skip to main content
US FlagAn official website of the United States government
dot gov icon
Official websites use .gov
A .gov website belongs to an official government organization in the United States.
https lock icon
Secure .gov websites use HTTPS
A lock ( lock ) or https:// means you've safely connected to the .gov website. Share sensitive information only on official, secure websites.

Explore Research Products in the PAR
It may take a few hours for recently added research products to appear in PAR search results.


  • NSF Public Access
  • Search Results
  • Michelson Interferometer for Global High-Resolution Thermospheric Imaging (MIGHTI) On-Orbit Wind Observations: Data Analysis and Instrument Performance
Title: Michelson Interferometer for Global High-Resolution Thermospheric Imaging (MIGHTI) On-Orbit Wind Observations: Data Analysis and Instrument Performance
Abstract The design, principles of operation, calibration, and data analysis approaches of the Michelson Interferometer for Global High-resolution Thermospheric Imaging (MIGHTI) on the NASA Ionospheric Connection (ICON) satellite have been documented prior to the ICON launch. Here we update and expand on the MIGHTI wind data analysis and discuss the on-orbit instrument performance. In particular, we show typical raw data and we describe key processing steps, including the correction of a “signal-intensity dependent phase shift,” which is necessitated by unexpected detector behavior. We describe a new zero-wind calibration approach that is preferred over the originally planned approach due to its higher precision. Similar to the original approach, the new approach is independent of any a priori data. A detailed update on the wind uncertainties is provided and compared to the mission requirements, showing that MIGHTI has met the ICON mission requirements. While MIGHTI observations are not required to produce absolute airglow brightness profiles, we describe a relative brightness profile product, which is included in the published data. We briefly review the spatial resolution of the MIGHTI wind data in addition to the data coverage and data gaps that occurred during the nominal mission. Finally, we include comparisons of the MIGHTI wind data with ground-based Fabry-Perot interferometer observations and meteor radar observations, updating previous studies with more recent data, again showing good agreement. The data processing steps covered in this work and all the derived wind data correspond to the MIGHTI data release Version 5 (v05).  more » « less
Award ID(s):
1933077
PAR ID:
10442770
Author(s) / Creator(s):
; ; ; ; ; ; ; ; ;
Date Published:
Journal Name:
Space Science Reviews
Volume:
219
Issue:
3
ISSN:
0038-6308
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. ; ; ; ; ; ; ; ; ; ; et al (, Space Science Reviews)
    Abstract The Michelson Interferometer for Global High-resolution Thermospheric Imaging (MIGHTI) was launched aboard NASA’s Ionospheric Connection (ICON) Explorer satellite in October 2019 to measure winds and temperatures on the limb in the upper mesosphere and lower thermosphere (MLT). Temperatures are observed using the molecular oxygen atmospheric band near 763 nm from 90–127 km altitude in the daytime and 90–108 km in the nighttime. Here we describe the measurement approach and methodology of the temperature retrieval, including unique on-orbit operations that allow for a better understanding of the instrument response. The MIGHTI measurement approach for temperatures is distinguished by concurrent observations from two different sensors, allowing for two self-consistent temperature products. We compare the MIGHTI temperatures against existing MLT space-borne and ground-based observations. The MIGHTI temperatures are within 7 K of these observations on average from 90–95 km throughout the day and night. In the daytime on average from 99–105 km, MIGHTI temperatures are higher than coincident observations by the Sounding of the Atmosphere using Broadband Emission Radiometry (SABER) instrument on NASA’s TIMED satellite by 18 K. Because the difference between the MIGHTI and SABER observations is predominantly a constant bias at a given altitude, conclusions of scientific analyses that are based on temperature variations are largely unaffected. 
