An official website of the United States government
Since the impact ∼50,000 yr ago, surface runoff has entrained and transported sediment from the walls to the floor of Meteor Crater (Arizona, USA). Previous work interpreted this erosion and deposition to be due to predominantly fluvial (i.e., dilute water transport) processes. However, light detection and ranging (LiDAR)−derived topographic data and field observations indicate that debris flows dominated, which were likely generated by runoff that entrained the talus that borders bedrock cliffs high on the crater walls. The low gradient of the crater floor caused debris flows to stop, leaving lobate deposits, while fluvial processes delivered sediment toward the center of the crater. Cosmogenic radionuclide dating of levee deposits suggests that debris-flow activity ceased in the late Pleistocene, synchronous with regional drying. Assuming a rock-to-water ratio of 0.3 at the time of transport by mass flows, it would have taken ∼2 × 106 m3 of water to transport the estimated ∼6.8 × 106 m3 of debris-flow deposits found at the surface of the crater floor. This extensive erosion would require ∼6 m of total runoff over the 0.35 km2 upslope source area of the crater, or ∼18 mm of runoff per debris-flow event. Much more runoff did occur, as evidenced by crater lake deposits, Holocene fluvial activity (which produced little erosion), and contemporary rainfall rates. Rarely on Earth is the total amount of water that creates and runs through a landscape estimated, yet such calculations are commonly done on Mars. Our analysis suggests that erosional and depositional landforms may record only a small fraction of the total runoff.
more »
« less
Rates and processes controlling periglacial alluvial fan formation: Implications for martian fans
Alluvial fans are found across a range of climates and are built from a combination of fluvial and debris flow processes. Correct identification of process is critical to reconstructing the climate and water histories of alluvial fans on Earth and Mars. Theory and data from subaerial Earth fans are often used to estimate paleoflow discharges and sediment fluxes for martian fans; however, most terrestrial work has been conducted on fans that are in hot, dry climates with runoff sourced from rainfall. This differs from the prevailing interpretation that martian fans were sourced from snowmelt under warming periglacial conditions. To characterize processes and rates of periglacial fan formation, we conducted a field-based study of the Black Mountain alluvial fan in the Aklavik Range, Canada. We observed active fluvial bedload transport as well as several small debris flows that had initiated from ice-filled gullies. Following a runoff event of ∼0.005 mm/hr to ∼0.2 mm/hr across the fan, we estimated sediment fluxes of ∼0.04 m3/hr. Under bankfull conditions, we estimated runoff rates between ∼0.01 mm/hr to ∼14 mm/hr and corresponding sediment fluxes of ∼0.3 m3/hr to ∼550 m3/hr. This suggests that moderate flow events, well below the maximum runoff production rates suggested for Mars, are capable of entraining and transporting appreciable amounts of sediment by fluvial processes. However, sedimentological and geomorphological observations suggest that ∼67% of the fan was deposited fluvially; the remainder was deposited by mass flows. Our results emphasize the need to take care in interpreting martian sedimentary processes and climate from fan surface morphology alone.
more »
« less
- Award ID(s):
- 2116471
- PAR ID:
- 10384147
- Date Published:
- Journal Name:
- GSA Bulletin
- ISSN:
- 0016-7606
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Alluvial fans are large-scale depositional structures commonly found at the base of mountain ranges. They are relatively soil-rich compared to the rocky terrains, or catchment areas, from which their material originates. When frequented by debris flows (massive, muddy, rocky flows) they contribute significantly to local hazards as they carry focused, collisional, fast-moving materials across alluvial fans, unpredictable in size, speed, and direction. We research how fine particle content in debris flows correlates with directional changes, i.e., debris flow avulsions. Toward this, we analyzed field data from two neighboring alluvial fans in the White Mountains (California, USA) that exhibit dramatically different topographies despite their proximity and associated similar long-term climates. Informed by these measurements, we performed long-term and incremental alluvial fan experiments built by debris flows with systematically-varied fine particle content. We found that (1) decreasing fine particle content increases the variability of fan slopes and associated channelization dynamics, and (2) for all mixtures longer-term continuous alluvial fan experiments form more complex surface channelizations than repeated flows for the same total time, indicating the importance ofbothparticle sizes and timescales on alluvial fan surface morphology.more » « less
-
