- Award ID(s):
- 1719875
- NSF-PAR ID:
- 10411665
- Date Published:
- Journal Name:
- Sustainable Energy & Fuels
- Volume:
- 6
- Issue:
- 24
- ISSN:
- 2398-4902
- Page Range / eLocation ID:
- 5474 to 5490
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
Effect of Acidic Hydrochar on Plastic Crude Oil Produced from Hydrothermal Liquefaction of Waste PVCIn this study, the effect of hydrothermal liquefaction (HTL) of waste PVC was investigated in the presence of acidic hydrochar. The hydrochar was prepared by hydrothermal carbonization of pineapple waste at 250 °C and at 1 h in the presence of citric acid. Hydrochar was acidic, stable, and porous and contained acidic functional groups. Hydrochar was co-fed with PVC during HTL to enhance HTL conversion and quality of the plastic crude oil. HTL experiments were performed at 300–350 °C, 0.25–4 h of reaction times, and 0–20 wt% hydrochar-to-PVC ratio. The plastic crude oil was separated from the solid residue to evaluate HTL conversion and to analyze elemental compositions, boiling point distribution, alteration of chemical bonds, and chemical compositions. The results showed that acidic hydrochar enhances HTL conversion with a maximum value of 28.75 at 5 wt% hydrochar content at 350 °C and 0.5 h. Furthermore, plastic crude oils contained no chloride but contained significantly high carbon and hydrogen, resulting in a higher heating value of up to 36.43 MJ/kg. The major component of the plastic crude oil was 3, 5 dimethylphenol produced ranging from 61.4 to 86.4% (percentage of total identified area) according to gas chromatography mass spectroscopy (GCMS) data.more » « less
-
Valorization of agricultural and food waste digestates is crucial for sustainable waste management to reduce environmental impacts and improve the economics of commercial farms. Hydrothermal liquefaction (HTL) of anaerobic digestates was evaluated to recover resources by converting them into carbon-dense biocrude oil and a nutrient-rich HTL aqueous phase (HTL-AP) coproduct. The effects of HTL temperature (280–360 °C), reaction time (10–50 min), feedstock pH (2.5–8.5), digestate salt content (1–5 wt%), and digestate cellulose-to-lignin ratio (0.2–1.8) on energy and nutrient recovery were systematically investigated in a set of well-designed experiments following a half-fractional central composite protocol. Response surface analysis combined with HTL product characterization and comparative literature study produced a comprehensive reaction pathway for HTL of anaerobic digestates. Moreover, this analysis revealed the importance of acidic feedstocks (pH 3.00–5.53), high reaction temperatures (337–360 °C), and reaction times <45 or 45–50 min for digestates with Cel/Lig >1 or <1, for maximizing the energy recovered in biocrude (high carbon yield and low heteroatom content) and the amounts of P, NH 3 –N, and Mg distributed in the HTL-AP. Acidic conditions catalyzed biocrude production, inhibited the Maillard reaction (lowering the nitrogen content in biocrude), and partitioned nutrients into the HTL-AP. Higher reaction temperatures coupled with longer reaction times activated hydro-denitrogenation and deoxygenation reactions to improve biocrude quality. This work provides not only validated methods to achieve targeted resource recovery for specific feedstock compositions using HTL, but also a comprehensive mechanistic understanding of the HTL of biomass waste for controlling target product characteristics.more » « less
-
Rauch, W Liu (Ed.)Water contamination by nitrogen and phosphorus ions has a direct consequence of eutrophication to the ecosystem. The objective of this study is to investigate the production of hydrochars by acetic acid or sodium hydroxide assisted hydrothermal carbonization (HTC), various activation methods, and the potential of hydrochar as an adsorbent to remove NH4+-N and PO43--P from wastewater. The results showed that acetic acid or sodium hydroxide assisted HTC and activation with magnesium chloride or air could improve the surface properties of hydrochar. Acetic acid modification generated extensive oxygenated functional groups, while sodium hydroxide modification produced hydrochar with a high N/C ratio and surface aromaticity. Treating hydrochar with magnesium chloride could impregnate nano-magnesium particles on the hydrochar, thereby improving the ability to remove N and P. Air activation of hydrochar resulted in more oxygen containing functional groups. The NH4+-N and PO43--P adsorption capacities of these hydrochars ranged from 92.6 to 122.4mg/g and 1.6 to 15.8mg/g, respectively. The adsorption capacity of hydrochars in swine wastewater is similar to the results of artificial wastewater. The results suggested that Mg-nanoparticle dispersion and oxygen-containing functional groups played a major role in adsorption than ion exchange and physisorption.more » « less
-
Rauch, Wolfgang ; null (Ed.)Water contamination by nitrogen and phosphorus ions has a direct consequence of eutrophication to the ecosystem. The objective of this study is to investigate the production of hydrochars by acetic acid or sodium hydroxide assisted hydrothermal carbonization (HTC), various activation methods, and the potential of hydrochar as an adsorbent to remove NH4+-N and PO43−-P from wastewater. The results showed that acetic acid or sodium hydroxide assisted HTC and activation with magnesium chloride or air could improve the surface properties of hydrochar. Acetic acid modification generated extensive oxygenated functional groups, while sodium hydroxide modification produced hydrochar with a high N/C ratio and surface aromaticity. Treating hydrochar with magnesium chloride could impregnate nano-magnesium particles on the hydrochar, thereby improving the ability to remove N and P. Air activation of hydrochar resulted in more oxygen containing functional groups. The NH4+-N and PO43−-P adsorption capacities of these hydrochars ranged from 92.6 to 122.4mg/g and 1.6 to 15.8mg/g, respectively. The adsorption capacity of hydrochars in swine wastewater is similar to the results of artificial wastewater. The results suggested that Mg-nanoparticle dispersion and oxygen-containing functional groups played a major role in adsorption than ion exchange and physisorption.more » « less
-
Abstract Producing hydrochar from landfill municipal solid wastes (MSW) is a sustainable alternative to existing waste management practices in low‐ and middle‐income countries. In this study, mixed MSW feedstock (sent for landfilling) was subjected to hydrothermal carbonization to produce hydrochars. The hydrochar showing the highest heating value was subjected to pyrolysis at 5, 10, and 20 K min−1heating rates. Based on the pyrolysis characteristics, a three pseudo‐component‐based distributed activation energy model was employed to describe the pyrolysis kinetics. The activation energy distributions for the three pseudo‐components were 140 ± 8.7 kJ mol−1, 190 ± 1 kJ mol−1and 175.9 ± 24.9 kJ mol−1, which were able to predict the pyrolysis profile at all heating rates with
R 2 > 0.999. Differential thermogravimetric profiles of the hydrochar revealed its pyrolytic reactivity to resemble lignocellulosic constituents. Fourier‐transform infrared analysis of the hydrochar showed retention of oxygen‐containing functional groups (associated with lignocellulosic constituents) from the parent feedstock. © 2022 Society of Chemical Industry and John Wiley & Sons, Ltd.