An official website of the United States government
Abstract The Michelson Interferometer for Global High-resolution Thermospheric Imaging (MIGHTI) was launched aboard NASA’s Ionospheric Connection (ICON) Explorer satellite in October 2019 to measure winds and temperatures on the limb in the upper mesosphere and lower thermosphere (MLT). Temperatures are observed using the molecular oxygen atmospheric band near 763 nm from 90–127 km altitude in the daytime and 90–108 km in the nighttime. Here we describe the measurement approach and methodology of the temperature retrieval, including unique on-orbit operations that allow for a better understanding of the instrument response. The MIGHTI measurement approach for temperatures is distinguished by concurrent observations from two different sensors, allowing for two self-consistent temperature products. We compare the MIGHTI temperatures against existing MLT space-borne and ground-based observations. The MIGHTI temperatures are within 7 K of these observations on average from 90–95 km throughout the day and night. In the daytime on average from 99–105 km, MIGHTI temperatures are higher than coincident observations by the Sounding of the Atmosphere using Broadband Emission Radiometry (SABER) instrument on NASA’s TIMED satellite by 18 K. Because the difference between the MIGHTI and SABER observations is predominantly a constant bias at a given altitude, conclusions of scientific analyses that are based on temperature variations are largely unaffected.
more »
« less
Vertical Wind Profiles in the Mesosphere and Lower Thermosphere Driven by Meteor Radar and Ionospheric Connection Explorer Observations Over the Korean Peninsula
Abstract Meteor radar observations provide wind data ranging from 80 to 100 km altitude, while the Michaelson Interferometer for Global High‐resolution Thermospheric Imaging (MIGHTI) onboard the Ionospheric Connection Explorer satellite offers wind data above 90 km altitude. This study aims to generate wind profiles in the mesosphere and lower thermosphere by combining the winds derived from meteor radar and MIGHTI observations over the Korean Peninsula from January 2020 to December 2021. The wind profiles derived from the two instruments are continuous at night, but they show discrepancies during the day. The atomic oxygen 557.7 nm (green line) emission intensity measured by MIGHTI peaks at approximately 100 km during the day and 94 km at night. The vertical gradient of the airglow volume emission rate is more pronounced during the day. These differences can cause day‐night differences in the MIGHTI wind retrieval accuracy, potentially leading to discrepancies during the day.
more »
« less
- Award ID(s):
- 2029840
- PAR ID:
- 10562329
- Publisher / Repository:
- American Geophysical Union
- Date Published:
- Journal Name:
- Geophysical Research Letters
- Volume:
- 51
- Issue:
- 4
- ISSN:
- 0094-8276
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract The design, principles of operation, calibration, and data analysis approaches of the Michelson Interferometer for Global High-resolution Thermospheric Imaging (MIGHTI) on the NASA Ionospheric Connection (ICON) satellite have been documented prior to the ICON launch. Here we update and expand on the MIGHTI wind data analysis and discuss the on-orbit instrument performance. In particular, we show typical raw data and we describe key processing steps, including the correction of a “signal-intensity dependent phase shift,” which is necessitated by unexpected detector behavior. We describe a new zero-wind calibration approach that is preferred over the originally planned approach due to its higher precision. Similar to the original approach, the new approach is independent of any a priori data. A detailed update on the wind uncertainties is provided and compared to the mission requirements, showing that MIGHTI has met the ICON mission requirements. While MIGHTI observations are not required to produce absolute airglow brightness profiles, we describe a relative brightness profile product, which is included in the published data. We briefly review the spatial resolution of the MIGHTI wind data in addition to the data coverage and data gaps that occurred during the nominal mission. Finally, we include comparisons of the MIGHTI wind data with ground-based Fabry-Perot interferometer observations and meteor radar observations, updating previous studies with more recent data, again showing good agreement. The data processing steps covered in this work and all the derived wind data correspond to the MIGHTI data release Version 5 (v05).more » « less
-
