An official website of the United States government
SUMMARY Within the last decade, thin ultra-low velocity zone (ULVZ) layering, sitting directly on top of the core–mantle boundary (CMB), has begun to be investigated using the flip-reverse-stack (FRS) method. In this method, pre- and post-cursor arrivals that are symmetrical in time about the ScS arrival, but with opposite polarities, are stacked. This same methodology has also been applied to high velocity layering, with indications that ultra-high velocity zones (UHVZs) may also exist. Thus far, studies using the FRS technique have relied on 1-D synthetic predictions to infer material properties of ULVZs. 1-D ULVZ models predominantly show a SdS precursor that reflects off the top of the ULVZ and an ScscS reverberation within the ULVZ that arrives as a post-cursor. 1-D UHVZ models are more complex and have a different number of arrivals depending on a variety of factors including UHVZ thickness, velocity contrast, and lateral extent. 1-D modelling approaches assume that lower mantle heterogeneity is constant and continuous everywhere across the lower mantle. However, lower mantle features display lateral heterogeneity and are either finite in extent or display local thickness variations. We examine the interaction of the ScS wavefield with ULVZs and UHVZs in 2.5-D geometries of finite extent. We show that multiple additional arrivals exist that are not present in 1-D predictions. In particular, multipath ScS arrivals as well as additional post-cursor arrivals are generated. Subsequent processing by the FRS method generates complicated FRS traces with multiple peaks. Furthermore, post-cursor arrivals can be generated even when the ScS ray path does not directly strike the heterogeneity from above. Analysing these predictions for 2.5-D models using 1-D modelling techniques demonstrates that a cautious approach must be adopted in utilization and interpretation of FRS traces to determine if the ScS wavefield is interacting with a ULVZ or UHVZ through a direct strike on the top of the feature. In particular, traveltime delays or advances of the ScS arrival should be documented and symmetrical opposite polarity arrivals should be demonstrated to exist around ScS. The latter can be quantified by calculation of a time domain multiplication trace. Because multiple post-cursor arrivals are generated by finite length heterogeneities, interpretation should be confined to single layer models rather than to interpret the additional peaks as internal layering. Furthermore, strong trade-offs exist between S-wave velocity perturbation and thickness making estimations of ULVZ or UHVZ elastic parameters highly uncertain. We test our analysis methods using data from an event occurring in the Fiji-Tonga region recorded in North America. The ScS bounce points for this event sample the CMB region to the southeast of Hawaii, in a region where ULVZs have been identified in several recent studies. We see additional evidence for a ULVZ in this region centred at 14°N and 153°W with a lateral scale of at least 250 km × 360 km. Assuming a constant S-wave velocity decrease of −10 or −20 per cent with respect to the PREM model implies a ULVZ thickness of up to 16 or 9 km, respectively.
more »
« less
Evidence for Ultra-Low Velocity Zone Genesis in Downwelling Subducted Slabs at the Core–Mantle Boundary
Abstract We investigate broadband SPdKS waveforms from earthquakes occurring beneath Myanmar. These paths sample the core–mantle boundary beneath northwestern China. Waveform modeling shows that two ∼250 × 250 km wide ultra-low velocity zones (ULVZs) with a thickness of roughly 10 km exist in the region. The ULVZ models fitting these data have large S-wave velocity drops of 55% but relatively small 14% P-wave velocity reductions. This is almost a 4:1 S- to P-wave velocity ratio and is suggestive of a partial melt origin. These ULVZs exist in a region of the Circum-Pacific with a long history of subduction and far from large low-velocity province (LLVP) boundaries where ULVZs are more commonly observed. It is possible that these ULVZs are generated by partial melting of mid-ocean ridge basalt.
