skip to main content

Explore Research Products in the NSF-PAR

Title: Data report: revised composite depth scale and splice for IODP Expedition 363 Site U1483
The shipboard sediment splice of International Ocean Discovery Program Expedition 363 Site U1483, drilled in 1733 m water depth on the Scott Plateau off Northwest Australia, was primarily based on a composite of the magnetic susceptibility records at 2.5 cm resolution from three holes drilled at this site. We performed X-ray fluorescence (XRF) core scanning at 2 cm intervals with overlaps of ~1–2 m at splice tie points and used these new data to verify the tie points along the original splice from 0 to 211.53 m core composite depth below seafloor (CCSF). Based on the XRF records, we revised the position of three original tie points and present a revised composite depth scale for Site U1483. These revisions resulted in shifts of up to 94 cm relative to the original shipboard offsets and a continuous section extending down to 211.62 m revised core composite depth below seafloor (r-CCSF).  more » « less
Award ID(s):
1326927
NSF-PAR ID:
10229183
Author(s) / Creator(s):
; ; ;
Date Published:
Journal Name:
Proceedings of the International Ocean Discovery Program
Volume:
363
ISSN:
2377-3189
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. ; ; ; ( , Proceedings of the International Ocean Discovery Program)
    null (Ed.)
    International Ocean Discovery Program (IODP) Expedition 363 recovered extended Neogene to Quaternary carbonate- and clay-rich sedimentary successions at Site U1482 (15°3.32ʹS, 120°26.10ʹE; 1466 m water depth), drilled at the southwestern edge of the Indo-Pacific Warm Pool off northwest Australia (Rosenthal et al., 2018b). Four holes were drilled with the advanced piston corer (APC) system at this site and deepened with the half-length APC (HLAPC) and extended core barrel (XCB) systems. A shipboard splice, from 0 to 451.26 m core composite depth below seafloor (CCSF), was established. After the expedition, the cores were scanned at high-resolution (1–2 cm) using an Avaatech X-ray fluorescence (XRF) core scanner. Scanning was performed along the shipboard splice with approximately 1 m overlap at the splice tie points for verification. Based on this new data set, we revised nine of the original splice tie points. The revised splice for Site U1482 now extends to 445.11 m revised CCSF and is available from the IODP Laboratory Information Management System (LIMS) database. 
    more » « less
  2. ; ; ; ( , Proceedings of the International Ocean Discovery Program)
    null (Ed.)
    Bulk sediment chemistry was measured at 2 cm resolution along cores from International Ocean Discovery Program (IODP) Site U1457 using the X-ray fluorescence (XRF) core scanner at the IODP Gulf Coast Repository. The Pleistocene splice section assembled from Holes U1457A and U1457B was scanned in its entirety, and nearly continuous sediment bulk chemistry profiles were constructed to a depth of 125 m core composite depth below seafloor (CCSF). Some sections of Hole U1457C were also scanned: (1) an upper Miocene hemipelagic section and (2) a 30 m lower Paleocene section directly overlying basalt. In the Pleistocene spliced sections, 2 cm spacing represents a sampling resolution of 150–300 y, whereas in the upper Miocene section this spacing represents about 500 y between samples. We report data and acquisition conditions for major and many minor elements. We find large variability in CaCO3 content in the Pleistocene section, from around 14 to 89 wt%. We used discrete shipboard CaCO3 measurements to calibrate the XRF Ca data. CaCO3 has cyclic variability and correlates with light sediment colors. Variation in aluminosilicate elements is largely caused by changes in dilution by CaCO3. The lower part of the spliced section, presumably representing distal Indus Fan deposits, has a distinctive but more uniform composition than the upper part. 
    more » « less
  3. ; ( , Proceedings of the International Ocean Discovery Program)
    null (Ed.)
