Azimuthal variations in receiver function conversions can image lithospheric structural contrasts and anisotropic fabrics that together compose tectonic grain. We apply this method to data from EarthScope Transportable Array in Alaska and additional stations across the northern Cordillera. The best-resolved quantities are the strike and depth of dipping fabric contrasts or interfaces. We find a strong geographic gradient in such anomalies, with large amplitudes extending inboard from the present-day subduction margin, the Aleutian arc, and an influence of flat-slab subduction of the Yakutat microplate north of the Denali fault. An east–west band across interior Alaska shows low- amplitude crustal anomalies. Anomaly amplitudes correlate with structural intensity (density of aligned geological elements), but are the highest in areas of strong Cenozoic deformation, raising the question of an influence of current stress state. Imaged subsurface strikes show alignment with surface structures. We see concentric strikes around arc volcanoes implying dipping magmatic structures and fabric into the middle crust. Regions with present-day weaker deformation show lower anomaly amplitudes but structurally aligned strikes, suggesting pre-Cenozoic fabrics may have been overprinted or otherwise modified. We observe general coherence of the signal across the brittle-plastic transition. Imaged crustal fabrics are aligned with major faults and shear zones, whereas intrafault blocks show imaged strikes both parallel to and at high angles to major block-bounding faults. High-angle strikes are subparallel to neotectonic deformation, seismicity, fault lineaments, and prominent metallogenic belts, possibly due to overprinting and/or co-evolution with fault-parallel fabrics. We suggest that the underlying tectonic grain in the northern Cordillera is broadly distributed rather than strongly localized. Receiver functions thus reveal key information about the nature and continuity of tectonic fabrics at depth and can provide unique insights into the deformation history and distribution of regional strain in complex orogenic belts.
more »
« less
Tectonic Inheritance With Dipping Faults and Deformation Fabric in the Brittle and Ductile Southern California Crust
Plate motions in Southern California have undergone a transition from compressional and extensional regimes to a dominantly strike‐slip regime in the Miocene. Strike‐slip motion is most easily accommodated on vertical faults, and major transform fault strands in the region are typically mapped as near vertical on the surface. However, some previous work suggests that these faults have a dipping geometry at depth. We analyze receiver function arrivals that vary harmonically with back azimuth at all available broadband stations in the region. The results show a dominant signal from contrasts in dipping foliation as well as dipping isotropic velocity contrasts from all crustal depths, including from the ductile middle to lower crust. We interpret these receiver function observations as a dipping fault‐parallel structural fabric that is pervasive throughout the region. The strike of these structures and fabrics is parallel to that of nearby fault surface traces. We also plot microseismicity on depth profiles perpendicular to major strike‐slip faults and find consistently NE dipping features in seismicity changing from near vertical (80–85°) on the Elsinore Fault in the Peninsular Ranges to 60–65° slightly further inland on the San Jacinto Fault to 50–55° on the San Andreas Fault. Taken together, the dipping features in seismicity and in rock fabric suggest that preexisting fabrics and faults may have acted as strain guides in the modern slip regime, with reactivation and growth of strike‐slip faults along northeast dipping fabrics both above and below the brittle‐ductile transition.
more » « less- NSF-PAR ID:
- 10364035
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Journal of Geophysical Research: Solid Earth
- Volume:
- 125
- Issue:
- 8
- ISSN:
- 2169-9313
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
null (Ed.)Abstract Azimuthal variations in receiver function conversions can image lithospheric structural contrasts and anisotropic fabrics that together compose tectonic grain. We apply this method to data from EarthScope Transportable Array in Alaska and additional stations across the northern Cordillera. The best-resolved quantities are the strike and depth of dipping fabric contrasts or interfaces. We find a strong geographic gradient in such anomalies, with large amplitudes extending inboard from the present-day subduction margin, the Aleutian arc, and an influence of flat-slab subduction of the Yakutat microplate north of the Denali fault. An east–west band across interior Alaska shows low-amplitude crustal anomalies. Anomaly amplitudes correlate with structural intensity (density of aligned geological elements), but are the highest in areas of strong Cenozoic deformation, raising the question of an influence of current stress state. Imaged subsurface strikes show alignment with surface structures. We see concentric strikes around arc volcanoes implying dipping magmatic structures and fabric into the middle crust. Regions with present-day weaker deformation show lower anomaly amplitudes but structurally aligned strikes, suggesting pre-Cenozoic fabrics may have been overprinted or otherwise modified. We observe general coherence of the signal across the brittle-plastic transition. Imaged crustal fabrics are aligned with major faults and shear zones, whereas intrafault blocks show imaged strikes both parallel to and at high angles to major block-bounding faults. High-angle strikes are subparallel to neotectonic deformation, seismicity, fault lineaments, and prominent metallogenic belts, possibly due to overprinting and/or co-evolution with fault-parallel fabrics. We suggest that the underlying tectonic grain in the northern Cordillera is broadly distributed rather than strongly localized. Receiver functions thus reveal key information about the nature and continuity of tectonic fabrics at depth and can provide unique insights into the deformation history and distribution of regional strain in complex orogenic belts.more » « less
