An official website of the United States government
Cation site occupation is an important determinant of materials properties, especially in a complex system with multiple cations such as in ternary spinels. Many methods for extracting the cation site information have been explored in the past, including analysis of spectra obtained through K-edge X-ray absorption spectroscopy (XAS). In this work, we measure the effectiveness of X-ray emission spectroscopy (XES) for determining the cation site occupation. As a test system we use spinel phase Co x Mn 3−x O 4 nanoparticles contaminated with CoO phases because Co and Mn can occupy all cation sites and the impurity simulates typical products of oxide syntheses. We take advantage of the spin and oxidation state sensitive Kβ 1,3 peak obtained using XES and demonstrate that XES is a powerful and reliable technique for determining site occupation in ternary spinel systems. Comparison between the extended X-ray absorption fine structure (EXAFS) and XES techniques reveals that XES provides not only the site occupation information as EXAFS, but also additional information on the oxidation states of the cations at each site. We show that the error for EXAFS can be as high as 35% which makes the results obtained ambiguous for certain stoichiometries, whereas for XES, the error determined is consistently smaller than 10%. Thus, we conclude that XES is a superior and a far more accurate method than XAS in extracting cation site occupation in spinel crystal structures.
more »
« less
A laboratory X-ray emission spectrometer for phosphorus Kα and Kβ study of air-sensitive samples
The analytical chemistry of phosphorus-containing materials is often impeded by the long measurement times and relatively large sample masses needed for 31 P NMR spectroscopy, by the scarcity and access limitations of synchrotron beamlines operating in the energy range of the P K-edge, by the challenges posed by species interconversion during liquid extraction, and by the considerable air-sensitivity typical of many phosphorus-containing materials and nanophases. To this end, we report the design and operation of a new laboratory-based spectrometer to simultaneously perform P Kα and Kβ X-ray emission spectroscopy (XES) while being housed in a research-grade controlled-atmosphere glovebox. Demonstration studies on nickel phosphide nanophases illustrate the importance of air-free XES and the value of simultaneous Kα and Kβ spectroscopy for identifying the P oxidation state and for investigating nanoscale influences on valence level electronic structures.
more »
« less
- PAR ID:
- 10410660
- Date Published:
- Journal Name:
- Journal of Analytical Atomic Spectrometry
- ISSN:
- 0267-9477
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Tracking the change in electronic structure of target elements is crucial to investigate the nature of redox reactions occurring in battery electrodes. X-ray emission spectroscopy (XES) and x-ray absorption fine structure (XAFS) perform this role well with high sensitivity and throughput, but the requisite of synchrotron facilities often limits those availability for material characterization. Using a lab-scale x-ray emission/absorption spectrometer, we investigated the changes in the local structure and chemistry around the 3d transition metal elements of LiMO 2 cathodes for Li-ion batteries as a function of the battery state of charge (SoC). Ex situ measurement was prepared from the electrode samples with discrete difference in SoC. Coupled with ex situ measurement, operando measurement was performed using pouch cells with LiMO 2 cathode, which enabled a real-time monitoring of chemical shift in an element-specific manner resulted from changing electrode potential. Through the XES mode of the bench-top spectrometer, fluorescence emissions from the LiMO 2 cathode, or the cell containing it, was monochromatized by a spherically bent crystal analyzer (SBCA). The Kβ emissions of 3d transition metal elements such as cobalt display position/shape difference of spectrum with varying SoC. The trend of chemical shift and change in spectral features provided the information on the electronic structure variation, such as oxidation state change of 3d transition metals in LiMO 2 during charge and discharge (i.e., delithiation and lithiation). Furthermore, valence-to-core (VtC) emission signals helped enable in-depth analysis such as spin structure characterization. In addition to the XES analysis, we could measure K-edge XAFS for the same 3d transition metals in LiMO 2 as well. In the XAFS mode of the spectrometer, SBCA monochromatized bremsstrahlung x-ray generated from a high-power x-ray tube is used to make an incident source energy-dispersive. While Kβ XES probed occupied levels, K-edge XAFS examined unoccupied levels providing comprehensive understanding on the change in electronic structure of 3d transition metals in LiMO 2 . Figure 1more » « less
