The goal of classifying shock metamorphic features in meteorites is to estimate the corresponding shock pressure conditions. However, the temperature variability of shock metamorphism is equally important and can result in a diverse and heterogeneous set of shock features in samples with a common overall shock pressure. In particular, high-pressure (HP) minerals, which were previously used as a solid indicator of high shock pressure in meteorites, require complex pressure–temperature–time (
- NSF-PAR ID:
- 10329117
- Date Published:
- Journal Name:
- Minerals
- Volume:
- 11
- Issue:
- 4
- ISSN:
- 2075-163X
- Page Range / eLocation ID:
- 424
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract P–T–t ) histories to form and survive. First, parts of the sample must be heated to melting temperatures, at high pressure, to enable rapid formation of HP minerals before pressure release. Second, the HP minerals must be rapidly cooled to below a critical temperature, before the pressure returns to ambient conditions, to avoid retrograde transformation to their low-pressure polymorphs. These two constraints require the sample to contain large temperature heterogeneities, e.g. melt veins in a cooler groundmass, during shock. In this study, we calculated shock temperatures and possibleP–T paths of chondritic and differentiated mafic–ultramafic rocks for various shock pressures. TheseP–T conditions and paths, combined with observations from shocked meteorites, are used to constrain shock conditions andP–T –t histories of HP-mineral bearing samples. The need for rapid thermal quench of HP phases requires a relatively low bulk-shock temperature and therefore moderate shock pressures below ~ 30 GPa, which matches the stabilities of these HP minerals. The low-temperature moderate-pressure host rock generally shows moderate shock-deformation features consistent with S4 and, less commonly, S5 shock stages. Shock pressures in excess of 50 GPa in meteorites result in melt breccias with high overall post-shock temperatures that anneal out HP-mineral signatures. The presence of ringwoodite, which is commonly considered an indicator of the S6 shock stage, is inconsistent with pressures in excess of 30 GPa and does not represent shock conditions different from S4 shock conditions. Indeed, ringwoodite and coexisting HP minerals should be considered as robust evidence for moderate shock pressures (S4) rather than extreme shock (S6) near whole-rock melting. -
more » « less
Abstract Ultramylonites—intensely deformed rocks with fine grain sizes and well‐mixed mineral phases—are thought to be a key component of Earth‐like plate tectonics, because coupled phase mixing and grain boundary pinning enable rocks to deform by grain‐size‐sensitive, self‐softening creep mechanisms over long geologic timescales. In isoviscous two‐phase composites, “geometric” phase mixing occurs via the sequential formation, attenuation (stretching), and disaggregation of compositional layering. However, the effects of viscosity contrast on the mechanisms and timescales for geometric mixing are poorly understood. Here, we describe a series of high‐strain torsion experiments on nonisoviscous calcite‐fluorite composites (viscosity contrast,
η ca /η fl γ ≤ 10), polycrystalline domains of the individual phases become sheared and form compositional layering. As layering develops, strain localizes into the weaker phase, fluorite. Strain partitioning impedes mixing by reducing the rate at which the stronger (calcite) layers deform, attenuate, and disaggregate. Even at very large shear strains (γ ≥ 50), grain‐scale mixing is limited, and thick compositional layers are preserved. Our experiments (1) demonstrate that viscosity contrasts impede mechanical phase mixing and (2) highlight the relative inefficiency of mechanical mixing. Nevertheless, by employing laboratory flow laws, we show that “ideal” conditions for mechanical phase mixing may be found in the wet middle to lower continental crust and in the dry mantle lithosphere, where quartz‐feldspar and olivine‐pyroxene viscosity contrasts are minimized, respectively. -
more » « less
Abstract The response of forsterite, Mg2SiO4, under dynamic compression is of fundamental importance for understanding its phase transformations and high‐pressure behavior. Here, we have carried out an in situ X‐ray diffraction study of laser‐shocked polycrystalline and single‐crystal forsterite (