    more » « less
  2. ; ; ; ; ; ; ; ; ; ; et al (, Journal of Geophysical Research: Space Physics)
    Abstract Midlatitude thermospheric wind observations from the Michelson Interferometer for Global High‐resolution Thermospheric Imaging on board the Ionospheric Connections Explorer (ICON/MIGHTI) and from the ground‐based Boulder, Urbana, Millstone Hill and Morocco Fabry‐Perot interferometers (FPIs) are used to study a distinct solar local time (SLT) evolution in the nighttime wind field around the December solstice period. Our results show, to the best of our knowledge for the first time, strong non‐migrating tides in midlatitude thermospheric winds using coincident from different observing platforms. These observations exhibited a structure of strong (∼50–150 m/s) eastward and southward winds in the pre‐midnight sector (20:00–23:00 SLT) and in the post‐midnight sector (02:00–03:00 SLT), with a strong suppression around midnight. Tidal analysis of ICON/MIGHTI data revealed that the signature before midnight was driven by diurnal (D0, DE1, DE2, DW2) and semidiurnal (SE2, SE3, SW1, SW4) tides, and that strong terdiurnal (TE2, TW1, TW2, TW5) and quatradiurnal (QW2, QW3, QW6) tides were important contributors in the mid‐ and post‐midnight sectors. ICON/MIGHTI tidal reconstructions successfully reproduced the salient structures observed by the FPI and showed a longitudinal dual‐peak variation with peak magnitudes around 200°–120°W and 30°W–60°E. The signature of the structure extended along the south‐to‐north direction from lower latitudes, migrated to earlier local times with increasing latitude, and strengthened above 30°N. Tidal analysis using historical FPI data revealed that these structures were often seen during previous December solstices, and that they are much stronger for lower solar flux conditions, consistent with an upward‐propagating tidal origin. 
    more » « less
  3. ; ; (, Journal of Geophysical Research: Space Physics)
    Abstract The statistics of day‐to‐day tidal variability within 35‐day running mean windows is obtained from Michelson Interferometer for Global High‐Resolution Thermospheric Imaging (MIGHTI)/Ionospheric Connection Explorer (ICON) observations in the 90–107 km height region for the year 2020. Temperature standard deviations for 18 diurnal and semidiurnal tidal components, and for four quasi‐stationary planetary waves are presented, as function of latitude, altitude, and day‐of‐year. Our results show that the day‐to‐day variability (DTDV) can be as large as 70% of the monthly mean amplitudes, thus providing a significant source of variability for the ionospheric E‐region dynamo and hence for the F‐region plasma. We further validate our results with COSMIC‐2 ionospheric observations and present an approach to extend the MIGHTI/ICON results to all latitudes using Hough Mode Extension fitting, to produce global tidal fields and their statistical DTDV that are suitable as lower boundary conditions for nudging and ensemble modeling of TIE‐GCM. In the future, this will likely help to establish a data‐driven perspective of space weather variability caused by the tidal weather of the lower atmosphere. 
    more » « less
  4. ; ; ; ; ; ; ; (, Geophysical Research Letters)
    Abstract Meteor radar observations provide wind data ranging from 80 to 100 km altitude, while the Michaelson Interferometer for Global High‐resolution Thermospheric Imaging (MIGHTI) onboard the Ionospheric Connection Explorer satellite offers wind data above 90 km altitude. This study aims to generate wind profiles in the mesosphere and lower thermosphere by combining the winds derived from meteor radar and MIGHTI observations over the Korean Peninsula from January 2020 to December 2021. The wind profiles derived from the two instruments are continuous at night, but they show discrepancies during the day. The atomic oxygen 557.7 nm (green line) emission intensity measured by MIGHTI peaks at approximately 100 km during the day and 94 km at night. The vertical gradient of the airglow volume emission rate is more pronounced during the day. These differences can cause day‐night differences in the MIGHTI wind retrieval accuracy, potentially leading to discrepancies during the day. 
    more » « less
  5. ; ; ; ; ; ; ; (, Journal of Geophysical Research: Space Physics)
    Abstract The moving solar terminator (ST) generates atmospheric disturbances, broadly termed solar terminator waves (STWs). Despite theoretically recurring daily, STWs remain poorly understood, partially due to measurement challenges near the ST. Analyzing Michelson Interferometer for Global High‐resolution Thermospheric Imaging (MIGHTI) data from NASA's Ionospheric Connection Explorer (ICON) observatory, we present observations of STW signatures in thermospheric neutral winds, including the first reported meridional wind signatures. Seasonal analysis reveals STWs are most prominent during solstices, when they intersect the ST about ∼20° latitude from the equator in the winter hemisphere and have phase fronts inclined at a ∼40° angle to the ST. We also provide the first observed STW altitude profiles, revealing large vertical wavelengths above 200 km. Comparing these observations to four different models suggests the STWs likely originate directly or indirectly from waves from below 97 km. STWs may play an under‐recognized role in the daily variability of the thermosphere‐ionosphere system, warranting further study. 
    more » « less
  • Citation Formats
  • MLA
  • APA
  • Chicago
  • BibTeX
  • Save / Share this Record
  • Send to Email