more »
« less
- PAR ID:
- 10516186
- Publisher / Repository:
- The Seismological Society of America
- Date Published:
- Journal Name:
- The Seismic Record
- Volume:
- 4
- Issue:
- 2
- ISSN:
- 2694-4006
- Page Range / eLocation ID:
- 111 to 120
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Ultra‐low velocity zones (ULVZs) are anomalous structures, generally associated with decreased seismic velocity and sometimes an increase in density, that have been detected in some locations atop the Earth's core‐mantle boundary (CMB). A wide range of ULVZ characteristics have been reported by previous studies, leading to many questions regarding their origins. The lowermost mantle beneath Antarctica and surrounding areas is not located near currently active regions of mantle upwelling or downwelling, making it a unique environment in which to study the sources of ULVZs; however, seismic sampling of this portion of the CMB has been sparse. Here, we examine core‐reflected PcP waveforms recorded by seismic stations across Antarctica using a double‐array stacking technique to further elucidate ULVZ structure beneath the southern hemisphere. Our results show widespread, variable ULVZs, some of which can be robustly modeled with 1‐D synthetics; however, others are more complex, which may reflect 2‐D or 3‐D ULVZ structure and/or ULVZs with internal velocity variability. Our findings are consistent with the concept that ULVZs can be largely explained by variable accumulations of subducted oceanic crust along the CMB. Partial melting of subducted crust and other, hydrous subducted materials may also contribute to ULVZ variability.more » « less
-
Abstract There are various hotspots in the Atlantic Ocean, which are underlain by mantle plumes that likely cross the mantle and originate at the core‐mantle boundary. We use teleseismic core‐diffracted shear waves to look for an Ultra‐Low Velocity Zone (ULVZ) at the potential base of central Atlantic mantle plumes. Our data set shows delayed postcursory phases after the core‐diffracted shear waves. The observed patterns are consistent in frequency dependence, delay time, and scatter pattern with those caused by mega‐ULVZs previously modeled elsewhere. Synthetic modeling of a cylindrical structure on the core‐mantle boundary below St. Helena provides a good fit to the data. The preferred model is 600 km across and 20 km high, centered at approximately 15° South, 15° West, and with a 30% S‐wave velocity reduction. Significant uncertainties and trade‐offs do remain to these parameters, but a large ULVZ is needed to explain the data. The location is west of St. Helena and south of Ascension. Helium and neon isotopic systematics observed in samples from this region could point to a less‐outgassed mantle component mixed in with the dominant signature of recycled material. These observations could be explained by a contribution from the Large Low Shear Velocity Province (LLSVP). Tungsten isotopic measurements would be needed to understand whether a contribution from the mega‐ULVZ is also required at St. Helena or Ascension.more » « less
-
The core mantle boundary (CMB), where the solid silicate mantle meets the liquid iron-nickel outer core, represents the largest density contrast on our planet, and it has long been recognized that the CMB is associated with significant structural heterogeneities. One CMB structure of particular interest are ultra low-velocity zones (ULVZs), laterally-varying, 5-50 km thick isolated patches seen in some locations just above the CMB that are associated with increased density and reduced seismic wave velocities. These variable characteristics have led to many questions regarding ULVZ origins, but less than 20% of the CMB has been surveyed for the presence of ULVZs given limited seismic coverage of the lowermost mantle. Therefore, investigations that sample the CMB with new geometries are critical to further our understanding of ULVZs and their potential connection to other deep Earth processes. The Transantarctic Mountains Northern Network (TAMNNET), a 15-station seismic array that was recently deployed in Antarctica, provides a unique dataset to further study ULVZ structure with new and unique path geometry. Core-reflected ScP phases from the TAMNNET dataset well sample the CMB in the vicinity of New Zealand in the southwestern Pacific, providing coverage between an area to the north where ULVZ structure has been previously identified and another region to the south, which shows no ULVZ evidence. This area is of particular interest because the data points sample across the boundary of the Pacific large low shear velocity province (LLSVP). The Weddell Sea region in Antarctica is also well sampled, providing new information on this area that has not been previously studied. By identifying and modeling pre- and post-cursor ScP energy, we have explored new portions of the CMB and found evidence for ULVZs in both regions. Given that ULVZs are detected within, along the edge of, and far from the Pacific LLSVP, our results may support that ULVZs are actually present everywhere along the CMB but that they are sometimes undetectable given associated methodology resolution.more » « less
-
Abstract The along‐strike variations of the velocity, thickness, and dip of subducting slabs and the volcano distribution have been observed globally. It is, however, unclear what controls the distribution of volcanoes and the associated magma generation. With the presence of nonuniform volcanism, the Aleutian‐Alaska subduction zone (AASZ) is an ideal place to investigate subduction segmentation and its relationship with volcanism. Using full‐wave ambient noise tomography, we present a high‐resolution 3‐D shear wave velocity model of the AASZ for the depths of 15–110 km. The velocity model reveals the distinct high‐velocity Pacific slab, the thicker, flatter, and more heterogeneous Yakutat slab, and the northeasterly dipping Wrangell slab. We observe low velocities within the uppermost mantle (at depth <60 km) below the Aleutian arc volcanoes, representing partial melt accumulation. The large crustal low‐velocity anomaly beneath the Wrangell volcanic field suggests a large magma reservoir, likely responsible for the clustering of volcanoes. The Denali volcanic gap is above an average‐velocity crust but an extremely fast mantle wedge, suggesting the lack of subsurface melt. This is in contrast with the lower‐velocity back‐arc mantle beneath the adjacent Buzzard Creek‐Jumbo Dome volcanoes to the east. The back‐arc low velocities associated with the Pacific, the eastern Yakutat, and the Wrangell slabs may reflect subduction‐driven mantle upwelling. The structural variation of the downgoing slabs and the overriding plate explains the change of volcanic activity along the AASZ. Our findings demonstrate the combined role of the subducting slab and the overriding plate in controlling the characteristics of arc magmatism.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript
- Journal Article:
- https://doi.org/10.1785/0320240003