a ‐,b ‐, andc ‐orientations) from 19 to 122 GPa using the Matter in Extreme Conditions end‐station of the Linac Coherent Light Source. Under laser‐based shock loading, forsterite does not transform to the high‐pressure equilibrium assemblage of MgSiO3bridgmanite and MgO periclase, as has been suggested previously. Instead, we observe forsterite and forsterite III, a metastable polymorph of Mg2SiO4, coexisting in a mixed‐phase region from 33 to 75 GPa for both polycrystalline and single‐crystal samples. Densities inferred from X‐ray diffraction data are consistent with earlier gas‐gun shock data. At higher stress, the response is sample‐dependent. Polycrystalline samples undergo amorphization above 79 GPa. For [010]‐ and [001]‐oriented crystals, a mixture of crystalline and amorphous material is observed to 108 GPa, whereas the [100]‐oriented forsterite adopts an unknown phase at 122 GPa. The first two sharp diffraction peaks of amorphous Mg2SiO4show a similar trend with compression as those observed for MgSiO3in both recent static‐ and laser‐driven shock experiments. Upon release to ambient pressure, all samples retain or revert to forsterite with evidence for amorphous material also present in some cases. This study demonstrates the utility of femtosecond free‐electron laser X‐ray sources for probing the temporal evolution of high‐pressure silicate structures through the nanosecond‐scale events of shock compression and release. -
Abstract. Volatility and viscosity are important properties of organic aerosols (OA),affecting aerosol processes such as formation, evolution, and partitioning ofOA. Volatility distributions of ambient OA particles have often beenmeasured, while viscosity measurements are scarce. We have previouslydeveloped a method to estimate the glass transition temperature (Tg) ofan organic compound containing carbon, hydrogen, and oxygen. Based onanalysis of over 2400 organic compounds including oxygenated organiccompounds, as well as nitrogen- and sulfur-containing organic compounds, weextend this method to include nitrogen- and sulfur-containing compoundsbased on elemental composition. In addition, parameterizations are developedto predict Tg as a function of volatility and the atomicoxygen-to-carbon ratio based on a negative correlation between Tg andvolatility. This prediction method of Tg is applied to ambientobservations of volatility distributions at 11 field sites. Thepredicted Tg values of OA under dry conditions vary mainly from 290 to 339 Kand the predicted viscosities are consistent with the results of ambientparticle-phase-state measurements in the southeastern US and the Amazonianrain forest. Reducing the uncertainties in measured volatility distributionswould improve predictions of viscosity, especially at low relative humidity.We also predict the Tg of OA components identified via positive matrixfactorization of aerosol mass spectrometer (AMS) data. The predicted viscosity ofoxidized OA is consistent with previously reported viscosity of secondary organic aerosols (SOA) derivedfrom α-pinene, toluene, isoprene epoxydiol (IEPOX), and diesel fuel.Comparison of the predicted viscosity based on the observed volatilitydistributions with the viscosity simulated by a chemical transport modelimplies that missing low volatility compounds in a global model can lead tounderestimation of OA viscosity at some sites. The relation betweenvolatility and viscosity can be applied in the molecular corridor orvolatility basis set approaches to improve OA simulations in chemicaltransport models by consideration of effects of particle viscosity in OAformation and evolution.more » « less
-
We have studied magnetic ordering in polycrystalline erbium at high pressures up to 32 GPa and low temperatures down to 10 K using neutron diffraction techniques at the Spallation Neutron Source at Oak Ridge National Laboratory, USA. For the hexagonal close-packed (hcp) phase, strong nuclear and magnetic satellite intensities permit a simultaneous refinement of the nuclear and magnetic structures. At 1 GPa of applied pressure, a modulation vector q=γc^* with γ≈2/7 for the c-axis modulated and cycloidal phases is consistent with prior single-crystal studies at low pressures. At 6.7 GPa in the hcp phase, we find γ≈0.31, indicating a reduction in the period of the magnetic structure with respect to the crystal lattice. The magnetic ordering temperature at 6.7 GPa is slightly above 60 K. At 32 GPa in the double hexagonal close-packed phase, the magnetic scattering constrains the magnetic ordering temperature to 25±5 K. Our neutron diffraction study demonstrates that the magnetic ordering persists in the high-pressure double hexagonal close-packed phase of erbium to the highest pressure of 32 GPa.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.3390/min11040424
