skip to main content


Title: Effect of Au substrate and coating on the lasing characteristics of GaAs nanowires
Abstract Optically pumped lasing from highly Zn-doped GaAs nanowires lying on an Au film substrate and from Au-coated nanowires has been demonstrated up to room temperature. The conically shaped GaAs nanowires were first coated with a 5 nm thick Al 2 O 3 shell to suppress atmospheric oxidation and band-bending effects. Doping with a high Zn concentration increases both the radiative efficiency and the material gain and leads to lasing up to room temperature. A detailed analysis of the observed lasing behavior, using finite-difference time domain simulations, reveals that the lasing occurs from low loss hybrid modes with predominately photonic character combined with electric field enhancement effects. Achieving low loss lasing from NWs on an Au film and from Au coated nanowires opens new prospects for on-chip integration of nanolasers with new functionalities including electro-optical modulation, conductive shielding, and polarization control.  more » « less
Award ID(s):
2004768
NSF-PAR ID:
10323637
Author(s) / Creator(s):
; ; ; ; ; ; ; ;
Date Published:
Journal Name:
Scientific Reports
Volume:
11
Issue:
1
ISSN:
2045-2322
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. Abstract

    In this work, we demonstrate optically pumped lasing in highly Zn-doped GaAs nanowires (NWs) lying on an iron film. The conically shaped NWs are first covered with an 8 nm thick Al2O3film to prevent atmospheric oxidation and mitigate band-bending effects. Multimode and single-mode lasing have been observed for NWs with a length greater or smaller than 2μm, respectively. Finite difference time domain calculations reveal a weak electric field enhancement in the Al2O3layer at the NW/iron film interface for the lasing modes. The high Zn acceptor concentration in the NWs provides enhanced radiative efficiency and enables lasing on the iron film despite plasmonic losses. Our results open avenues for integrating NW lasers on ferromagnetic substrates to achieve new functionalities, such as magnetic field-induced modulation.

     
    more » « less
  2. Abstract

    A simple room‐temperature process of depositing MXene on a III‐V structure with embedded 2D electron gas (2DEG) is used, which results in a large area, , photodetector (PD) device that greatly outperforms vacuum deposited Ti/Au metal‐semiconductor‐metal (MSM) PD's. By co‐optimizing properties of 2D MXene contacts and the III‐V material heterojunctions, this device sets new operating records with responsivity up to 1.04 A W1at low optical powers, corresponding to >230% internal quantum efficiency, dark current of 50 , >105.6‐dB dynamic range, and 25–150 ps response time, which improves the previous MXene‐Semiconductor‐MXene responsivity by >2.7 times and is 7 × 103–−106times faster compared to other MXene‐based PDs. This is achieved by enhancing the Schottky barrier height by forming a Van der Waals (vdW) heterojunction between a wide bandgap AlGaAs surface layer and spin coatedTi3C2Tzelectrodes. A layered architecture transports the optically generated electrons to a 2DEG channel at the GaAs/AlGaAs heterointerface, where they are rapidly collected. The landscaped electric field pushes the slow holes to an underlying low temperature‐grown GaAs (LT‐GaAs) region where they recombine. The proposed Schottky‐2DEG Photoconductor‐Schottky model for device operation shows how this device circumvents the canonical limitations of gain‐bandwidth product, and carrier transit time, while replacing the need for vacuum deposition of gold or other precious metals.

     
    more » « less
  3. Abstract

    2D photonic crystal (PhC) lasing from an InP nanowire array still attached to the InP substrate is demonstrated for the first time. The undoped wurtzite InP nanowire array is grown by selective area epitaxy and coated with a 10 nm thick Al2O3film to suppress atmospheric oxidation and band‐bending effects. The PhC array displays optically pumped lasing at room temperature at a pulsed threshold fluence of 14 µJ cm−2. At liquid nitrogen temperature, the array shows lasing under continuous wave excitation at a threshold intensity of 500 W cm−2. The output power of the single mode laser line reaches values of 470 µW. Rate equation calculations indicate a quality factor ofQ ≈ 1000. Investigations near threshold reveal that lasing starts from isolated islands within the pumped region before coherently merging into a single homogeneous area with increasing excitation power. This field emits a lasing mode with an average off‐normal angle of ≈6°. Single mode lasing with the nanoarray still attached to the InP substrate opens new design opportunities for electrically pumped PhC laser light sources.

     
    more » « less
  4. Abstract

    GaAs‐AlGaAs based nanowire (NW) lasers hold great potential for on‐chip photonic applications, where lasing metrics have steadily improved over the years by optimizing resonator design and surface passivation methods. The factor that will ultimately limit the performance will depend on material properties, such as native‐ or impurity‐induced point defects and their impact on non‐radiative recombination. Here, the role of impurity‐induced point defects on the lasing performance of low‐threshold GaAs(Sb)‐AlGaAs NW‐lasers is evaluated, particularly by exploring Si‐dopants and their associated vacancy complexes. Si‐induced point defects and their self‐compensating nature are identified using correlated atom probe tomography, resonant Raman scattering, and photoluminescence experiments. Under pulsed optical excitation the lasing threshold is remarkably low (<10 µJ cm−2) and insensitive to impurity defects over a wide range of Si doping densities, while excess doping ([Si]>1019 cm−3) imposes increased threshold at low temperature. These characteristics coincide with increased Shockley‐Read‐Hall recombination, reflected by shorter carrier lifetimes, and reduced internal quantum efficiencies (IQE) . Remarkably, despite the lower IQE the presence of self‐compensating Si‐vacancy defects provides an improved temperature stability in lasing threshold with higher characteristic temperature and room‐temperature lasing. These findings highlight an overall large tolerance of lasing metrics to impurity defects in GaAs‐AlGaAs based NW‐lasers.

     
    more » « less
  5. Metallic nanostructures can be used to selectively absorb a specific regime of the infrared (IR) spectrum depending on its constituent materials and geometry. In this paper, we propose and analyze a plasmo-thermomechanical detector that includes a graphene layer on top of metallic nanowires to enhance the absorption and sensitivity. The proposed device converts the free-space IR radiation to mechanical deformation of nanowires that modulates the insertion loss of the waveguide underneath the nanowires and facilitates the on-chip optical readout of the free-space radiation at room temperature. Our design takes advantage of localized surface plasmon resonances to maximize absorption at the desired IR spectrum. We provide a systematic investigation of different material combinations with and without graphene in addition to variations in detector geometry to optimize the designed IR detector. On top of the absorption enhancement, the graphene layer over the nanowires boosts thermal relaxation speed of the nanowires by 3 times due to graphene’s high thermal conductivity, in turn speeding up the response of the IR detection. Moreover, the coated graphene layer enhances the mechanical deformation by a factor of 6 and bends the suspended nanowires downward, enhancing the light–matter interaction between the nanowires and the waveguide evanescent field. Overall, incorporating graphene is beneficial for enhanced spectrum absorption, speed of the IR detection, and optical readout sensitivity.

     
    more » « less