An official website of the United States government
Ferroelectric hafnium-zirconium oxide (HZO) is an excellent candidate for low-power non-volatile memory applications due to its demonstrated ferroelectricity at the nanoscale and compatibility with silicon-based technologies. The interface of HZO in contact with its electrode, typically TiN in a metal–ferroelectric–metal (MFM) capacitor configuration, is of particular interest because factors, such as volume confinement, impurity concentration, interfacial layers, thermal expansion mismatch, and defect trapping, are believed to play a crucial role in the ferroelectric performance of HZO-based devices. Processing variables, such as precursor type, oxygen source, dose duration, and deposition temperature, are known to strongly affect the quality of the oxide–metal interface. However, not many studies have focused on the effect of breaking or maintaining vacuum during MFM deposition. In this study, sequential, no-atmosphere processing (SNAP) is employed to avoid atmospheric exposure, where electrode TiN and ferroelectric HZO are deposited sequentially in the atomic layer deposition chamber without breaking vacuum. The effect of breaking vacuum during the sequential deposition steps is elucidated by fabricating and characterizing MFM capacitors with and without intentional vacuum breaks prior to the deposition of the HZO and top TiN. Using x-ray photoelectron spectroscopy and time-of-flight secondary ion mass spectrometry (ToF-SIMS), we reveal that breaking vacuum after bottom TiN electrode deposition leads to interfacial oxidation and increased carbon contamination, which preferentially stabilizes the non-ferroelectric tetragonal phase and lead to diminished remanent polarization. Avoiding carbon impurities and interfacial TiOx at the HZO and TiN interface using SNAP leads to heightened remanent polarization, reduced leakage current density, and elimination of the wake-up effect. Our work highlights the effect of vacuum breaking on the processing-structure-properties of HZO-based capacitors, revealing that maintaining vacuum can significantly improve ferroelectric properties.
more »
« less
A Comparative Study of n- and p-Channel FeFETs with Ferroelectric HZO Gate Dielectric
This study investigates the electrical characteristics observed in n-channel and p-channel ferroelectric field effect transistor (FeFET) devices fabricated through a similar process flow with 10 nm of ferroelectric hafnium zirconium oxide (HZO) as the gate dielectric. The n-FeFETs demonstrate a faster complete polarization switching compared to the p-channel counterparts. Detailed and systematic investigations using TCAD simulations reveal the role of fixed charges and interface traps at the HZO-interfacial layer (HZO/IL) interface in modulating the subthreshold characteristics of the devices. A characteristic crossover point observed in the transfer characteristics of n-channel devices is attributed with the temporary switching between ferroelectric-based operation to charge-based operation, caused by the pinning effect due to the presence of different traps. This experimental study helps understand the role of charge trapping effects in switching characteristics of n- and p-channel ferroelectric FETs.
more »
« less
- Award ID(s):
- 2123863
- PAR ID:
- 10493950
- Publisher / Repository:
- MDPI Solids
- Date Published:
- Journal Name:
- Solids
- Volume:
- 4
- Issue:
- 4
- ISSN:
- 2673-6497
- Page Range / eLocation ID:
- 356 to 367
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
In this work, hafnium zirconium oxide (HZO)-based 100 × 100 nm2 ferroelectric tunnel junction (FTJ) devices were implemented on a 300 mm wafer platform, using a baseline 65 nm CMOS process technology. FTJs consisting of TiN/HZO/TiN were integrated in between metal 1 (M1) and via 1 (V1) layers. Cross-sectional transmission electron microscopy and energy dispersive x-ray spectroscopy analysis confirmed the targeted thickness and composition of the FTJ film stack, while grazing incidence, in-plane x-ray diffraction analysis demonstrated the presence of orthorhombic phase Pca21 responsible for ferroelectric polarization observed in HZO films. Current measurement, as a function of voltage for both up- and down-polarization states, yielded a tunneling electroresistance (TER) ratio of 2.28. The device TER ratio and endurance behavior were further optimized by insertion of thin Al2O3 tunnel barrier layer between the bottom electrode (TiN) and ferroelectric switching layer (HZO) by tuning the band offset between HZO and TiN, facilitating on-state tunneling conduction and creating an additional barrier layer in off-state current conduction path. Investigation of current transport mechanism showed that the current in these FTJ devices is dominated by direct tunneling at low electric field (E < 0.4 MV/cm) and by Fowler–Nordheim (F–N) tunneling at