-
Removing phosphorus (P) from water and wastewater is essential for preventing eutrophication and protecting environmental quality. Lanthanum [La(III)]-containing materials can effectively and selectively remove orthophosphate (PO4) from aqueous systems, but there remains a need to better understand the underlying mechanism of PO4 removal. Our objectives were to 1) identify the mechanism of PO4 removal by La-containing materials and 2) evaluate the ability of a new material, La2(CO3)3(s), to remove PO4 from different aqueous matrices, including municipal wastewater. We determined the dominant mechanism of PO4 removal by comparing geochemical simulations with equilibrium data from batch experiments and analyzing reaction products by X-ray diffraction and scanning transmission electron microscopy with energy dispersive spectroscopy. Geochemical simulations of aqueous systems containing PO4 and La-containing materials predicted that PO4 removal occurs via precipitation of poorly soluble LaPO4(s). Results from batch experiments agreed with those obtained from geochemical simulations, and mineralogical characterization of the reaction products were consistent with PO4 removal occurring primarily by precipitation of LaPO4(s). Between pH 1.5 and 12.9, La2(CO3)3(s) selectively removed PO4 over other anions from different aqueous matrices, including treated wastewater. However, the rate of PO4 removal decreased with increasing solution pH. In comparison to other solids, such as La(OH)3(s), La2(CO3)3(s) exhibits a relatively low solubility, particularly under slightly acidic conditions. Consequently, release of La3+ into the environment can be minimized when La2(CO3)3(s) is deployed for PO4 sequestration.more » « less
-
Spherically‐bent crystal analyzers (SBCAs) see considerable use in very high‐resolution hard X‐ray wavelength dispersive X‐ray fluorescence spectroscopy, often called X‐ray emission spectroscopy (XES). While Si and Ge are the most frequently used diffractive components of SBCAs, we consider here the somewhat classical choice of muscovite mica as the dispersing element. We find that the various harmonics of a highest‐quality mica‐based SBCA show ~5–~40% of the integral reflectivity per unit solid angle of a typical Si or Ge SBCA in the hard X‐ray range, and that the mica SBCA have comparable energy resolution to the traditional SBCAs. Interestingly, the choice of mica comes with a practical benefit: the primary (0,0,2) reflection has sufficiently strong harmonics that are fairly tightly spaced in energy so that they span the complete energy range from ~4 to ~11 keV when used at convenient Bragg angles in a Rowland circle spectrometer. Hence, a single mica SBCA can be used for every K‐shell emission line of three dimensional transition metals and every L‐shell emission line of the lanthanide elements simply by selecting the correct mica (0,0,2) harmonic with a final energy‐dispersive solid state detector. The loss in efficiency is counteracted by an operational efficiency, i.e., the “universal” application of a single analyzer over a very large range of elements. This performance suggests future application of mica SBCAs in both laboratory‐based XES and synchrotron‐based photon‐in, photon‐out spectroscopies in the hard X‐ray range.more » « less
-
Abstract Tin monochalcogenides SnS and SnSe, belonging to a family of Van der Waals crystals isoelectronic to black phosphorus, are known as environmentally friendly materials promising for thermoelectric conversion applications. However, they exhibit other desired functionalities, such as intrinsic linear dichroism of the optical and electronic properties originating from strongly anisotropic orthorhombic crystal structures. This property makes them perfect candidates for polarization‐sensitive photodetectors working in near‐infrared spectral range. A comprehensive study of the SnS and SnSe crystals is presented, performed by means of optical spectroscopy and photoemission spectroscopy, supported by ab initio calculations. The studies reveal the high sensitivity of the optical response of both materials to the incident light polarization, which is interpreted in terms of the electronic band dispersion and orbital composition of the electronic bands, dictating the selection rules. From the photoemission investigation the ionization potential, electron affinity and work function are determined, which are parameters crucial for the design of devices based on semiconductor heterostructures.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1039/D3JA00053B
