Quantum error correction has recently been shown to benefit greatly from specific physical encodings of the code qubits. In particular, several researchers have considered the individual code qubits being encoded with the continuous variable GottesmanKitaev-Preskill (GKP) code, and then imposed an outer discrete-variable code such as the surface code on these GKP qubits. Under such a concatenation scheme, the analog information from the inner GKP error correction improves the noise threshold of the outer code. However, the surface code has vanishing rate and demands a lot of resources with growing distance. In this work, we concatenate the GKP code with generic quantum low-density parity-check (QLDPC) codes and demonstrate a natural way to exploit the GKP analog information in iterative decoding algorithms. We first show the noise thresholds for two lifted product QLDPC code families, and then show the improvements of noise thresholds when the iterative decoder – a hardware-friendly min-sum algorithm (MSA) – utilizes the GKP analog information. We also show that, when the GKP analog information is combined with a sequential update schedule for MSA, the scheme surpasses the well-known CSS Hamming bound for these code families. Furthermore, we observe that the GKP analog information helps the iterative decoder in escaping harmful trapping sets in the Tanner graph of the QLDPC code, thereby eliminating or significantly lowering the error floor of the logical error rate curves. Finally, we discuss new fundamental and practical questions that arise from this work on channel capacity under GKP analog information, and on improving decoder design and analysis.
more »
« less
This content will become publicly available on December 1, 2024
Autonomous quantum error correction and fault-tolerant quantum computation with squeezed cat qubits
We propose an autonomous quantum error correction scheme using squeezed cat (SC) code against excitation loss in continuous-variable systems. Through reservoir engineering, we show that a structured dissipation can stabilize a two-component SC while autonomously correcting the errors. The implementation of such dissipation only requires low-order nonlinear couplings among three bosonic modes or between a bosonic mode and a qutrit. While our proposed scheme is device independent, it is readily implementable with current experimental platforms such as superconducting circuits and trapped-ion systems. Compared to the stabilized cat, the stabilized SC has a much lower dominant error rate and a significantly enhanced noise bias. Furthermore, the bias-preserving operations for the SC have much lower error rates. In combination, the stabilized SC leads to substantially better logical performance when concatenating with an outer discrete-variable code. The surface-SC scheme achieves more than one order of magnitude increase in the threshold ratio between the loss rate κ1 and the engineered dissipation rate κ2. Under a practical noise ratio κ1/κ2 = 10−3, the repetition-SC scheme can reach a 10−15 logical error rate even with a small mean excitation number of 4, which already suffices for practically useful quantum algorithms.
more »
« less
- Award ID(s):
- 1936118
- NSF-PAR ID:
- 10482882
- Publisher / Repository:
- npj Quantum Information
- Date Published:
- Journal Name:
- npj Quantum Information
- Volume:
- 9
- Issue:
- 1
- ISSN:
- 2056-6387
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
more » « less
Abstract For space-based laser communications, when the mean photon number per received optical pulse is much smaller than one, there is a large gap between communications capacity achievable with a receiver that performs individual pulse-by-pulse detection, and the quantum-optimal “joint-detection receiver” that acts collectively on long codeword-blocks of modulated pulses; an effect often termed “superadditive capacity”. In this paper, we consider the simplest scenario where a large superadditive capacity is known: a pure-loss channel with a coherent-state binary phase-shift keyed (BPSK) modulation. The two BPSK states can be mapped conceptually to two non-orthogonal states of a qubit, described by an inner product that is a function of the mean photon number per pulse. Using this map, we derive an explicit construction of the quantum circuit of a joint-detection receiver based on a recent idea of “belief-propagation with quantum messages” (BPQM). We quantify its performance improvement over the Dolinar receiver that performs optimal pulse-by-pulse detection, which represents the best “classical” approach. We analyze the scheme rigorously and show that it achieves the quantum limit of minimum average error probability in discriminating 8 (BPSK) codewords of a length-5 binary linear code with a tree factor graph. Our result suggests that a BPQM receiver might attain the Holevo capacity of this BPSK-modulated pure-loss channel. Moreover, our receiver circuit provides an alternative proposal for a quantum supremacy experiment, targeted at a specific application that can potentially be implemented on a small, special-purpose, photonic quantum computer capable of performing cat-basis universal qubit logic.
