An official website of the United States government
Abstract Articular cartilage is a multiphasic, anisotropic, and heterogeneous material. Although cartilage possesses excellent mechanical and biological properties, it can undergo mechanical damage, resulting in osteoarthritis. Thus, it is important to understand the microscale failure behavior of cartilage in both basic science and clinical contexts. Determining cartilage failure behavior and mechanisms provides insight for improving treatment strategies to delay osteoarthritis initiation or progression and can also enhance the value of cartilage as bioinspiration for material fabrication. To investigate microscale failure behavior, we developed a protocol to initiate fractures by applying a microindentation technique using a well‐defined tip geometry that creates localized cracks across a range of loading rates. The protocol includes extracting the tissue from the joint, preparing samples, and microfracture. Various aspects of the experiment, such as loading profile and solvent, can be adjusted to mimic physiological or pathological conditions and thereby further clarify phenomena underlying articular cartilage failure. © 2021 Wiley Periodicals LLC. Basic Protocol 1: Harvesting and dissection of the joint surfaces Basic Protocol 2: Preparation of samples for microindentation and fatigue testing Basic Protocol 3: Microfracture using microindentation Basic Protocol 4: Crack propagation under cyclic loading
more »
« less
Relaxation capacity of cartilage is a critical factor in rate- and integrity-dependent fracture
Abstract Articular cartilage heals poorly but experiences mechanically induced damage across a broad range of loading rates and matrix integrity. Because loading rates and matrix integrity affect cartilage mechanical responses due to poroviscoelastic relaxation mechanisms, their effects on cartilage failure are important for assessing and preventing failure. This paper investigated rate- and integrity-dependent crack nucleation in cartilage from pre- to post-relaxation timescales. Rate-dependent crack nucleation and relaxation responses were obtained as a function of matrix integrity through microindentation. Total work for crack nucleation increased with decreased matrix integrity, and with decreased loading rates. Critical energy release rate of intact cartilage was estimated as 2.39 ± 1.39 to 2.48 ± 1.26 kJ m−2in a pre-relaxation timescale. These findings showed that crack nucleation is delayed when cartilage can accommodate localized loading through poroviscoelastic relaxation mechanisms before fracture at a given loading rate and integrity state.
more »
« less
- Award ID(s):
- 1662456
- PAR ID:
- 10225803
- Publisher / Repository:
- Nature Publishing Group
- Date Published:
- Journal Name:
- Scientific Reports
- Volume:
- 11
- Issue:
- 1
- ISSN:
- 2045-2322
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Articular cartilage is a thin layer of a solid matrix swollen by fluid, and it protects joints from damage via poroviscoelastic damping. Our previous experimental and simulation studies showed that cartilage-like poroviscoelastic damping could widen the range of damping methods in a low-frequency range (<100 Hz). Thus, the current study aimed to realize cartilage-like damping capacity by single- and two-indenter–foam poroviscoelastic dampers in a low-frequency range. Multiple single-indenter–foam dampers were designed by combining foam sheets with different pore diameters and indenters with different radii. Their damping capacity was investigated by dynamic mechanical analysis in a frequency range of 0.5–100 Hz. Single-indenter–foam dampers delivered peak damping frequencies that depended on the foam’s pore diameter and characteristic diffusion length (contact radii). Those dampers maximize the damping capacity at the desired frequency (narrowband performance). A mechanical model combined with simple scaling laws was shown to relate poroelasticity to the peak damping frequencies reasonably well. Finally, combinations of single-indenter–foam dampers were optimized to obtain a two-indenter–foam damper that delivered nearly rate-independent damping capacity within 0.5–100 Hz (broadband performance). These findings suggested that cartilage-like poroviscoelastic dampers can be an effective mean of passive damping for narrowband and broadband applications.more » « less
-
Water ice Ih exhibits brittle behavior when rapidly loaded. Under tension, it fails via crack nucleation and propagation. Compressive failure is more complicated. Under low confinement, cracks slide and interact to form a frictional (Coulombic) fault. Under high confinement, frictional sliding is suppressed and adiabatic heating through crystallographic slip leads to the formation of a plastic fault. The coefficient of static friction increases with time under load, owing to creep of asperities in contact. The coefficient of kinetic (dynamic) friction, set by the ratio of asperity shear strength to hardness, increases with velocity at lower speeds and decreases at higher speeds as contacts melt through frictional heating. Microcracks, upon reaching a critical number density (which near the ductile-to-brittle transition is nearly constant above a certain strain rate), form a pathway for percolation. Additional work is needed on the effects of porosity and crack healing. ▪ An understanding of brittle failure is essential to better predict the integrity of the Arctic and Antarctic sea ice covers and the tectonic evolution of the icy crusts of Enceladus, Europa, and other extraterrestrial satellites. ▪ Fundamental to the brittle failure of ice is the initiation and propagation of microcracks, frictional sliding across crack faces, and localization of strain through both crack interaction and adiabatic heating.more » « less
-
Abstract This paper develops a Bayesian inference-based probabilistic crack nucleation model for the Ni-based superalloy René 88DT under fatigue loading. A data-driven, machine learning approach is developed, identifying underlying mechanisms driving crack nucleation. An experimental set of fatigue-loaded microstructures is characterized near crack nucleation sites using scanning electron microscopy and electron backscatter diffraction images for correlating the grain morphology and crystallography to the location of crack nucleation sites. A concurrent multiscale model, embedding experimental polycrystalline microstructural representative volume elements (RVEs) in a homogenized material, is developed for fatigue simulations. The RVE domain is modeled by a crystal plasticity finite element model. An anisotropic continuum plasticity model, obtained by homogenization of the crystal plasticity model, is used for the exterior domain. A Bayesian classification method is introduced to optimally select informative state variable predictors of crack nucleation. From this principal set of state variables, a simple scalar crack nucleation indicator is formulated.more » « less
-
Abstract Post‐traumatic osteoarthritis develops following an inciting injury to a joint and results in cartilage degeneration. Mechanical loading, including articulation, drives anabolic responses in cartilage clinically, in vivo, and in vitro. Tribological articulation, or sliding of cartilage on a glass counterface, has long been used as an in vitro tool to study cartilage tissue behavior. However, it is unclear if tribological articulation affects chondrocyte fate following injury, and if the timing of articulation impacts the resultant effect. The goal of this study was to investigate the effect of tribological articulation on injured cartilage tissue at two time points: (i) performed immediately after injury and (ii) 24 h after injury. Neonatal bovine femoral cartilage explants were injured using a rapid spring‐loaded impactor and subsequently subjected to tribological articulation. Cell death due to impact injury was highest near the articular surface, suggesting a strain‐dependent mechanism. Immediate articulation following injury mitigated cell death compared to injury alone or delayed articulation; markers for both general cell death and early‐stage apoptosis were markedly decreased in the explants that were immediately slid. Interestingly, mitigation of cell death due to sliding was most predominant at the cartilage surface. Tribological articulation is known to create fluid flow within the tissue, predominantly at the articular surface, which could drive the protective response seen here. Altogether, this work shows that perturbations to the cellular environment immediately following cartilage injury significantly impact chondrocyte fate.more » « less
