An official website of the United States government
Abstract Seismic azimuthal anisotropy beneath Australia is investigated using splitting of the teleseismic PKS, SKKS, and SKS phases to delineate asthenospheric flow and lithospheric deformation beneath one of the oldest and fast‐moving continents on Earth. In total 511 pairs of high‐quality splitting parameters were observed at 116 seismic stations. Unlike other stable continental areas in Africa, East Asia, and North America, where spatially consistent splitting parameters dominate, the fast orientations and splitting times observed in Australia show a complex pattern, with a slightly smaller than normal average splitting time of 0.85 ± 0.33 s. On the North Australian Craton, the fast orientations are mostly N‐S, which is parallel to the absolute plate motion (APM) direction in the hotspot frame. Those observed in the South Australian Craton are mostly NE‐SW and E‐W, which are perpendicular to the maximum lithospheric horizontal shortening direction. In east Australia, the observed azimuthal anisotropy can be attributed to either APM induced simple shear or lithospheric fabric parallel to the strike of the orogenic belts. The observed spatial variations of the seismic azimuthal anisotropy, when combined with results from depth estimation utilizing the spatial coherency of the splitting parameters and seismic tomography studies, suggest that the azimuthal anisotropy in Australia can mostly be related to simple shear in the rheologically transition layer between the lithosphere and asthenosphere. Non‐APM parallel anisotropy is attributable to modulations of the mantle flow system by undulations of the bottom of the lithosphere, with a spatially variable degree of contribution from lithospheric fabric.
more »
« less
Tectonic Inheritance During Plate Boundary Evolution in Southern California Constrained From Seismic Anisotropy
Abstract The style of convective force transmission to plates and strain‐localization within and underneath plate boundaries remain debated. To address some of the related issues, we analyze a range of deformation indicators in southern California from the surface to the asthenosphere. Present‐day surface strain rates can be inferred from geodesy. At seismogenic crustal depths, stress can be inferred from focal mechanisms and splitting of shear waves from local earthquakes via crack‐dependent seismic velocities. At greater depths, constraints on rock fabrics are obtained from receiver function anisotropy,PnandPtomography, surface wave tomography, and splitting ofSKSand other teleseismic core phases. We construct a synthesis of deformation‐related observations focusing on quantitative comparisons of deformation style. We find consistency with roughly N‐S compression and E‐W extension near the surface and in the asthenospheric mantle. However, all lithospheric anisotropy indicators show deviations from this pattern.Pnfast axes and dipping foliations from receiver functions are fault‐parallel with no localization to fault traces and match post‐Farallon block rotations in the Western Transverse Ranges. Local shear wave splitting orientations deviate from the stress orientations inferred from focal mechanisms in significant portions of the area. We interpret these observations as an indication that lithospheric fabric, developed during Farallon subduction and subsequent extension, has not been completely reset by present‐day transform motion and may influence the current deformation behavior. This provides a new perspective on the timescales of deformation memory and lithosphere‐asthenosphere interactions.
more »
« less
- PAR ID:
- 10363594
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Geochemistry, Geophysics, Geosystems
- Volume:
- 22
- Issue:
- 11
- ISSN:
- 1525-2027
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Seismic anisotropy provides essential information for characterizing the orientation of deformation and flow in the crust and mantle. The isotropic structure of the Antarctic crust and upper mantle has been determined by previous studies, but the azimuthal anisotropy structure has only been constrained by mantle core phase (SKS) splitting observations. This study determines the azimuthal anisotropic structure of the crust and mantle beneath the central and West Antarctica based on 8—55 s Rayleigh wave phase velocities from ambient noise cross‐correlation. An anisotropic Rayleigh wave phase velocity map was created using a ray—based tomography method. These data are inverted using a Bayesian Monte Carlo method to obtain an azimuthal anisotropy model with uncertainties. The azimuthal anisotropy structure in most of the study region can be fit by a two‐layer structure, with one layer at depths of 0–15 km in the shallow crust and the other layer in the uppermost mantle. The azimuthal anisotropic layer in the shallow crust of West Antarctica, where it coincides with strong positive radial anisotropy quantified by the previous study, shows a fast direction that is subparallel to the inferred extension direction of the West Antarctic Rift System. Fast directions of upper mantle azimuthal anisotropy generally align with teleseismic shear wave splitting fast directions, suggesting a thin lithosphere or similar lithosphere‐asthenosphere deformation. However, inconsistencies in this exist in Marie Byrd Land, indicating differing ancient deformation patterns in the shallow mantle lithosphere sampled by the surface waves and deformation in the deeper mantle and asthenosphere sampled more strongly by splitting measurements.more » « less