-
A high-speed super-resolution computational imaging technique is introduced on the basis of classical and quantum correlation functions obtained from photon counts collected from quantum emitters illuminated by spatiotemporally structured illumination. The structured illumination is delocalized—allowing the selective excitation of separate groups of emitters as the modulation of the illumination light advances. A recorded set of photon counts contains rich quantum and classical information. By processing photon counts, multiple orders of Glauber correlation functions are extracted. Combinations of the normalized Glauber correlation functions convert photon counts into signals of increasing order that contain increasing spatial frequency information. However, the amount of information above the noise floor drops at higher correlation orders, causing a loss of accessible information in the finer spatial frequency content that is contained in the higher-order signals. We demonstrate an efficient and robust computational imaging algorithm to fuse the spatial frequencies from the low-spatial-frequency range that is available in the classical information with the spatial frequency content in the quantum signals. Because of the overlap of low spatial frequency information, the higher signal-to-noise ratio (SNR) information concentrated in the low spatial frequencies stabilizes the lower SNR at higher spatial frequencies in the higher-order quantum signals. Robust performance of this joint fusion of classical and quantum computational single-pixel imaging is demonstrated with marked increases in spatial frequency content, leading to super-resolution imaging, along with much better mean squared errors in the reconstructed images.more » « less
-
We present the Hybrid Polar Decoder (HyPD), a hybrid classical-quantum decoder design for Polar error correction codes, which are becoming widespread in today’s 5G and tomorrow’s 6G networks. HyPD employs CMOS processing for the Polar decoder’s binary tree traversal, and Quantum Annealing (QA) processing for the Quantum Polar Decoder (QPD)-a Maximum-Likelihood QA-based Polar decoder submodule. QPD’s design efficiently transforms a Polar decoder into a quadratic polynomial optimization form, then maps this polynomial on to the physical QA hardware via QPD-MAP, a customized problem mapping scheme tailored to QPD. We have experimentally evaluated HyPD on a state-of-the-art QA device with 5,627 qubits, for 5G-NR Polar codes with block length of 1,024 bits, in Rayleigh fading channels. Our results show that HyPD outperforms Successive Cancellation List decoders of list size eight by half an order of bit error rate magnitude, and achieves a 1,500-bytes frame delivery rate of 99.1%, at 1 dB signal-to-noise ratio. Further studies present QA compute time considerations. We also propose QPD-HW, a novel QA hardware topology tailored for the task of decoding Polar codes. QPD-HW is sparse, flexible to code rate and block length, and may be of potential interest to the designers of tomorrow’s 6G wireless networks.more » « less
-
more » « less
Recent constructions of quantum low-density parity-check (QLDPC) codes provide optimal scaling of the number of logical qubits and the minimum distance in terms of the code length, thereby opening the door to fault-tolerant quantum systems with minimal resource overhead. However, the hardware path from nearest-neighbor-connection-based topological codes to long-range-interaction-demanding QLDPC codes is likely a challenging one. Given the practical difficulty in building a monolithic architecture for quantum systems, such as computers, based on optimal QLDPC codes, it is worth considering a distributed implementation of such codes over a network of interconnected medium-sized quantum processors. In such a setting, all syndrome measurements and logical operations must be performed through the use of high-fidelity shared entangled states between the processing nodes. Since probabilistic many-to-1 distillation schemes for purifying entanglement are inefficient, we investigate quantum error correction based entanglement purification in this work. Specifically, we employ QLDPC codes to distill GHZ states, as the resulting high-fidelity logical GHZ states can interact directly with the code used to perform distributed quantum computing (DQC), e.g. for fault-tolerant Steane syndrome extraction. This protocol is applicable beyond the application of DQC since entanglement distribution and purification is a quintessential task of any quantum network. We use the min-sum algorithm (MSA) based iterative decoder with a sequential schedule for distilling-qubit GHZ states using a ratefamily of lifted product QLDPC codes and obtain an input fidelity threshold ofunder i.i.d. single-qubit depolarizing noise. This represents the best threshold for a yield offor any GHZ purification protocol. Our results apply to larger size GHZ states as well, where we extend our technical result about a measurement property of-qubit GHZ states to construct a scalable GHZ purification protocol.