null (Ed.)The ShUREX (Shigaraki UAV Radar Experiment) 2015 campaign carried out at the Shigaraki Middle and Upper atmosphere (MU) observatory (Japan) in June 2015 provided a unique opportunity to compare vertical profiles of atmospheric parameters estimated from unmanned aerial vehicle (UAV), balloon, and radar data in the lower troposphere. The present work is intended primarily as a demonstration of the potential offered by combination of these three instruments for studying the small-scale structure and dynamics in the lower troposphere. Here, we focus on data collected almost simultaneously by two instrumented UAVs and two meteorological balloons, near the MU radar operated continuously during the campaign. The UAVs flew along helical ascending and descending paths at a nearly constant horizontal distance from the radar (~ 1.0 km), while the balloons launched from the MU radar site drifted up to ~ 3–5 km in the altitude range of comparisons (~ 0.5 to 4.0 km) due to wind advection. Vertical profiles of squared Brünt-Väisälä frequency N2 and squared vertical gradient of generalized potential refractive index M2 were estimated at a vertical resolution of 20 m from pressure, temperature, and humidity data collected by UAVs and radiosondes. Profiles of M2 were also estimated from MU radar echo power at vertical incidence at a vertical sampling of 20 m and various time resolutions (1–4 min). The balloons and the MU radar provided vertical profiles of wind and wind shear S so that two independent estimates of the gradient Richardson number (Ri = N2/S2) could be obtained at a range resolution of 150 m. The two estimates of Ri profiles also showed remarkable agreement at all altitudes. We show that all three instruments detected the same prominent temperature and humidity gradients, down to decameter scales in stratified conditions. These gradients extended horizontally over a few kilometers at least and persisted for hours without significant changes, indicating that the turbulent diffusion was weak. Large discrepancies between N2and M2 profiles derived from the balloon, UAV, and radar data were found in a turbulent layer generated by a Kelvin-Helmholtz (KH) shear flow instability in the height range from 1.80 to 2.15 km. The cause of these discrepancies appears to depend on the stage of the KH billows.more » « less
-
Abstract The moving solar terminator (ST) generates atmospheric disturbances, broadly termed solar terminator waves (STWs). Despite theoretically recurring daily, STWs remain poorly understood, partially due to measurement challenges near the ST. Analyzing Michelson Interferometer for Global High‐resolution Thermospheric Imaging (MIGHTI) data from NASA's Ionospheric Connection Explorer (ICON) observatory, we present observations of STW signatures in thermospheric neutral winds, including the first reported meridional wind signatures. Seasonal analysis reveals STWs are most prominent during solstices, when they intersect the ST about ∼20° latitude from the equator in the winter hemisphere and have phase fronts inclined at a ∼40° angle to the ST. We also provide the first observed STW altitude profiles, revealing large vertical wavelengths above 200 km. Comparing these observations to four different models suggests the STWs likely originate directly or indirectly from waves from below 97 km. STWs may play an under‐recognized role in the daily variability of the thermosphere‐ionosphere system, warranting further study.more » « less
-
Abstract We study the dynamical and thermal roles of internal gravity waves generated in the troposphere and above using the Coupled Middle Atmosphere Thermosphere‐2 General Circulation Model. This model incorporates the whole atmosphere nonlinear spectral gravity wave parameterization and its extension to include non‐tropospheric sources. We conducted model experiments for northern summer solstice conditions, first including only tropospheric sources, then including sources localized at 50 and 90 km, and uniformly distributed over all heights. The simulated differences in mean temperature and horizontal winds demonstrate that gravity waves produce the greatest dynamical and thermal changes in the latter case compared to the localized sources. While the gravity wave drag is longitudinally uniform in the lower thermosphere, it is more localized in the upper thermosphere in all the simulations. Waves from uniformly distributed sources increase the longitudinal variability of zonal winds in the thermosphere up to 150 km. Gravity wave effects exhibit different local time variations in the lower thermosphere (100–140 km) than in the upper thermosphere. In the upper thermosphere, gravity wave effects are stronger during the day than at night. In contrast, nighttime gravity wave effects are stronger than the daytime ones in the lower thermosphere. Finally, a comparison with ICON‐MIGHTI observations shows that the model reproduces the basic structure of thermospheric winds, performing better with zonal winds than with meridional winds. Adding non‐tropospheric wave sources modifies wind structures in wave‐breaking regions, but does not improve the global statistical comparison.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript
- Journal Article:
- https://doi.org/10.1029/2023GL106450
