The dynamical core that predicts the three‐dimensional vorticity rather than the momentum, which is called Vector‐Vorticity Model (VVM), is implemented on a cubed sphere. Its horizontal coordinate system is not restricted to orthogonal, while the vertical coordinate is orthogonal to the horizontal surface. Accordingly, all the governing equations of the VVM, which are originally developed with Cartesian coordinates, are rewritten in terms of general curvilinear coordinates. The local coordinates on each cube surface are constructed with the gnomonic equiangular projection. Using global channel domains, the VVM on the cubed sphere has been evaluated by (1) advecting a passive tracer with a bell‐shaped initial perturbation along an east‐west latitude circle and along a north‐south meridional circle and (2) simulating the evolution of barotropic and baroclinic instabilities. The simulated results with the cubed‐sphere grids are compared to analytic solutions or those with the regular longitude‐latitude grids. The convergence with increasing spatial resolution is also quantified using standard error norms. The comparison shows that the solutions with the cubed‐sphere grids are quite reasonable for both linear and nonlinear problems when high resolutions are used. With coarse resolution, degeneracy appears in the solutions of the nonlinear problems such as spurious wave growth; however, it is effectively reduced with increased resolution. Based on the encouraging results in this study, we intend to use this model as the cloud‐resolving component in a global Quasi‐Three‐Dimensional Multiscale Modeling Framework.
- Award ID(s):
- NSF-PAR ID:
- Date Published:
- Journal Name:
- Journal of fluid mechanics
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
The momentum and energy exchanges at the ocean surface are central factors determining the sea state, weather patterns and climate. To investigate the effects of surface waves on the air–sea energy exchanges, we analyse high-resolution laboratory measurements of the airflow velocity acquired above wind-generated surface waves using the particle image velocimetry technique. The velocity fields were further decomposed into the mean, wave-coherent and turbulent components, and the corresponding energy budgets were explored in detail. We specifically focused on the terms of the budget equations that represent turbulence production, wave production and wave–turbulence interactions. Over wind waves, the turbulent kinetic energy (TKE) production is positive at all heights with a sharp peak near the interface, indicating the transfer of energy from the mean shear to the turbulence. Away from the surface, however, the TKE production approaches zero. Similarly, the wave kinetic energy (WKE) production is positive in the lower portion of the wave boundary layer (WBL), representing the transfer of energy from the mean flow to the wave-coherent field. In the upper part of the WBL, WKE production becomes slightly negative, wherein the energy is transferred from the wave perturbation to the mean flow. The viscous and Stokes sublayer heights emerge as natural vertical scales for the TKE and WKE production terms, respectively. The interactions between the wave and turbulence perturbations show an energy transfer from the wave to the turbulence in the bulk of the WBL and from the turbulence to the wave in a thin layer near the interface.more » « less
null (Ed.)The air–sea momentum exchanges in the presence of surface waves play an integral role in coupling the atmosphere and the ocean. In the current study, we present a detailed laboratory investigation of the momentum fluxes over wind-generated waves. Experiments were performed in the large wind-wave facility at the Air–Sea Interaction Laboratory of the University of Delaware. Airflow velocity measurements were acquired above wind waves using a combination of particle image velocimetry and laser-induced fluorescence techniques. The momentum budget is examined using a wave-following orthogonal curvilinear coordinate system. In the wave boundary layer, the phase-averaged turbulent stress is intense (weak) and positive downwind (upwind) of the crests. The wave-induced stress is also positive on the windward and leeward sides of wave crests but with asymmetric intensities. These regions of positive wave stress are intertwined with regions of negative wave stress just above wave crests and downwind of wave troughs. Likewise, at the interface, the viscous stress exhibits along-wave phase-locked variations with maxima upwind of the wave crests. As a general trend, the mean profiles of the wave-induced stress decrease to a negative minimum from a near-zero value far from the surface and then increase rapidly to a positive value near the interface where the turbulent stress is reduced. Far away from the surface, however, the turbulent stress is nearly equal to the total stress. Very close to the surface, in the viscous sublayer, the wave and turbulent stresses vanish, and therefore the stress is supported by the viscosity.more » « less
The interaction of localised solitary waves with large-scale, time-varying dispersive mean flows subject to non-convex flux is studied in the framework of the modified Korteweg–de Vries (mKdV) equation, a canonical model for internal gravity wave propagation and potential vorticity fronts in stratified fluids. The effect of large amplitude, dynamically evolving mean flows on the propagation of localised waves – essentially ‘soliton steering’ by the mean flow – is considered. A recent theoretical and experimental study of this new type of dynamic soliton–mean flow interaction for convex flux has revealed two scenarios where the soliton either transmits through the varying mean flow or remains trapped inside it. In this paper, it is demonstrated that the presence of a non-convex cubic hydrodynamic flux introduces significant modifications to the scenarios for transmission and trapping. A reduced set of Whitham modulation equations is used to formulate a general mathematical framework for soliton–mean flow interaction with non-convex flux. Solitary wave trapping is stated in terms of crossing modulation characteristics. Non-convexity and positive dispersion – common for stratified fluids – imply the existence of localised, sharp transition fronts (kinks). Kinks play dual roles as a mean flow and a wave, imparting polarity reversal to solitons and dispersive mean flows, respectively. Numerical simulations of the mKdV equation agree with modulation theory predictions. The mathematical framework developed is general, not restricted to completely integrable equations like mKdV, enabling application beyond the mKdV setting to other fluid dynamic contexts subject to non-convex flux such as strongly nonlinear internal wave propagation that is prevalent in the ocean.more » « less
Air–sea momentum and scalar fluxes are strongly influenced by the coupling dynamics between turbulent winds and a spectrum of waves. Because direct field observations are difficult, particularly in high winds, many modeling and laboratory studies have aimed to elucidate the impacts of the sea state and other surface wave features on momentum and energy fluxes between wind and waves as well as on the mean wind profile and drag coefficient. Opposing wind is common under transient winds, for example, under tropical cyclones, but few studies have examined its impacts on air–sea fluxes. In this study, we employ a large-eddy simulation for wind blowing over steep sinusoidal waves of varying phase speeds, both following and opposing wind, to investigate impacts on the mean wind profile, drag coefficient, and wave growth/decay rates. The airflow dynamics and impacts rapidly change as the wave age increases for waves following wind. However, there is a rather smooth transition from the slowest waves following wind to the fastest waves opposing wind, with gradual enhancement of a flow perturbation identified by a strong vorticity layer detached from the crest despite the absence of apparent airflow separation. The vorticity layer appears to increase the effective surface roughness and wave form drag (wave attenuation rate) substantially for faster waves opposing wind.
Surface waves increase friction at the sea surface and modify how wind forces upper-ocean currents and turbulence. Therefore, it is important to include effects of different wave conditions in weather and climate forecasts. We aim to inform more accurate forecasts by investigating wind blowing over waves propagating in the opposite direction using large-eddy simulation. We find that when waves oppose wind, they decay as expected, but also increase the surface friction much more drastically than when waves follow wind. This finding has important implications for how waves opposing wind are represented as a source of surface friction in forecast models.