An official website of the United States government
The effects of horizontal resolution and wave drag damping on the semidiurnal M2 tidal energetics are studied for two realistically-forced global HYbrid Coordinate Ocean Model (HYCOM) simulations with 41 layers and horizontal resolutions of 8 km (H12) and 4 km (H25). In both simulations, the surface tidal error is minimized by tuning the strength of the linear wave drag, which is a parameterization of the surface-tide energy conversion to the unresolved baroclinic wave modes. In both simulations the M2 surface tide error with TPXO8-atlas, an altimetry constrained model, is 2.6 cm. Compared to H12, the surface tide energy conversion to the resolved vertical modes is increased by 50% in H25. This coincides with an equivalent reduction in the tuned loss of energy from the surface tide to the wave drag. For the configurations studied here, the horizontal and not the vertical resolution is the factor limiting the number of vertical modes that are resolved in most of the global ocean: modes 1–2 in H12 and modes 1–5 in H25. The wave drag also dampens the resolved internal tides. The 40% reduction in wave-drag strength does not result in a proportional increase in the mode-1 energy density in H25. In the higher-resolution simulations, topographic mode-scattering and wave–wave interactions are better resolved. This allows for an energy flux out of mode 1 to the higher modes, mitigating the need for an internal tide damping term. The HYCOM simulations are validated with analytical conversion models and altimetry-inferred sea-surface height, fluxes, and surface tide dissipation. H25 agrees best with these data sets to within 10%. To facilitate the comparison of stationary tide signals extracted from time series with different durations, we successfully apply a spatially-varying correction factor.
more »
« less
Coastal Trapped Waves: Normal Modes, Evolution Equations, and Topographic Generation
Abstract Coastal trapped waves (CTWs) transport energy along coastlines and drive coastal currents and upwelling. CTW modes are nonorthogonal when frequency is treated as the eigenvalue, preventing the separation of modal energy fluxes and quantification of longshore topographic scattering. Here, CTW modes are shown to be orthogonal with respect to energy flux (but not energy) when the longshore wavenumber is the eigenvalue. The modal evolution equation is a simple harmonic oscillator forced by longshore bathymetric variability, where downstream distance is treated like time. The energy equation includes an expression for modal topographic scattering. The eigenvalue problem is carefully discretized to produce numerically orthogonal modes, allowing CTW amplitudes, energy fluxes, and generation to be precisely quantified in numerical simulations. First, a spatially uniform K 1 longshore velocity is applied to a continental slope with a Gaussian bump in the coastline. Mode-1 CTW generation increases quadratically with the amplitude of the bump and is maximum when the bump’s length of coastline matches the natural wavelength of the CTW mode, as predicted by theory. Next, a realistic K 1 barotropic tide is applied to the Oregon coast. The forcing generates mode-1 and mode-2 CTWs with energy fluxes of 6 and 2 MW, respectively, which are much smaller than the 80 MW of M 2 internal-tide generation in this region. CTWs also produce 1-cm sea surface displacements along the coast, potentially complicating the interpretation of future satellite altimetry. Prospects and challenges for quantifying the global geography of CTWs are discussed.
more »
« less
- Award ID(s):
- 1635560
- PAR ID:
- 10392691
- Date Published:
- Journal Name:
- Journal of Physical Oceanography
- Volume:
- 52
- Issue:
- 8
- ISSN:
- 0022-3670
- Page Range / eLocation ID:
- 1835 to 1848
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Through interactions with the continental margins, incident low‐mode internal tides (ITs) can be reflected, scattered to high modes, transmitted onto the shelf and dissipated. We investigate the fate of remotely generated mode‐1 ITs in the U.S. West Coast (USWC) continental margin using two 4‐km horizontal resolution regional simulations. These 1‐year long simulations have realistic stratification, and atmospheric, tidal, and sub‐tidal forcings. In addition, one of these simulations has remote internal wave (IW) forcing at the open boundaries while the other does not. To compute the IT reflectivity of the USWC margin, we separate the IT energy fluxes into onshore and offshore propagating components using a Discrete Fourier Transform in space and time. Overall, ∼20% of the remote mode‐1 semidiurnal IT energy fluxes reflect off the USWC margin, 40% is scattered to modes 2–5, and 7% is transmitted onto the shelf while the remaining is dissipated on the continental slope. Furthermore, our results reveal that differences in stratification, slope criticality, topographic roughness and angle of incidence cause these fractions to vary spatially and temporally along the USWC margin. However, there is no clear seasonal variability in these estimates. Remote IWs enhance the advection and diffusion of heat in the continental margin, resulting in cooling at the surface and warming at depth, and a reduction in the thermocline stratification. These results suggest that low‐mode ITs can cause water mass transformation in continental margins that are far away from their generation sites.more » « less
-
