An official website of the United States government
Abstract Climatic warming and permafrost thaw are predicted to increase Arctic riverbank erosion, threatening communities and accelerating sediment, carbon and nutrient cycling between rivers and floodplains. Existing theory assumes that pore‐ice thaw sets riverbank erosion rates, but overpredicts observed erosion rates by orders of magnitude. Here, we developed a simple model that predicts more modest rates due to a sediment‐entrainment limitation and riverbank armoring by slump blocks. Results show that during times of thaw‐limited erosion, the river rapidly erodes permafrost and undercuts its banks, consistent with previous work. However, overhanging banks generate slump blocks that must thaw and erode by sediment entrainment. Sediment entrainment can limit bank and slump block erosion rates, producing seasonally averaged rates more consistent with observations. Importantly, entrainment‐limited riverbank erosion does not depend on water temperature, indicating that decadal erosion rates may be less sensitive to warming than predicted previously.
more »
« less
Geologic Controls on Erosion Mechanism on the Alaska Beaufort Coast
Two prominent arctic coastal erosion mechanisms affect the coastal bluffs along the North Slope of Alaska. These include the niche erosion/block collapse mechanism and the bluff face thaw/slump mechanism. The niche erosion/block collapse erosion mechanism is dominant where there are few coarse sediments in the coastal bluffs, the elevation of the beach below the bluff is low, and there is frequent contact between the sea and the base of the bluff. In contrast, the bluff face thaw/slump mechanism is dominant where significant amounts of coarse sediment are present, the elevation of the beach is high, and contact between the sea and the bluff is infrequent. We show that a single geologic parameter, coarse sediment areal density, is predictive of the dominant erosion mechanism and is somewhat predictive of coastal erosion rates. The coarse sediment areal density is the dry mass (g) of coarse sediment (sand and gravel) per horizontal area (cm 2 ) in the coastal bluff. It accounts for bluff height and the density of coarse material in the bluff. When the areal density exceeds 120 g cm −2 , the bluff face thaw/slump mechanism is dominant. When the areal density is below 80 g cm −2 , niche erosion/block collapse is dominant. Coarse sediment areal density also controls the coastal erosion rate to some extent. For the sites studied and using erosion rates for the 1980–2000 period, when the sediment areal density exceeds 120 g cm −2 , the average erosion rate is low or 0.34 ± 0.92 m/yr. For sediment areal density values less than 80 g cm −2 , the average erosion rate is higher or 2.1 ± 1.5 m/yr.
more »
« less
- Award ID(s):
- 1745508
- PAR ID:
- 10325991
- Date Published:
- Journal Name:
- Frontiers in Earth Science
- Volume:
- 9
- ISSN:
- 2296-6463
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
The Arctic is experiencing accelerated warming at up to four times the rate of temperate regions, driving permafrost thawing and ground ice melting, which, in turn lead to coastal bluff failure and accelerated erosion. The primary mechanisms behind Arctic coastal bluff failures include the formation of thermoerosional niches at the bluff’s toe and warming-induced reductions in ground strength, making Arctic coastal bluff failure a complex thermal-mechanical coupling process. Most existing studies have focused on coastal bluff failures in temperate regions, but the unique failure mechanism in the Arctic remain underexplored. This study addresses this gap by developing a thermalmechanical coupling model to study the failure mechanism of a permafrost bluff failure that occurred in 2023–2024 in Utqia˙gvik, Alaska. The model incorporates pore ice phase change, thaw-induced reductions in permafrost stiffness and strength, and the effects of thermoerosional niches, cracks, and ice wedges. Stability analysis is conducted via the local factor of safety (LFS) method to account for spatial variations in permafrost strength and stiffness. Ground-penetrating radar (GPR) data from the August 2024 site survey were employed to characterize site conditions, and ground temperature data were used to validate the model. The results revealed two primary failure zones: one near the ground surface and another at the bluff’s toe. The total area of these two failure zones expanded with ongoing thaw. Besides, the results indicated that the increase in thaw thickness, the growth in niche length, and the presence of cracks exacerbate bluff instability, and bluff failure is likely to initiate along the ice wedge–permafrost interface.more » « less
-
Coastal bluff erosion and recession are among the common mechanisms altering the geomorphology of the coastline in California. The accelerated erosion rate increasingly threatens the stability of structures located on these bluffs. Previous researchers have investigated the effect of material properties and strength on the generation of the shear plane and failure modes of coastal bluffs and cliffs. Monitoring the morphology of the moderately cemented coastal bluffs with time has indicated that a comparison of material strength with the expected insitu minor principal stress distribution can be used as a criterion to assess bluff stability. However, the effect of varying factors such as cementation levels and bluff geometry and dimensions on stress distribution patterns and material properties that determine bluff failure susceptibility requires further investigation. While bond breakage and disturbance during sampling and transportation undermine the