An official website of the United States government
Abstract Electrochemical intercalation can enable lithium extraction from dilute water sources. However, during extraction, co-intercalation of lithium and sodium ions occurs, and the response of host materials to this process is not fully understood. This aspect limits the rational materials designs for improving lithium extraction. Here, to address this knowledge gap, we report one-dimensional (1D) olivine iron phosphate (FePO 4 ) as a model host to investigate the co-intercalation behavior and demonstrate the control of lithium selectivity through intercalation kinetic manipulations. Via computational and experimental investigations, we show that lithium and sodium tend to phase separate in the host. Exploiting this mechanism, we increase the sodium-ion intercalation energy barrier by using partially filled 1D lithium channels via non-equilibrium solid-solution lithium seeding or remnant lithium in the solid-solution phases. The lithium selectivity enhancement after seeding shows a strong correlation with the fractions of solid-solution phases with high lithium content (i.e., Li x FePO 4 with 0.5 ≤ x < 1). Finally, we also demonstrate that the solid-solution formation pathway depends on the host material’s particle morphology, size and defect content.
more »
« less
The Effect of Mechanical Strain on Lithium Staging in Graphene
Abstract The development of next‐generation electrodes for metal‐ion batteries requires an understanding of intercalation dynamics in nanomaterials. Herein, it is shown that microscale mechanical strain significantly affects the formation of ordered lithium phases in graphene. In situ Raman spectroscopy of graphene microflakes mechanically constrained at the edge during lithium intercalation reveals a thickness‐dependent increase of up to 1.26 V in the electrochemical potential that induces lithium staging. While the induced mechanical strain energy increases with graphene thickness to the fourth power, its magnitude is small compared to the observed increase in electrochemical energy. It is hypothesized that the mechanical strain energy increases a nucleation barrier for lithium staging, greatly delaying the formation of ordered lithium phases. These results indicate that electrode assembly may critically impact lithium staging dynamics. The present work demonstrates strain engineering in two dimensional (2D) nanomaterials as an effective approach to manipulate phase transitions and chemical reactivity.
more »
« less
- Award ID(s):
- 1749742
- PAR ID:
- 10453887
- Publisher / Repository:
- Wiley Blackwell (John Wiley & Sons)
- Date Published:
- Journal Name:
- Advanced Electronic Materials
- Volume:
- 7
- Issue:
- 3
- ISSN:
- 2199-160X
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Porous graphene and graphite are increasingly utilized in electrochemical energy storage and solar-thermal applications due to their unique structural and thermal properties. In this study, we conduct a comprehensive analysis of the lattice thermal transport and spectral phonon characteristics of holey graphite and multilayer graphene. Our results reveal that phonon modes propagating obliquely with respect to the graphene basal planes are the primary contributors to cross-plane thermal transport. These modes exhibit a predominantly ballistic nature, resulting in an almost linear increase in cross-plane thermal conductivity with the number of layers. The presence of nanoholes in graphene induces a broadband suppression of cross-plane phonon transport, whereas lithium-ion intercalation shows potential to enhance it. These findings provide critical insights into the mechanisms governing cross-plane heat conduction in key graphene-based structures, offering valuable guidance for thermal management and engineering of van der Waals materials.more » « less
-
Abstract Solid‐state batteries (SSBs), utilizing a lithium metal anode, promise to deliver enhanced energy and power densities compared to conventional lithium‐ion batteries. Penetration of lithium filaments through the solid‐state electrolytes (SSEs) during electrodeposition poses major constraints on the safety and rate performance of SSBs. While microstructural attributes, especially grain boundaries (GBs) within the SSEs are considered preferential metal propagation pathways, the underlying mechanisms are not fully understood yet. Here, a comprehensive insight is presented into the mechanistic interactions at the mesoscale including the electrochemical‐mechanical response of the GB‐electrode junction and competing ion transport dynamics in the SSE. Depending on the GB transport characteristics, a highly non‐uniform electrodeposition morphology consisting of either cavities or protrusions at the GB‐electrode interface is identified. Mechanical stability analysis reveals localized strain ramps in the GB regions that can lead to brittle fracture of the SSE. For ionically less conductive GBs compared to the grains, a crack formation and void filling mechanism, triggered by the heterogeneous nature of electrochemical‐mechanical interactions is delineated at the GB‐electrode junction. Concurrently, in situ X‐ray tomography of pristine and failed Li7La3Zr2O12(LLZO) SSE samples confirm the presence of filamentous lithium penetration and validity of the proposed mesoscale failure mechanisms.more » « less
-
Abstract Intercalation pseudocapacitance has emerged as a promising energy storage mechanism that combines the energy density of intercalation materials with the power density of capacitors. Niobium pentoxide was the first material described as exhibiting intercalation pseudocapacitance. The electrochemical kinetics for charging/discharging this material are surface‐limited for a wide range of conditions despite intercalation via diffusion. Investigations of niobium pentoxide nanostructures are diverse and numerous; however, none have yet compared performance while adjusting a single architectural parameter at a time. Such a comparative approach reduces the reliance on models and the associated assumptions when seeking nanostructure–property relationships. Here, a tailored isomorphic series of niobium pentoxide nanostructures with constant pore size and precision tailored wall thickness is examined. The sweep rate at which niobium pentoxide transitions from being surface‐limited to being diffusion‐limited is shown to depend sensitively upon the nanoscale dimensions of the niobium pentoxide architecture. Subsequent experiments probing the independent effects of electrolyte concentration and film thickness unambiguously identify solid‐state lithium diffusion as the dominant diffusion constraint even in samples with just 48.5–67.0 nm thick walls. The resulting architectural dependencies from this type of investigation are critical to enable energy‐dense nanostructures that are tailored to deliver a specific power density.more » « less
-
Abstract The phase transitions of two-dimensional (2D) materials are key to the operation of many devices with applications including energy storage and low power electronics. Nanoscale confinement in the form of reduced thickness can modulate the phase transitions of 2D materials both in their thermodynamics and kinetics. Here, using in situ Raman spectroscopy we demonstrate that reducing the thickness of MoS 2 below five layers slows the kinetics of the phase transition from 2H- to 1T′-MoS 2 induced by the electrochemical intercalation of lithium. We observe that the growth rate of 1T′ domains is suppressed in thin MoS 2 supported by SiO 2 , and attribute this growth suppression to increased interfacial effects as the thickness is reduced below 5 nm. The suppressed kinetics can be reversed by placing MoS 2 on a 2D hexagonal boron nitride ( h BN) support, which readily facilitates the release of strain induced by the phase transition. Additionally, we show that the irreversible conversion of intercalated 1T′-MoS 2 into Li 2 S and Mo is also thickness-dependent and the stability of 1T′-MoS 2 is significantly increased below five layers, requiring a much higher applied electrochemical potential to break down 1T′-MoS 2 into Li 2 S and Mo nanoclusters.more » « less