The M2internal tide field contains waves of various baroclinic modes and various horizontal propagation directions. This paper presents a technique for decomposing the sea surface height (SSH) field of the multimodal multidirectional internal tide. The technique consists of two steps: first, different baroclinic modes are decomposed by two-dimensional (2D) spatial filtering, utilizing their different horizontal wavelengths; second, multidirectional waves in each mode are decomposed by 2D plane wave analysis. The decomposition technique is demonstrated using the M2internal tide field simulated by the MITgcm. This paper focuses on a region lying off the U.S. West Coast ranging 20°–50°N, 220°–245°E. The lowest three baroclinic modes are separately resolved from the internal tide field; each mode is further decomposed into five waves of arbitrary propagation directions in the horizontal. The decomposed fields yield unprecedented details on the internal tide’s generation and propagation, which cannot be observed in the harmonically fitted field. The results reveal that the mode-1 M2internal tide in the study region is dominantly from the Hawaiian Ridge to the west but also generated locally at the Mendocino Ridge and continental slope. The mode-2 and mode-3 M2internal tides are generated at isolated seamounts, as well as at the Mendocino Ridge and continental slope. The Mendocino Ridge radiates both southbound and northbound M2internal tides for all three modes. Their propagation distances decrease with increasing mode number: mode-1 waves can travel over 2000 km, while mode-3 waves can only be tracked for 300 km. The decomposition technique may be extended to other tidal constituents and to the global ocean.more » « less
-
Abstract The generation of internal tides at coastal margins is an important mechanism for the loss of energy from the barotropic tide. Although some previous studies attempted to quantify energy loss from the barotropic tides into the deep ocean, global estimates are complicated by the coastal geometry and spatially and temporally variable stratification. Here, we explore the effects of supercritical, finite amplitude bottom topography, which is difficult to solve analytically. We conduct a suite of 2D linear numerical simulations of the barotropic tide interacting with a uniform alongshore coastal shelf, representing the tidal forcing by a body force derived from the vertical displacement of the isopycnals by the gravest coastal trapped wave (of which a Kelvin wave is a close approximation). We explore the effects of latitude, topographic parameters, and nonuniform stratification on the baroclinic tidal energy flux propagating into the deep ocean away from the shelf. By varying the pycnocline depth and thickness, we extend previous studies of shallow and infinitesimally thin pycnoclines to include deep permanent pycnoclines. We find that scaling laws previously derived in terms of continental shelf width and depth for shallow and thin pycnoclines generally hold for the deeper and thicker pycnoclines considered in this study. We also find that baroclinic tidal energy flux is more sensitive to topographic than stratification parameters. Interestingly, we find that the slope of the shelf itself is an important parameter but not the width of the continental slope in the case of these steep topographies. Significance StatementThe objective of this study is to better understand how vertical density stratification, which can vary seasonally in the ocean, affects the interaction of tides with steep coastal topography and the generation of waves that travel away from the coast in the ocean interior. These waves in the interior can travel over long distances, carrying energy offshore into the deep ocean. Our results suggest that the amount of energy in these internal waves is more sensitive to changes in topography and latitude than to the vertical density profile. The scaling laws found in this study suggest which parameters are important for calculating global estimates of the energy lost from the tide to the ocean interior at the coastal margins.more » « less
-
Abstract High‐tide flooding—minor, disruptive coastal inundation—is expected to become more frequent as sea levels rise. However, quantifying just how quickly high‐tide flooding rates are changing, and whether some places experience more high‐tide flooding than others, is challenging. To quantify trends in high‐tide flooding from tide‐gauge observations, flood thresholds—elevations above which flooding begins—must be specified. Past studies of high‐tide flooding in the United States have used different data sets and approaches for specifying flood thresholds, only some of which directly relate to coastal impacts, which has lead to sometimes conflicting and ambiguous results. Here we present a novel method for quantifying, with uncertainty, high‐tide flooding thresholds along the United States coast based on sparsely available impact‐based flood thresholds. We use those newly modeled thresholds to make an updated assessment of changes in high‐tide flooding across the United States over the past few decades. From 1990–2000 to 2010–2020, high‐tide flooding rates almost certainly (probability ) increased along the United States East Coast, Gulf Coast, California, and Pacific Islands, while they very likely decreased along Alaska during that time; significant changes in high‐tide flooding rates between the two decades were not detected in Oregon, Washington, and the Caribbean. Averaging spatially, we find that high‐tide flooding rates probably more than doubled nationally between 1990–2000 and 2010–2020. Our approach lays a foundation for future studies to more accurately model high‐tide flood thresholds and trends along the global coastline.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1175/JPO-D-21-0220.1
