « less
-
Reactions in microdroplets can be accelerated and can present unique chemistry compared to reactions in bulk solution. Here, we report the accelerated oxidation of aromatic sulfones to sulfonic acids in microdroplets under ambient conditions without the addition of acid, base, or catalyst. The experimental data suggest that the water radical cation, (H2O)+•, derived from traces of water in the solvent, is the oxidant. The substrate scope of the reaction indicates the need for a strong electron-donating group (e.g., p-hydroxyl) in the aromatic ring. An analogous oxidation is observed in an aromatic ketone with benzoic acid production. The shared mechanism is suggested to involve field-assisted ionization of water at the droplet/air interface, its reaction with the sulfone (M) to form the radical cation adduct, (M + H2O)+•, followed by 1,2-aryl migration and C–O cleavage. A remarkably high reaction rate acceleration (∼103) and regioselectivity (∼100-fold) characterize the reaction.more » « less
-
Solvent isotope effects have long been used as a mechanistic tool for determining enzyme mechanisms. Most commonly, macroscopic rate constants such as kcat and kcat/Km are found to decrease when the reaction is performed in D2O for a variety of reasons including the transfer of protons. Under certain circumstances, these constants are found to increase, in what is termed an inverse solvent kinetic isotope effect (SKIE), which can be a diagnostic mechanistic feature. Generally, these phenomena can be attributed to an inverse solvent equilibrium isotope effect on a rapid equilibrium preceding the rate-limiting step(s). This review surveys inverse SKIEs in enzyme-catalyzed reactions by assessing their underlying origins in common mechanistic themes. Case studies for each category are presented, and the mechanistic implications are put into context. It is hoped that readers may find the illustrative examples valuable in planning and interpreting solvent isotope effect experiments.more » « less
-
null (Ed.)SIRT1 is the most extensively studied human sirtuin with a broad spectrum of endogenous targets. It has been implicated in the regulation of a myriad of cellular events, such as gene transcription, mitochondria biogenesis, insulin secretion as well as glucose and lipid metabolism. From a mechanistic perspective, nicotinamide (NAM), a byproduct of a sirtuin-catalyzed reaction, reverses a reaction intermediate to regenerate NAD+ through “base exchange”, leading to the inhibition of the forward deacetylation. NAM has been suggested as a universal sirtuin negative regulator. Sirtuins have evolved different strategies in response to NAM regulation. Here, we report the detailed kinetic analysis of SIRT1-catalyzed reactions using endogenous substrate-based synthetic peptides. A novel substrate-dependent sensitivity of SIRT1 to NAM inhibition was observed. Additionally, SIRT1 demonstrated pH-dependent deacetylation with normal solvent isotope effects (SIEs), consistent with proton transfer in the rate-limiting step. Base exchange, in contrast, was insensitive to pH changes with no apparent SIEs, indicative of lack of proton transfer in the rate-limiting step. Consequently, NAM inhibition was attenuated at a high pH in proteated buffers. Our study provides new evidence for “activation by de-repression” as an effective sirtuin activation strategy.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- The DOI is not currently available.