Abstract Fluvial fans are large, low-gradient depositional systems that occur in sedimentary basins worldwide. Fluvial fans can represent much of the geologic record of foreland basins, create hazards, and record paleoclimate and tectonic signals. However, we lack an understanding of how fluvial fans grow into the variety of shapes observed around the world. We explored this aspect using a cellular model of foreland basin landscape evolution with rules for sediment transport, river avulsion, and floodplain processes. We tested the hypothesis that avulsion dynamics, namely, avulsion trigger period and abandoned channel dynamics, are a primary control on fluvial fan development. We found that shorter trigger periods lead to rounder planform fluvial fan shapes because, between avulsions, channel aggradation (and thus avulsion setup) propagates shorter distances from the upstream boundary along channel pathways. This prioritizes lateral sediment dispersion, creating shorter, rounder fans, over sediment delivery further into the basin, which would create elongated fans. Modeled fans with abandoned channel attraction (but not repulsion) generated a commonly observed abrupt fan boundary marked by a transition from distributary to tributary channel patterns. While fluvial fans are thought to be linked to climate, they can occur anywhere that rivers aggrade, lose lateral confinement, and preserve alluvial topography. Instead, fluvial fans might be more recognizable in environments that frequently trigger avulsions and preserve abandoned channels that capture future avulsions.more » « less
-
Large fan-shaped sediment distributary systems (103 – 105 km2), typically referred to as fluvial megafans, are found proximal to topographic barriers within terrestrial basins. Concepts regarding their formation have been focused on water-dominated processes associated with monsoonal climates, high sediment bedload, and flow rate. But are there other processes behind the erratic avulsive channel behavior of some of the largest fans on the planet? This study presents remotely mapped geomorphic observations from megafans including playa lakes, dunes, vegetation patterns, and basin elevation profiles of fans. Corroborating these concepts are field observations drawn from the Chaco Plain of Argentina. Active tectonics set the stage for multiple monsoon-affected eastward-flowing fluvial systems to interact with the northerly prevailing winds from the South American lower-level jet. The Chaco megafans exhibit low overall slope and limited drainage integration creating playas in both abandoned channels within the active fluvial belt and small depressions on the loess-covered floodplains. Chaco forebulge stratigraphy shows that distal from the main fluvial belt multiple loess-paleosol sequences are present up to four meters below the surface. This suggests that where subsidence outpaces fluvial avulsion rates, fine-grain wind-blown detritus aggrades in packages defined by soil profiles. Loessic paleosols are also located proximal to the orographic front, where the development of uplands relative to modern/recent fluvial incision protects the eolian sediments from erosion. Varying temporal cyclicity in aridity and seasonality of precipitation determines the climatic regime that the megafan sediments experience, resulting in megafans covered in complex fabrics of slope-oriented fluvial/pluvial features superimposed on wind-oriented eolian features and vice versa. The interaction of these depositional environments in the Chaco foreland basin highlights the smoothing effect of eolian transport and deposition, which may allow for high-avulsion rates that enhance megafan development. These geomorphic features can be observed on other globally notable megafan basin systems, highlighting the complexity of sediment transport pathways within a terrestrial realm.more » « less
-
na (Ed.)We build on previous work which explained the origin of myriad gullies and incised channels on the dry, sandy uplands of northern Lower Michigan by invoking widespread permafrost. Indicators of permafrost (ice-wedge casts and patterned ground) are known from many sites across the region. Our study area, within an extensive reentrant of the retreating Laurentide Ice Sheet, had been particularly well positioned, geographically, for permafrost. Our goal was to characterize the geomorphic characteristics of the gullies on 72 large ridges, to address the hypothesis that they had formed in association with permafrost. Across the study area, thousands of dry, narrow channels and gullies occur in dense networks, typically with channels aligned directly downslope, in parallel drainage patterns. Most of the gullies exhibit only a minimal amount of incision (ca. 2–3 m), a nearly straight longitudinal profile, and lack a clear depositional fan at their mouth. Even where small fans are present, they are subtle and exhibit little down-fan textural sorting, as would be present in larger, more mature fluvial systems. Gully morphologies did not exhibit strong morphological differences as a function of aspect, as we would have expected for an erosional, periglacial system forming on fairly steep slopes. Nonetheless, in these sandy/gravelly sediments, we could find no other scenario that would have allowed for runoff and gully formation, except ice-rich permafrost that limited infiltration and promoted saturation of the active layer, and eventually, runoff. We conclude that the gullies formed via thermo-erosion into ice-rich permafrost, involving mostly fluvial processes but also some slope failure. Even though thermo-erosion can rapidly form deep gullies, our study area has mainly weak gully forms, perhaps because: (1) permafrost existed here only briefly, (2) the landscape was so cold and the permafrost so ice-rich that runoff was rare, (3) the permafrost on the sandy slopes remained somewhat permeable, limiting runoff, and/or (4) the paleoclimate was so dry that little water was available for sediment transport. We could find no evidence that the gullies developed within preexisting polygonal networks, as is happening today in polar regions under a warming climate. Thus, our study has implications for areas of the Arctic and Antarctic that are, today, experiencing rapid hydrological changes.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1130/B36459.1