high electric field (E > 0.4 MV/cm). The modified FTJ device stack (TiN/Al2O3/HZO/TiN) demonstrated an enhanced TER ratio of ∼5 (2.2× improvement) and endurance up to 106 switching cycles. Write voltage and pulse width dependent trade-off characteristics between TER ratio and maximum endurance cycles (Nc) were established that enabled optimal balance of FTJ switching metrics. The FTJ memory cells also showed multi-level-cell characteristics, i.e., 2 bits/cell storage capability. Based on full 300 mm wafer statistics, a switching yield of >80% was achieved for fabricated FTJ devices demonstrating robustness of fabrication and programming approach used for FTJ performance optimization. The realization of CMOS-compatible nanoscale FTJ devices on 300 mm wafer platform demonstrates the promising potential of high-volume large-scale industrial implementation of FTJ devices for various nonvolatile memory applications.more » « less
-
We experimentally demonstrate the heterogeneous integration of ferroelectric hafnium zirconium oxide (HZO) with a silicon photonic microring resonator and demonstrate two non-volatile states for data storage by switching the polarization of HZO. Capped by transparent conducting titanium doped indium oxide (ITiO), the device functions as a metal insulator semiconductor (MIS) capacitor and utilizes the refractive index modulation via carrier (hole) accumulation and the effect of trapped charges at the ferroelectric–silicon interface to create the non-volatile binary switching states. In contrast to electronic devices where trapped charges at the silicon–ferroelectric interface reduce the memory window, in our ferrophotonic device, trapped charges amplify the refractive index difference in the binary states due to effective screening of the silicon in inversion. By switching the applied bias from negative to positive, the optical power transmitted through the ring switches with 3.5 dB output power difference between the non-volatile set and reset states and 40 pJ switching energy at ±8 V. Preliminary results suggest a path toward achieving sub-1 V non-volatile ferrophotonic switching.more » « less
-
In this work, we investigate the device-to-device variations in the remanent polarization of metal–ferroelectric–insulator–metal stacks based on ferroelectric hafnium–zirconium–oxide (HZO). Our study employs a 3D dynamic multi-grain phase-field model to consider the effects of the polycrystalline nature of HZO in conjunction with the multi-domain polarization switching. We explore the dependence of variations on various design factors, such as the ferroelectric thickness and voltage stimuli (set voltage, pulse amplitude, and width), and correlate the trends to the underlying polarization switching mechanisms. Our analysis reveals a non-monotonic dependence of variations on the set voltage due to the coupled effect of the underlying polycrystalline structure variations and the voltage dependence of polarization switching mechanisms. We further report that collapsing of oppositely polarized domains at higher set voltages can lead to an increase in variations, while ferroelectric thickness scaling lowers the overall device-to-device variations. Considering the dynamics of polarization switching, we highlight the key role of voltage and temporal dependence of domain nucleation in dictating the trends in variations. Finally, we show that using a lower amplitude pulse for longer duration to reach a target mean polarization state results in lower variations compared to using a higher amplitude pulse for shorter duration.more » « less
-
We present a physics-based model for ferroelectric/negative capacitance transistors (FEFETs/ NCFETs) without an inter-layer metal between ferroelectric and dielectric in the gate stack. The model self-consistently solves 2D Poisson's equation, non-equilibrium Green's function (NEGF) based charge and transport equations, and multi-domain Landau Khalatnikov (LK) equations with the domain interaction term. The proposed simulation framework captures the variation of ferroelectric (FE) polarization (P) along the gate length due to non-uniform electric field (E) along the channel. To calibrate the LK equations, we fabricate and characterize 10nm HZO films. Based on the calibrated model, we analyze the gate/drain voltage dependence of P distribution in the FE and its effect on the channel potential and current-voltage characteristics. Our results highlight the importance of larger domain interaction to boost the benefits of FEFETs with subthreshold swing (SS) as small as ~50mV/decade achieved at room temperature. As domain interaction increases, the characteristics of FEFETs without inter-layer metal (SS, negative drain induced barrier lowering (DIBL), negative output conductance) approach those of FEFETs with inter-layer metal.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.3390/solids4040023
