An official website of the United States government
Abstract Reservoir operations for gas extraction, fluid disposal, carbon dioxide storage, or geothermal energy production are capable of inducing seismicity. Modeling tools exist for seismicity forecasting using operational data, but the computational costs and uncertainty quantification (UQ) pose challenges. We address this issue in the context of seismicity induced by gas production from the Groningen gas field using an integrated modeling framework, which combines reservoir modeling, geomechanical modeling, and stress-based earthquake forecasting. The framework is computationally efficient thanks to a 2D finite-element reservoir model, which assumes vertical flow equilibrium, and the use of semianalytical solutions to calculate poroelastic stress changes and predict seismicity rate. The earthquake nucleation model is based on rate-and-state friction and allows for an initial strength excess so that the faults are not assumed initially critically stressed. We estimate uncertainties in the predicted number of earthquakes and magnitudes. To reduce the computational costs, we assume that the stress model is true, but our UQ algorithm is general enough that the uncertainties in reservoir and stress models could be incorporated. We explore how the selection of either a Poisson or a Gaussian likelihood influences the forecast. We also use a synthetic catalog to estimate the improved forecasting performance that would have resulted from a better seismicity detection threshold. Finally, we use tapered and nontapered Gutenberg–Richter distributions to evaluate the most probable maximum magnitude over time and account for uncertainties in its estimation. Although we did not formally account for uncertainties in the stress model, we tested several alternative stress models, and found negligible impact on the predicted temporal evolution of seismicity and forecast uncertainties. Our study shows that the proposed approach yields realistic estimates of the uncertainties of temporal seismicity and is applicable for operational forecasting or induced seismicity monitoring. It can also be used in probabilistic traffic light systems.
more »
« less
Earthquake Nucleation Characteristics Revealed by Seismicity Response to Seasonal Stress Variations Induced by Gas Production at Groningen
Abstract Deterministic earthquake prediction remains elusive, but time‐dependent probabilistic seismicity forecasting seems within reach thanks to the development of physics‐based models relating seismicity to stress changes. Difficulties include constraining the earthquake nucleation model and fault initial stress state. Here, we analyze induced earthquakes from the Groningen gas field, where production is strongly seasonal, and seismicity began 3 decades after production started. We use the seismicity response to stress variations to constrain the earthquake nucleation process and calibrate models for time‐dependent forecasting of induced earthquakes. Remarkable agreements of modeled and observed seismicity are obtained when we consider (a) the initial strength excess, (b) the finite duration of earthquake nucleation, and (c) the seasonal variations of gas production. We propose a novel metric to quantify the nucleation model's ability to capture the damped amplitude and the phase of the seismicity response to short‐timescale (seasonal) stress variations which allows further tightening the model's parameters.
more »
« less
- Award ID(s):
- 1822214
- PAR ID:
- 10468870
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Geophysical Research Letters
- Volume:
- 50
- Issue:
- 19
- ISSN:
- 0094-8276
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Gas extraction from the Groningen gas field resulted in significant induced seismicity. We analyze the magnitude‐frequency distribution of these earthquakes in space, time and in view of stress changes calculated based on gas production and reservoir properties. Previous studies suggested variations related to reservoir geometry and stress. While we confirm the spatial variations, we do not detect a clear sensitivity of b‐value to Coulomb stress changes. However, we find that b‐value correlates positively with the rate of Coulomb stress changes. This correlation is statistically significant and robust to uncertainties related to stress change calculation. This study thus points to a possible influence of stress change rate on the probability of the magnitude of induced earthquakes.more » « less
-
Abstract We investigate the relative importance of injection and production on the spatial‐temporal distribution of induced seismicity at the Raft River geothermal field. We use time‐series of InSAR measurements to document surface deformation and calibrate a hydro‐mechanical model to estimate effective stress changes imparted by injection and production. Seismicity, located predominantly in the basement, is induced primarily by poroelastic stresses from cold water reinjection into a shallower reservoir. The poroelastic effect of production from a deeper reservoir is minimal and inconsistent with observed seismicity, as is pore‐pressure‐diffusion in the basement and along reactivated faults. We estimate an initial strength excess of ∼20 kPa in the basement and sedimentary cover, but the seismicity rate in the sedimentary cover is four times lower, reflecting lower density of seed‐points for earthquake nucleation. Our modeling workflow could be used to assess the impact of fluid extraction or injection on seismicity and help design or guide operations.more » « less
-
Foreshocks are the most obvious signature of the earthquake nucleation stage and could, in principle, forewarn of an impending earthquake. However, foreshocks are only sometimes observed, and we have a limited understanding of the physics that controls their occurrence. In this work, we use high-resolution earthquake catalogs and estimates of source properties to understand the spatiotemporal evolution of a sequence of 11 foreshocks that occurred ~ 6.5 hours before the 2020 Mw 4.8 Mentone earthquake in west Texas. Elevated pore-pressure and poroelastic stressing from subsurface fluid injection from oil-gas operations is often invoked to explain seismicity in west Texas and the surrounding region. However, here we show that static stresses induced from the initial ML 4.0 foreshock significantly perturbed the local shear stress along the fault and could have triggered the Mentone mainshock. The majority (9/11) of the earthquakes leading up to the Mentone mainshock nucleated in areas where the static shear stresses were increased from the initial ML 4.0 foreshock. The spatiotemporal properties of the 11 earthquakes that preceded the mainshock cannot easily be explained in the context of a preslip or cascade nucleation model. We show that at least 6/11 events are better classified as aftershocks of the initial ML 4.0. Together, our results suggest that a combination of physical mechanisms contributed to the occurrence of the 11 earthquakes that preceded the mainshock, including static-stressing from earthquake-earthquake interactions, aseismic creep, and stress perturbations induced from fluid injection. Our work highlights the role of earthquake-earthquake triggering in induced earthquake sequences, and suggests that such triggering could help sustain seismic activity following initial stressing perturbations from fluid injection.more » « less
-
SUMMARY A number of recent modelling studies of induced seismicity have used the 1994 rate-and-state friction model of Dieterich 1994 to account for the fact that earthquake nucleation is not instantaneous. Notably, the model assumes a population of seismic sources accelerating towards instability with a distribution of initial slip speeds such that they would produce earthquakes steadily in the absence of any perturbation to the system. This assumption may not be valid in typical intraplate settings where most examples of induced seismicity occur, since these regions have low stressing rates and initially low seismic activity. The goal of this paper is twofold. First, to derive a revised Coulomb rate-and-state model, which takes into account that seismic sources can be initially far from instability. Second, to apply and test this new model, called the Threshold rate-and-state model, on the induced seismicity of the Groningen gas field in the Netherlands. Stress changes are calculated based on a model of reservoir compaction since the onset of gas production. We next compare the seismicity predicted by our threshold model and Dieterich’s model with the observations. The two models yields comparable spatial distributions of earthquakes in good agreement with the observations. We find however that the Threshold model provides a better fit to the observed time-varying seismicity rate than Dieterich’s model, and reproduces better the onset, peak and decline of the observed seismicity rate. We compute the maximum magnitude expected for each model given the Gutenberg–Richter distribution and compare to the observations. We find that the Threshold model both shows better agreement with the observed maximum magnitude and provides result consistent with lack of observed seismicity prior to 1993. We carry out analysis of the model fit using a Chi-squared reduced statistics and find that the model fit is dramatically improved by smoothing the seismicity rate. We interpret this finding as possibly suggesting an influence of source interactions, or clustering, on a long timescale of about 3–5 yr.more » « less
