An official website of the United States government
Bubble nucleation was investigated in a 20-mm-long, wickless heat pipe on the International Space Station. Over 20 h of running experiments using pentane as the working fluid, more than 100 nucleation events were observed. Bubble nucleation at the heater end temporarily boosted peak pressures and vapor temperatures in the device. At the moment of nucleation, the heater wall temperature significantly decreased due to increased evaporation and the original vapor bubble collapsed due to increased pressure. A thermal model was developed and using the measured temperatures and pressures, heat transfer coefficients near the heater end of the system were extracted. Peak heat transfer coefficients during the nucleation event were over a factor of three higher than at steady-state. The heat transfer coefficient data were all collapsed in the form of a single, linear correlation relating the Nusselt number to the Ohnesorge number.
more »
« less
The effect of condenser temperature on the performance of the evaporator in a wickless heat pipe performance
The Constrained Vapor Bubble (CVB), a simple, wickless, heat pipe design that depends on interfacial forces to drive corner flow in a square cuvette, was studied in the microgravity environment aboard the International Space Station (ISS). In this paper, we consider the effects of different condenser temperatures on the heat transfer and fluid flow behavior using pentane as the working fluid. As the condenser temperature was decreased, the performance of the system decreased. This performance decrease using the pure working fluid was opposite to the behavior observed when using a mixture of 94 vol% pentane and 6 vol% isohexane. The mechanism for the decline in performance as the condenser temperature was lowered was a stronger than expected increase in the apparent strength of Marangoni flows at the heater end of the system. A simple mathematical model was fit to the experimental data and used to extract an evaporator heat transfer coefficient for experiments where we held the condenser temperature constant while increasing the heater power and where we held the heater power constant while decreasing the condenser temperature. All the results could be collapsed onto a single Nusselt number vs. Marangoni number curve. In this formulation, the Nusselt number was found to decrease with increasing Marangoni number to the 1/3 power.
more »
« less
- Award ID(s):
- 1637816
- PAR ID:
- 10337411
- Date Published:
- Journal Name:
- International Journal of Heat and Mass Transfer
- Volume:
- 176
- ISSN:
- 0017-9310
- Page Range / eLocation ID:
- 121484
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
null (Ed.)This study explores thermal convection in suspensions of neutrally buoyant, non-colloidal suspensions confined between horizontal plates. A constitutive diffusion equation is used to model the dynamics of the particles suspended in a viscous fluid and it is coupled with the flow equations. We employ a simple model that was proposed by Metzger, Rahli & Yin ( J. Fluid Mech. , vol. 724, 2013, pp. 527–552) for the effective thermal diffusivity of suspensions. This model considers the effect of shear-induced diffusion and gives the thermal diffusivity increasing linearly with the thermal Péclet number ( Pe ) and the particle volume fraction ( ϕ ). Both linear stability analysis and numerical simulation based on the mathematical models are performed for various bulk particle volume fractions $$({\phi _b})$$ ranging from 0 to 0.3. The critical Rayleigh number $$(R{a_c})$$ grows gradually by increasing $${\phi _b}$$ from the critical value $$(R{a_c} = 1708)$$ for a pure Newtonian fluid, while the critical wavenumber $$({k_c})$$ remains constant at 3.12. The transition from the conduction state of suspensions is subcritical, whereas it is supercritical for the convection in a pure Newtonian fluid $$({\phi _b} = 0)$$ . The heat transfer in moderately dense suspensions $$({\phi _b} = 0.2\text{--}0.3)$$ is significantly enhanced by convection rolls for small Rayleigh number ( Ra ) close to $$R{a_c}$$ . We also found a power-law increase of the Nusselt number ( Nu ) with Ra , namely, $$Nu\sim R{a^b}$$ for relatively large values of Ra where the scaling exponent b decreases with $${\phi _b}$$ . Finally, it turns out that the shear-induced migration of particles can modify the heat transfer.more » « less
-
The demand for flexible microelectronics has increased significantly within the last decade. This study investigates the cooling performance of flexible pulsating heat pipes (PHPs) made from acrylic with a bend radius of ≈300 mm. The fabricated devices support two-phase, pulsating fluid flow inside the rectangular microchannels. Both water and ethanol are used as coolants, where local hot spots are generated by cobalt-alloy foil heaters inside the flexible PHPs. The PHP's dissipate the heat generated to the environment via copper condensers with controlled setpoint temperatures. Based on a heater surface area of ≈1.5 cm 2 and a condenser setpoint temperature of 25°C, the maximum heat flux observed for sustained and repeatable cooling with water and ethanol was 8 W /cm 2 . These heat fluxes correlate well with other PHP studies with similar heater power loads, channel geometries, and coolants.more » « less
-
Abstract We theoretically study forced convection heat transfer from a single particle in uniform laminar flows. Asymptotic limits of small and large Peclet numbers Pe are considered. For Pe≪1 (diffusion-dominated regime) and a constant heat flux boundary condition on the surface of the particle, we derive a closed-form expression for the heat transfer coefficient that is valid for arbitrary particle shapes and Reynolds numbers, as long as the flow is incompressible. Remarkably, our formula for the average Nusselt number Nu has an identical form to the one obtained by Brenner for a uniform temperature boundary condition (Chem. Eng. Sci., vol. 18, 1963, pp. 109–122). We also present a framework for calculating the average Nu of axisymmetric and two-dimensional (2D) objects with a constant heat flux surface condition in the limits of Pe≫1 and small or moderate Reynolds numbers. Specific results are presented for the heat transfer from spheroidal particles in Stokes flow.more » « less
-
The variety of new electronic packaging technologies has grown significantly over the last 20 years as a result of market demands for higher device performance at lower costs and in less space. Those demands have pushed for heterogeneous packaging, where computer chips with different stack heights are closely packed, creating nonuniform heat flux and temperature and additional challenges for thermal management. Without implementing an appropriate thermal management strategy for heterogeneous packages, large temperature gradients can be observed within the package, which would increase the thermal stresses on the chip and raise reliability issues. To mimic this real-life scenario of such packaging, an experimental setup was designed and built. The design of the new experimental setup consists of four identical 1.2 cm × 1.2 cm ceramic heaters, each of which is connected to a separate power supply and can reach a heat flux of 140 W/cm2. Accordingly, this mock package is capable of delivering different power levels to mimic different multicore microprocessor conditions. To give the heater the ability to move precisely in the x-, y-, and z-directions, each heater is mounted to an XYZ linear stage. Deionized water (DI) was used as the working fluid, and a pin-fin heat sink was used to run the initial steady-state tests on the experimental rig. The tests showed how different flow rates at a constant fluid temperature and input power affect the temperatures of the heaters and the thermohydraulic performance of the heat sink. In addition, a three-dimensional numerical model has been developed and validated with experimental data in terms of heat sink pressure drop and the temperatures of the heaters.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript
- Journal Article:
- https://doi.org/https://doi.org/10.1016/j.ijheatmasstransfer.2021.121484