-
Shear wave splitting of teleseismic core phases such as SKS is commonly used to constrain mantle seismic anisotropy, a proxy for convective deformation. In plate boundaries, sharp lateral variations of splitting measurements near transform faults are often linked to deformation within a lithospheric shear zone below, but potential seismic waveform effects from heterogeneous structure on small scales may influence the interpretation. Here, we explore possible finite frequency effects on shear wave splitting near fault zones in a fully three‐dimensional anisotropic setting. We find that shear zones wider than 80 km, a scale set by the Fresnel zone, can be clearly detected, but narrower zones are less distinguishable. Near the edge of the shear zone, the combined effect of anisotropy and scattering generates false splitting measurements with large delay times and fast axis orientation approaching the back‐azimuth, a bias which can only be identified when records from different back‐azimuths are analyzed together. This substantiates that back‐azimuthal variations of splitting can arise not just from vertical layering but also lateral changes of anisotropic media. We also test the effects of shear zone edge geometry, epicentral distance, filtering frequency, crustal thickness, and sediment cover. Our study delineates the ability of shear wave splitting to resolve and investigate fault zones, and emphasizes the importance of good azimuthal coverage to correctly interpret observed anisotropy. Based on revisiting previous shear wave splitting and lithospheric deformation studies, we infer that many crustal fault zones are underlain by lithospheric shear zones at least 20 km wide.more » « less
-
Abstract Seismic anisotropy beneath eastern North America likely reflects both the remnant lithospheric fabrics and the present‐day deformation of the asthenosphere. We report new observations of splitting in core‐refracted shear phases observed over 3–5 years at 33 sites in New Jersey, New York, and states in the New England region and also include data from eight previously studied locations. Our data set emphasizes back azimuthal coverage necessary to capture the directional variation of splitting parameters expected from vertically varying anisotropy. We report single‐phase splitting parameters as well as station‐averaged values based on splitting intensity technique that incorporates all observed records regardless of whether they showed evidence of splitting or not. Trends of averaged fast shear wave polarizations appear coherent and are approximately aligned with absolute plate motion direction. The general disparity between the fast axes and the trend of surface tectonic features suggests a dominant asthenosphere contribution for the observed seismic anisotropy. Averaged delay values systematically increase from ~0.5 s in New Jersey to ~1.4 s in Maine. Splitting parameters vary at all sites, and neighboring stations often show similar patterns of directional variation. We developed criteria to group stations based on their splitting patterns and identified four domains with distinct anisotropic properties. Splitting patterns of three domains suggest a layered anisotropic structure that is geographically variable, outlining distinct regions in the continental mantle, for example, the Proterozoic lithosphere of the Adirondack Mountains. A domain coincident with the North Appalachian Anomaly displays virtually no splitting, implying that the lithospheric fabric was locally erased.more » « less
-
Abstract This study represents the first campaign‐style teleseismic shear wave splitting (SWS) investigation of central Myanmar, an area that is tectonically controlled by the oblique subduction of the Indian Plate underneath the Eurasian Plate. The resulting 678 well‐defined and 247 null SWS measurements obtained from recently deployed 71 broadband seismic stations show that the Indo‐Burma Ranges (IBR) possess mostly N‐S fast orientations that are parallel to the trend of the depth contours of the subducted slab. Relative to the global average of 1.0 s, extremely large splitting times with station‐averaged values ranging from 1.28 to 2.79 s and an area‐averaged value of 2.09 ± 0.55 s are observed in the IBR. In contrast, the Central Basin (CB) and the Shan Plateau (SP) are characterized by slightly larger than normal splitting times. The fast orientations observed in the CB are mostly NE‐SW in the northern part of the study area, N‐S in the central part, and NW‐SE in the southern part. The fast orientations change from nearly N‐S along the N‐S oriented Sagaing Fault, to NW‐SE in the central and eastern portions of the SP. These observations, together with SWS measurements using local S events, crustal anisotropy measurements using P‐to‐S receiver functions, and the estimated depth of the source of anisotropy using the spatial coherency of the splitting parameters, suggest the presence of a trench‐parallel sub‐slab flow system driven by slab rollback, a trench‐perpendicular corner flow, and a trench‐parallel flow possibly entering the mantle wedge through a slab window or gap.more » « less