quality of recovered soil samples, artificial cementation methods (e.g., Portland cement) may not properly replicate the natural formation processes. Instead, microbially induced carbonate precipitation (MICP) is a ground improvement method that simulates the cementation processes that occur in natural geological settings. This method harnesses the activities of bacteria to generate cementitious precipitation among soil particles. The formation of the cementing agent improves the mechanical properties of the soil. In the past two decades, extensive studies have been devoted to understanding the cementation formation mechanism and the improvement of mechanical properties that can be used as a proxy for natural cemented soil for stability analysis. In the study presented herein, a series of FEM models were developed in SIGMA/W software. The effect of the different cementation levels and variation of bluff geometry on minor principal stress distribution was investigated. Results of the study demonstrated that although the cementation level of the materials determines the failure mode, the stress distribution mainly depends on the bluff geometry. The obtained results offer further insights into the failure mechanism of coastal bluffs as well as MICP-treated slopes for future field implementation of this soil improvement method.more » « less
-
null (Ed.)Observational data of coastal change over much of the Arctic are limited largely due to its immensity, remoteness, harsh environment, and restricted periods of sunlight and ice-free conditions. Barter Island, Alaska, is one of the few locations where an extensive, observational dataset exists, which enables a detailed assessment of the trends and patterns of coastal change over decadal to annual time scales. Coastal bluff and shoreline positions were delineated from maps, aerial photographs, and satellite imagery acquired between 1947 and 2020, and at a nearly annual rate since 2004. Rates and patterns of shoreline and bluff change varied widely over the observational period. Shorelines showed a consistent trend of southerly erosion and westerly extension of the western termini of Barter Island and Bernard Spit, which has accelerated since at least 2000. The 3.2 km long stretch of ocean-exposed coastal permafrost bluffs retreated on average 114 m and at a maximum of 163 m at an average long-term rate (70 year) of 1.6 ± 0.1 m/yr. The long-term retreat rate was punctuated by individual years with retreat rates up to four times higher (6.6 ± 1.9 m/yr; 2012–2013) and both long-term (multidecadal) and short-term (annual to semiannual) rates showed a steady increase in retreat rates through time, with consistently high rates since 2015. A best-fit polynomial trend indicated acceleration in retreat rates that was independent of the large spatial and temporal variations observed on an annual basis. Rates and patterns of bluff retreat were correlated to incident wave energy and air and water temperatures. Wave energy was found to be the dominant driver of bluff retreat, followed by sea surface temperatures and warming air temperatures that are considered proxies for evaluating thermo-erosion and denudation. Normalized anomalies of cumulative wave energy, duration of open water, and air and sea temperature showed at least three distinct phases since 1979: a negative phase prior to 1987, a mixed phase between 1987 and the early to late 2000s, followed by a positive phase extending to 2020. The duration of the open-water season has tripled since 1979, increasing from approximately 40 to 140 days. Acceleration in retreat rates at Barter Island may be related to increases in both thermodenudation, associated with increasing air temperature, and the number of niche-forming and block-collapsing episodes associated with higher air and water temperature, more frequent storms, and longer ice-free conditions in the Beaufort Sea.more » « less
-
null (Ed.)Wave forcing from hurricanes, nor’easters, and energetic storms can cause erosion of the berm and beach face resulting in increased vulnerability of dunes and coastal infrastructure. LIDAR or other surveying techniques have quantified post-event morphology, but there is a lack of in situ hydrodynamic and morphodynamic measurements during extreme storm events. Two field studies were conducted in March 2018 and April 2019 at Bethany Beach, Delaware, where in situ hydrodynamic and morphodynamic measurements were made during a nor’easter (Nor’easter Riley) and an energetic storm (Easter Eve Storm). An array of sensors to measure water velocity, water depth, water elevation and bed elevation were mounted to scaffold pipes and deployed in a single cross-shore transect. Water velocity was measured using an electro-magnetic current meter while water and bed elevations were measured using an acoustic distance meter along with an algorithm to differentiate between the water and bed during swash processes. GPS profiles of the beach face were measured during every day-time low tide throughout the storm events. Both accretion and erosion were measured at different cross-shore positions and at different times during the storm events. Morphodynamic change along the back-beach was found to be related to berm erosion, suggesting an important morphologic feedback mechanism. Accumulated wave energy and wave energy flux per unit area between Nor’easter Riley and a recent mid-Atlantic hurricane (Hurricane Dorian) were calculated and compared. Coastal Observations: JALBTCX/NCMP emergency-response airborne Lidar coastal mapping & quick response data products for 2016/2017/2018 hurricane impact assessmentsmore » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.3389/feart.2021.693824
