skip to main content
US FlagAn official website of the United States government
dot gov icon
Official websites use .gov
A .gov website belongs to an official government organization in the United States.
https lock icon
Secure .gov websites use HTTPS
A lock ( lock ) or https:// means you've safely connected to the .gov website. Share sensitive information only on official, secure websites.

Explore Research Products in the PAR
It may take a few hours for recently added research products to appear in PAR search results.


Title: High-pressure elastic properties of dolomite melt supporting carbonate-induced melting in deep upper mantle
Deeply subducted carbonates likely cause low-degree melting of the upper mantle and thus play an important role in the deep carbon cycle. However, direct seismic detection of carbonate-induced partial melts in the Earth’s interior is hindered by our poor knowledge on the elastic properties of carbonate melts. Here we report the first experimentally determined sound velocity and density data on dolomite melt up to 5.9 GPa and 2046 K by in-situ ultrasonic and sink-float techniques, respectively, as well as first-principles molecular dynamics simulations of dolomite melt up to 16 GPa and 3000 K. Using our new elasticity data, the calculated V P /V S ratio of the deep upper mantle (∼180–330 km) with a small amount of carbonate-rich melt provides a natural explanation for the elevated V P /V S ratio of the upper mantle from global seismic observations, supporting the pervasive presence of a low-degree carbonate-rich partial melt (∼0.05%) that is consistent with the volatile-induced or redox-regulated initial melting in the upper mantle as argued by petrologic studies. This carbonate-rich partial melt region implies a global average carbon (C) concentration of 80–140 ppm. by weight in the deep upper mantle source region, consistent with the mantle carbon content determined from geochemical studies.  more » « less
Award ID(s):
1753125
PAR ID:
10316158
Author(s) / Creator(s):
; ; ; ; ; ;
Date Published:
Journal Name:
Proceedings of the National Academy of Sciences
Volume:
117
Issue:
31
ISSN:
0027-8424
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. ; (, Journal of Geophysical Research: Solid Earth)
    Abstract A comprehensive analysis of experimental data and theoretical simulations on the partial molar volume of water in silicate melt indicates that finite strain theory successfully describes the compression of the H2O component dissolved in silicate melt at high pressures and temperatures. However, because of the high compressibility of the water component, a fourth order equation of state fit is required to accurately simulate experimental results on water's volume in silicate melts at a deep upper mantle, transition zone, and lower mantle pressures. Data from previous shock compression experiments on hydrous minerals in which melting occurs along the Hugoniot are used to provide an experimental constraint on the partial molar volume of water in silicate melt at deep mantle temperatures and pressures. The equation of state of the water component indicates that, depending on elastic averaging technique, the amount of water that could be present in neutrally or negatively buoyant mafic/ultramafic melts above the 410 km seismic discontinuity is upper‐bounded at 5.6 wt%: smaller than previously inferred, and consistent with melt being confined to a narrow depth range above the 410 km discontinuity. If melt is predominantly distributed along grain boundaries in low aspect ratio films, extents of melting as low as 2% could produce observed seismic velocity reductions. The ability of the lowermost mantle to contain negatively buoyant hydrous liquids hinges on the trade‐off between iron content and hydration: at these depths, substantially higher degrees of hydration could be present within partial melts. 
    more » « less
  2. ; (, Journal of Petrology)
    Abstract Many lines of evidence from high P–T experiments, thermodynamic models, and natural observations suggest that slab-derived aqueous fluids, which flux mantle wedges contain variable amounts of dissolved carbon. However, constraints on the effects of H2O–CO2 fluids on mantle melting, particularly at mantle wedge P–T conditions, are limited. Here, we present new piston cylinder experiments on fertile and depleted peridotite compositions with 3.5 wt.% H2O and XCO2 [= molar CO2 / (CO2 + H2O)] of 0.04–0.17. Experiments were performed at 2–3 GPa and 1350°C to assess how temperature, peridotite fertility, and XCO2 of slab-derived fluid affects partial melting in mantle wedges. All experiments produce olivine + orthopyroxene +7 to 41 wt.% partial melt. Our new data, along with previous lower temperature data, show that as mantle wedge temperature increases, primary melts become richer in SiO2, FeO*, and MgO and poorer CaO, Al2O3, and alkalis when influenced by H2O–CO2 fluids. At constant P–T and bulk H2O content, the extent of melting in the mantle wedge is largely controlled by peridotite fertility and XCO2 of slab-fluid. High XCO2 depleted compositions generate ~7 wt.% melt, whereas, at identical P–T, low XCO2 fertile compositions generate ~30 to 40 wt.% melt. Additionally, peridotite fertility and XCO2 have significant effects on peridotite partial melt compositions. At a constant P–T–XCO2, fertile peridotites generate melts richer in CaO and Al2O3 and poorer in SiO2, MgO + FeO, and alkalis. Similar to previous experimental studies, at a constant P–T fertility condition, as XCO2 increases, SiO2 and CaO of melts systematically decrease and increase, respectively. Such distinctive effects of oxidized form of dissolved carbon on peridotite partial melt compositions are not observed if the carbon-bearing fluid is reduced, such as CH4-bearing. Considering the large effect of XCO2 on melt SiO2 and CaO concentrations and the relatively oxidized nature of arc magmas, we compare the SiO2/CaO of our experimental melts and melts from previous peridotite + H2O ± CO2 studies to the SiO2/CaO systematics of primitive arc basalts and ultra-calcic, silica-undersaturated arc melt inclusions. From this comparison, we demonstrate that across most P–T–fertility conditions predicted for mantle wedges, partial melts from bulk compositions with XCO2 ≥ 0.11 have lower SiO2/CaO than all primitive arc melts found globally, even when correcting for olivine fractionation, whereas partial melts from bulk compositions with XCO2 = 0.04 overlap the lower end of the SiO2/CaO field defined by natural data. These results suggest that the upper XCO2 limit of slab-fluids influencing primary arc magma formation is 0.04 < XCO2 < 0.11, and this upper limit is likely to apply globally. Lastly, we show that the anomalous SiO2/CaO and CaO/Al2O3 signatures observed in ultra-calcic arc melt inclusions can be reproduced by partial melting of either CO2-bearing hydrous fertile and depleted peridotites with 0 < XCO2 < 0.11 at 2–3 GPa, or from nominally CO2-free hydrous fertile peridotites at P > 3 GPa. 