    Sediment cores from adjacent holes at a drill site are typically spliced to make a continuous sediment record that spans sediment gaps that occur between sediment cores within each hole. The splice also provides a template for later sampling. During International Ocean Discovery Program Expedition 355, we made such a splice for both Sites U1456 and U1457 using shipboard Whole-Round Multisensor Logger and Section Half Multisensor Logger data. The shipboard-spliced sediment section at Site U1457 was constructed for the advanced piston corer interval to an age of about 1.5 Ma. Additional postexpedition planktonic foraminifer stable isotope data (Globigerinoides ruber δ18O) show that the shipboard stratigraphic tie between Cores 355-U1457B-1H and 355-U1457A-1H was wrong. This paper describes a revised splice that appends Core 355-U1457A-1H to the base of Core 355-U1457B-1H. The core composite depth below seafloor depths of the remaining splice have been revised because of this change. The revised splice interval is also longer by 1.2 m to accommodate the lower part of Core 355-U1457B-1H. In addition, a break of unknown thickness is present between Cores 355-U1457B-1H and 355-U1457A-1H. The revised splice interval table is included in this report. 
    more » « less
  4. ; ; ( , Proceedings of the International Ocean Discovery Program Expedition reports)
    To estimate the calcium carbonate (CaCO3) content in the Site U1543 sediment core samples retrieved during International Ocean Discovery Program (IODP) Expedition 383 at high downcore resolution, the X-ray fluorescence (XRF) scanning Ca data, at a spacing of every 10 mm downcore, were calibrated using a total of 118 coulometry-based discrete CaCO3 analyses from the upper 30 meters composite depth (mcd) along the splice. To remove the volume measurement problems of XRF and estimating CaCO3 contents quantitatively, first, raw XRF peak areas were scaled to reduce the effect resulting from the differences in efficiency at absorbing X-rays. Then, the scaled XRF scanning data were normalized to adjust the variability of the amount of XRF peak areas due to porosity and calibrated to properly estimate CaCO3 content. Based on the quality assessment, the calibrated XRF CaCO3 estimates are within ±4.50 wt% of the discrete measurements (1 standard deviation). This data report presents a discrete CaCO3 measurement data set, a normalized median-scaled XRF data set, and XRF CaCO3 estimates on the core depth below seafloor, Method A (CSF-A), and core composite depth below seafloor, Method A (CCSF-A), depth scales. 
    more » « less
  5. ; ; ; ; ; ; ; ; ( , Proceedings of the International Ocean Discovery Program)
    Contribution of melting Antarctic Ice Sheets (AIS) to rising sea level remains one of the least quantified inputs to predictive models for the future. To improve these estimates, International Ocean Discovery Program Expedition 374 cored five sites in the Ross Sea, Antarctica, to examine the stability of the AIS to past intervals of global warmth. Site U1523 proved difficult to core because of the presence of gravel lags and indurated intervals; thus, we cored three holes with overlapping stratigraphy at that site to recover a more complete stratigraphic section. Given these challenges, no attempt was made to create a composite depth scale or stratigraphic splice during the expedition. Here we use a combination of physical property data (primarily magnetic susceptibility and natural gamma radiation), X-ray fluorescence core scanning, and visual core description to construct a core composite depth below seafloor (CCSF) depth scale to the base of Hole U1523B. This composite depth scale is discontinuous because of challenging coring conditions and variable core recovery, although there are several intervals of reasonably good stratigraphic continuity between 0 and 26 m CCSF and 82 and 96 m CCSF. We also created a stratigraphic splice from 0 to 93.95 m CCSF, although the splice is only continuous to 15.82 m CCSF. Additionally, we mapped the off-splice interval of Core 374-U1523E-1H to the composite depth scale over several intervals with significant core disturbance by stretching and squeezing to obtain a best fit. Development of the composite depth scale and stratigraphic splice will improve postcruise research results by allowing scientists to compare samples from different holes on the same depth scale. 
    more » « less
  • Citation Formats
  • MLA
  • APA
  • Chicago
  • BibTeX
  • Save / Share this Record
  • Send to Email