-
more » « less
Abstract The convergent plate boundary in eastern Indonesia and Timor‐Leste captures an active oblique collision between the Banda Arc and the Australian plate. We analyzed ∼5 years' worth (2014–2019) of radial and tangential teleseismic Ps receiver functions (RFs) observed at 30 temporary broadband seismic stations across the area. Azimuthal variations in RF arrivals are observed throughout the region, indicative of the presence of oriented tectonic fabrics (dipping contrasts or plunging axis anisotropy) from a variety of crustal depths. The two main strikes of these fabrics are roughly parallel to the orogen and the plate convergence across the outer arc islands, likely associated with orogenic and strike‐slip structures. We observe distinct double polarity‐reversal arrivals with opposite polarity that reflect an anisotropic layer with orogen‐parallel strikes in the shallow crust beneath Timor and Savu, interpreted as metamorphic rocks. Fabrics oriented E‐W are imaged beneath the Flores and Lomblen that host active volcanoes, where we find interesting correlations with magmatic structures. NNW‐SSE striking fabric is imaged at ∼13 km depth beneath central Flores, which relates to a connected dike magmatic system that feeds the aligned cinder cones exposed on the surface. Finally, we identify convergence‐parallel fabrics on the volcano‐extinct islands of Alor and Atauro, consistent with one main fabric orientation imaged in Timor. We suggest all convergence‐parallel fabrics might accommodate strike‐slip motion generated by the overall NNE convergence of the Australian plate with respect to Eurasian plate and contribute to strain partitioning between the trough and backarc resulting from the collision.
-
Robles, F. ; Schwartz, J. ; Miranda, E. ; Klepeis, K. ; and Mora-Klepeis, G. (Ed.)Ancient basement rocks in Southern California contain mechanical anisotropies that may influence the architecture of Quaternary faulting. We study exposed basement rocks found within the southeastern San Gabriel lithotectonic block with the intention of reconciling the relationship between inherited ductile fabrics and the geometry of Quaternary faults that are part of the San Andreas Fault system. By focusing our study on the southeastern corner of the San Gabriel block we can study the exposed lower- to middle crustal shear zone fabrics near where the Cucamonga Fault and the San Jacinto Fault intersect. The brittle Quaternary Cucamonga Thrust Fault strikes E-W and dips to the north-northeast (35-25°) and is localized at the range front and cuts these older fabrics, however there is also brittle deformation distal from the fault that also affects the sequence of lower- to middle crustal (6-8 kbar) granulite- to upper amphibolite facies mylonite and granulite-facies metasedimentary rocks. Near the Cucamonga Fault, mylonitic fabrics strike E-W and dip northeast (40-50°). Quaternary brittle faults that strike E-W and dip northeast (30-40°) reactivate the mvlonites and slickenlines and record a sinistral, top-to-the-west sense of shear. Investigation of host rocks indicates that they formed in the roots of a continental arc which was active from the Middle Jurassic to Late Cretaceous (172-86 Ma) at 740-800°C. Ductile deformation was associated with granulite-facies metamorphism at approximately 30 km depth during the Late Cretaceous (88-74 Ma) at 730-800 °C. Our work shows that the exhumed Late Cretaceous mylonitic fabrics may have operated as stress guides during Quaternary faulting in the Cucamonga Fault zone. We conclude that these lower crustal fabrics influence the geometry and kinematics of late Cenozoic faulting of the Cucamonga and San Jacinto fault zones.more » « less
-
ABSTRACT The largest earthquake since 1954 to strike the state of Nevada, United States, ruptured on 15 May 2020 along the Monte Cristo range of west-central Nevada. The Mw 6.5 event involved predominantly left-lateral strike-slip faulting with minor normal components on three aligned east–west-trending faults that vary in strike by 23°. The kinematic rupture process is determined by joint inversion of Global Navigation Satellite Systems displacements, Interferometric Synthetic Aperture Radar (InSAR) data, regional strong motions, and teleseismic P and SH waves, with the three-fault geometry being constrained by InSAR surface deformation observations, surface ruptures, and relocated aftershock distributions. The average rupture velocity is 1.5 km/s, with a peak slip of ∼1.6 m and a ∼20 s rupture duration. The seismic moment is 6.9×1018 N·m. Complex surface deformation is observed near the fault junction, with a deep near-vertical fault and a southeast-dipping fault at shallow depth on the western segment, along which normal-faulting aftershocks are observed. There is a shallow slip deficit in the Nevada ruptures, probably due to the immature fault system. The causative faults had not been previously identified and are located near the transition from the Walker Lane belt to the Basin and Range province. The east–west geometry of the system is consistent with the eastward extension of the Mina Deflection of the Walker Lane north of the White Mountains.more » « less