    more » « less
  3. ; ; (, Journal of Geophysical Research: Solid Earth)
    Abstract High pressure and temperature experiments were carried out on the oxide mixtures corresponding to the bridgmanite stoichiometry under the hydrous shallow lower mantle conditions (24–25 GPa and 1673–1873 K with 5–10 wt. % of water in the starting material). Oxide mixtures investigated correspond to MgSiO3, (Mg, Fe)SiO3, (Mg, Al, Si)O3, and (Mg, Fe, Al, Si)O3. Melting was observed in all runs. Partitioning of various elements, including Mg, Fe, Si, and H is investigated. Melting under hydrous lower mantle conditions leads to increased (Mg + Fe)O/SiO2in the melt compared to the residual solids. The residual solids often contain a large amount of stishovite, and the melt contains higher (Mg,Fe)O/SiO2ratio than the initial material. (Mg + Fe)O‐rich hydrous melt could explain the low‐velocity anomalies observed in the shallow lower mantle and a large amount of stishovite in the residual solid may be responsible for the scattering of seismic waves in the mid‐lower mantle and may explain the “stishovite paradox. Since stishovite‐rich materials are formed only when silica‐rich source rock (MORB) is melted (not a typical peridotitic rock [bulk silicate Earth]), seismic scattering in the lower mantle provides a clue on the circulation of subducted MORB materials. To estimate hydrogen content, we use a new method of estimating the water content of unquenchable melts, and also propose a new interpretation of the significance of superhydrous phase B inclusions in bridgmanite. The results provide revised values of water partitioning between solid minerals and hydrous melts that are substantially higher than previous estimates. 
    more » « less
  4. ; ; ; ; ; (, Geophysical Research Letters)
    Abstract One of the central challenges in accurately estimating the mantle melting temperature is the sensitivity of the probe for detecting a small amount of melt at the solidus. To address this, we used a multichannel collimator to enhance the diffuse X‐ray scattering from a small amount of melt and probed an eutectic pyrolitic composition to increase the amount of melt at the solidus. Our in situ detection of diffuse scattering from the pyrolitic melt determined an anhydrous melting temperature of 3,302 ± 100 K at 119 ± 6 GPa and 3,430 ± 130 K at the core‐mantle boundary (CMB) conditions, as the upper bound temperature. Our CMB temperature is approximately 700 K lower than the previous estimates, implying much faster secular cooling and higher concentrations of S, C, O, and/or H in the region, and nonlinear, advocating the basal magma ocean hypothesis. 
    more » « less
  5. ; ; ; ; ; ; ; ; ; (, Journal of Petrology)
    Abstract Spongy clinopyroxene is common in most mantle-derived xenoliths and megacrysts of eclogitic and peridotitic parageneses. Its formation is commonly attributed to the partial melting of a primary clinopyroxene in response to various factors, including changes in pressure and temperature or infiltration of external melts or fluids. In order to study the mechanism of spongy clinopyroxene formation in detail, we selected six eclogitic clinopyroxene inclusions in diamonds with varying amounts of spongy clinopyroxene (from ~10 to 100%). We employed computed tomography, electron microprobe analysis, and Raman spectroscopy to study the textural characteristics, major element concentrations, and the types of volatiles present in both phases. We also used pMELTS to model the compositions of spongy clinopyroxene and associated melts produced by the melting of primary clinopyroxene over a range of pressures and temperatures. We compare these results with estimates from major element thermobarometry of the spongy clinopyroxene. We conclude that the studied spongy clinopyroxene is the solid product of partial melting that occurs upon decompression of the primary clinopyroxene within the diamond in a near-closed system. Melting of the primary clinopyroxene occurred continuously or in pulses at different depths during the diamond’s ascent to Earth’s surface and produced variable spongy clinopyroxene and melt compositions even within the same inclusion. This is possible due to relatively rapid kimberlite ascent. The degrees of melting are various and unexpectedly high for mantle melting (between <10 and 60% with an average of ~20–30%). The produced melts are highly silicic, phonolitic, and alkali-rich. pMELTS modelling shows the spongy clinopyroxene compositions can be reproduced at pressures between 0.5–2.7 GPa and temperatures of 850–1300°C, with the majority of them satisfying the P–T conditions of 1–2 GPa and 1100–1300°C. This indicates decompression melting of primary clinopyroxene at shallow upper mantle or lower crustal conditions. 
    more » « less
  • Citation Formats
  • MLA
  • APA
  • Chicago
  • BibTeX
  • Save / Share this Record
  • Send to Email