An official website of the United States government
Abstract Understanding earthquake foreshocks is essential for deciphering earthquake rupture physics and can aid seismic hazard mitigation. With regional dense seismic arrays, we identify immediate foreshocks of 527 0.9M5.4 events of the 2019 Ridgecrest earthquake sequence, including 48 earthquakes with series of immediate foreshocks. These immediate foreshocks are adjacent to the mainshocks occurring within 100 s of the mainshocks, and their P waves share high resemblances with the mainshock P waves. However, attributes of the immediate‐foreshock P waves, including the amplitudes and preceding times, do not clearly scale with the mainshock magnitudes. Our observations suggest that earthquake rupture may initiate in a universal fashion but evolves stochastically. This indicates that earthquake rupture development is likely controlled by fine‐scale fault heterogeneities in the Ridgecrest fault system, and the final magnitude is the only difference between small and large earthquakes.
more »
« less
Rupture Directivity of the 2021 M W 6.0 Yangbi, Yunnan Earthquake
Abstract The 2021MW6.0 Yangbi, Yunnan strike‐slip earthquake occurred on an unmapped crustal fault near the Weixi‐Qiaoho‐Weishan Fault along the southeast margin of the Tibetan Plateau. Using near‐source broadband seismic data from ChinArray, we investigate the spatial and temporal rupture evolution of the mainshock using apparent moment‐rate functions (AMRFs) determined by the empirical Green's function (EGF) method. Assuming a 1D line source on the fault plane, the rupture propagated unilaterally southeastward (∼144°) over a rupture length of ∼8.0 km with an estimated rupture speed of 2.1 km/s to 2.4 km/s. A 2D coseismic slip distribution for an assumed maximum rupture propagation speed of 2.2 km/s indicates that the rupture propagated to the southeast ∼8.0 km along strike and ∼5.0 km downdip with a peak slip of ∼2.1 m before stopping near the largest foreshock, where three bifurcating subfaults intersect. Using the AMRFs, the radiated energy of the mainshock is estimated as ∼. The relatively low moment scaled radiated energyof 1.5 × 10−5and intense foreshock and aftershock activity might indicate reactivation of an immature fault. The earthquake sequence is mainly distributed along a northwest‐southeast trend, and aftershocks and foreshocks are distributed near the periphery of the mainshock large‐slip area, suggesting that the stress in the mainshock slip zone is significantly reduced to below the level for more than a few overlapping aftershock to occur.
more »
« less
- Award ID(s):
- 1802364
- PAR ID:
- 10373475
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Journal of Geophysical Research: Solid Earth
- Volume:
- 127
- Issue:
- 9
- ISSN:
- 2169-9313
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract The Indo‐Burma subduction zone is a highly oblique subduction system where the Indian plate is converging with the Eurasian plate. How strain is partitioned between the Indo‐Burma interface and upper plate Kabaw Fault, and whether the megathrust is a locked and active zone of convergence that can generate great earthquakes are ongoing debates. Here, we use data from a total of 68 Global Navigation Satellite System (GNSS) stations, including newly installed stations across the Kabaw Fault and compute an updated horizontal and vertical GNSS velocity field. We correct vertical rates for fluctuating seasonal signals by accounting for the elastic response of monsoon water on the crust. We model the geodetic data by inverting for 11,000 planar and non‐planar megathrust fault geometries and two geologically viable structural interpretations of the Kabaw Fault that we construct from field geological data, considering a basin‐scale wedge‐fault and a crustal‐scale reverse fault. We demonstrate that the Indo‐Burma megathrust is locked, converging at a rate ofmm/yr, and capable of hosting >8.2Mwmegathrust events. We also show that the Kabaw Fault is locked and accommodating strike‐slip motion at a rate ofmm/yr and converging at a rate ofmm/yr. Our interpretation of the geological, geophysical, and geodetic datasets indicates the Kabaw Fault is a crustal‐scale structure that actively absorbs a portion of the convergence previously ascribed to the Indo‐Burma megathrust. This reveals a previously unrecognized seismic hazard associated with the Kabaw Fault and slightly reduces the estimated hazard posed by megathrust earthquakes in the region.more » « less
-
Abstract On 4 and 6 July 2019, two large strike‐slip earthquakes withW‐phase moment magnitudesMWW6.5 (foreshock) andMWW7.1 (mainshock) struck the Eastern California Shear Zone, northeast of Ridgecrest. The faulting geometry and kinematic coseismic slip distribution of both events are determined by jointly inverting seismological and geodetic observations guided by aftershock and surface rupture locations. The foreshock ruptured two orthogonal faults with a prominent L‐shaped geometry with maximum slip of ~1.1 m on the NE‐SW segment. The mainshock faulting extended NW‐SE along several primary fault segments that straddle the foreshock slip. The surface rupture and slip model indicate mostly near‐horizontal strike‐slip motion with maximum slip of ~3.7 m, but there is a localized vertical dip‐slip motion. Both the foreshock and mainshock ruptures terminate in regions of complex surface offsets. High aftershock productivity and low rupture velocity may be the result of rupture of a relatively immature fault system.more » « less
-
Abstract We examine the spatiotemporal variations in seismic parameters corresponding to the 2018 Kīlauea eruption. We find that the summit area had mainly strike‐slip focal solutions prior to the eruption, whereas normal‐faulting was the predominant feature during the eruption, partially due to the collapse events. In contrast, the majority of the earthquakes in the central south flank had normal‐faulting solutions before December 2017, in agreement with the normal‐faulting of the Hilina Fault System, while there are more reverse solutions during the eruption. We also observe temporal variations in the estimated in situratios corresponding to the eruption, with increases in the summit and decreases in the East Rift Zone. The sustained lowratios below 4 km depth under the summit caldera may suggest persistent ascent of volatiles from the mantle. The lowvalues in the East Rift Zone are probably associated with increased degassing.more » « less
-
Abstract The number of aftershocks increases with mainshock size following a well‐defined scaling law. However, excursions from the average behavior are common. This variability is particularly concerning for large earthquakes where the number of aftershocks varies by factors of 100 for mainshocks of comparable magnitude. Do observable factors lead to differences in aftershock behavior? We examine aftershock productivity relative to the global average for all mainshocks () from 1990 to 2019. A global map of earthquake productivity highlights the influence of tectonic regimes. Earthquake depth, lithosphere age, and plate boundary type correspond well with earthquake productivity. We investigate the role of mainshock attributes by compiling source dimensions, radiated seismic energy, stress drop, and a measure of slip heterogeneity based on finite‐fault source inversions for the largest earthquakes from 1990 to 2017. On an individual basis, stress drop, normalized rupture width, and aspect ratio most strongly correlate with aftershock productivity. A multivariate analysis shows that a particular set of parameters (dip, lithospheric age, and normalized rupture area) combines well to improve predictions of aftershock productivity on a cross‐validated data set. Our overall analysis is consistent with a model in which the volumetric abundance of nearby stressed faults controls the aftershock productivity rather than variations in source stress. Thus, we suggest a complementary approach to aftershock forecasts based on geological and rupture properties rather than local calibration alone.more » « less
