An official website of the United States government
Graphene oxide (GO) films have a great potential for aerospace, electronics, and renewable energy applications due to their low cost and unique properties. For structural applications, they can achieve an exceptional combination of damping and stiffness. This study investigates the effect of packing density, reduction, and water removal on stiffness and damping of graphene oxide films. GO sheets dispersed in water are passed through a filter and deposited on a removable substrate. Through variations of the film fabrication process, films of both GO and reduced GO (rGO) are produced with varying levels of packing. Heat treatment is also used to remove the water in half of the films. The degree of packing is assessed through film density calculations. Microscopy as well as Raman and X-ray spectroscopy are used to measure the degree of packing while Dynamic Mechanical Analysis (DMA) is used to quantity mechanical damping and storage modulus of specimens in tension. Correlating mechanical properties to structure of films revealed new understanding of damping and stress transfer mechanisms in these materials. Optimal structures resulted in superior combinations of stiffness (18 GPa) and damping (0.14), potentially paving the way for using GO based films in advanced structural applications.
more »
« less
Energy harvesting from water flow through porous reduced graphene oxide networks
Using a syringe pump setup, the authors conducted water flow experiments through porous reduced graphene oxide (rGO). A variety of anions and cations were added to the water to study its effect on energy harvesting. More specifically, the authors performed tests to study effect of: (1) ion concentration in water, (2) type of anion used, (3) type of cation used, and (4) effect of flow rate. The test data indicates that water flow through rGO networks can directly induce drift of charge carriers in graphene and thus generate electricity. Graphene is ideally suited for this application, since it possesses high mobility charge carriers that are ready to be coupled to moving ions present in the flowing fluid. The proposed rGO material could enable harvesting of the ubiquitous, abundant, and renewable mechanical energy of moving water directly to electrical energy. Unlike traditional schemes, the graphene material directly converts the flow energy into electrical energy without the need for moving parts. Such graphene coatings could potentially replace conventional batteries (which are environmentally hazardous) in low‐power, low‐voltage, and long service‐life applications. Once scaled up, this concept offers a potentially transformative approach to energy harvesting, as opposed to incremental advances in current technologies.
more »
« less
- Award ID(s):
- 2002742
- PAR ID:
- 10531342
- Publisher / Repository:
- Wiley
- Date Published:
- Journal Name:
- The Journal of Engineering
- Volume:
- 2024
- Issue:
- 1
- ISSN:
- 2051-3305
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Lead zirconate titanate (PZT) is widely used in energy harvesting because of its excellent material properties. However, as the material contains lead, there are significant environmental concerns with its production and use. Flexoelectricity refers to the coupling between strain gradient and electric polarization that exists, in principle, in all dielectric materials and would allow for energy harvesting without using piezoelectric materials. However, the effect is very weak in most materials. Promisingly, it has recently been shown that space charge polarized materials (i.e., semiconducting materials with insulating barrier layers) can exhibit enhanced flexoelectricity. This space charge induced flexoelectric effect opens up the possibility of a non-toxic replacement for PZT in energy harvesting applications. In this paper we investigate the use of doped silicon with hafnium oxide insulating layers as flexoelectric transducers that could replace PZT in many applications including energy harvesting. Specifically, we experimentally demonstrate flexoelectricity in a bending beam and show an effective flexoelectric coefficient of 4.9 uC/F. Finally, we develop and demonstrate a finite element model for flexoelectricity.more » « less
-
Abstract Electronic materials that allow the controlled flow of electrons in aqueous media are required for emerging applications that require biocompatibility, safety, and/or sustainability. Here, a composite hydrogel film composed of graphene and catechol is electrofabricated, and that this composite offers synergistic properties is reported. Graphene confers metal‐like conductivity and enables charge‐storage through an electrical double layer mechanism. Catechol confers redox‐activity and enables charge‐storage through a redox mechanism. Importantly, there are two functional populations of catechols: conducting‐catechols (presumably in intimate contact with graphene) allow direct electron‐transfer; and non‐conducting‐catechols (presumably physically separated from graphene) require diffusible mediators to enable electron‐transfer. Using a variety of spectroelectrochemical measurements, that the capacity of the composite for charge‐storage increases in proportion to the extent by which the catechol‐groups can undergo redox‐state switching is demonstrated. To illustrate the broad relevance of this work, how the redox‐state switching can be related to both the charge storage of energy materials and the memory of molecular electronic materials is discussed. The authors believe this work is significant because it demonstrates that: conducting and redox‐active components enable distinctly different mechanisms for charge‐storage and electron‐transfer; these components act synergistically; and mediators provide unique opportunities to extend the capabilities of electronic materials.more » « less
-
Photocatalysis is an attractive, sustainable, and potentially low-cost route to capture solar energy as fuel. However, current photocatalytic materials synthesis routes are not easily scaled-up to the magnitude required to impact our energy consumption due to both economic and environmental concerns. While the elements utilized are often earth abundant, typical synthetic routes utilize organic solvents at elevated temperatures with relatively expensive precursors. Herein, we demonstrate the fully biomineralized synthesis of a quantum confined CdS/reduced graphene oxide (CdS/rGO) photocatalyst catalyzed by the single enzyme cystathionine γ-lyase (CSE). The synthesis is performed at pH 9 in a buffered aqueous solution, under ambient conditions, and utilizes the low-cost precursors Cd acetate, l -cysteine, graphene oxide, and a poly- l -lysine linker molecule. CSE actively decomposes l -cysteine to generate reactive HS − in aqueous solution at pH 9. Careful selection and control of the synthesis conditions enable both reduction of graphene oxide to rGO, and control over the mean CdS nanocrystal size. The CdS is conjugated to the rGO via a poly- l -lysine crosslinker molecule introduced during rGO formation. The completed CdS/rGO photocatalyst is capable of producing H 2 , without the aid of a noble metal co-catalyst, at a rate of 550 μmol h −1 g −1 for an optimized CdS/rGO ratio. This rate is double that measured for unsupported CdS and is comparable to CdS/rGO photocatalysts produced using more typical chemical synthesis routes. Single enzyme biomineralization by CSE can produce a range of metal chalcogenides without altering the enzyme or benign approach, making this an easily adaptable procedure for the sustainable production of a wide variety of important photocatalyst systems.more » « less
-
null (Ed.)Nanoscale materials that contain metallic components can be designed to have excellent light-harvesting capabilities, and can also be used to direct the flow of energy from incident photons into small molecules at or near the surface of metal nanoparticles. One promising route for energy flow is through so-called hot charge carriers, which are optically excited on metal nanoparticles and subsequently transferred to molecules/materials that share an interface with the metal. This article provides an overview of the fundamentals of hot-carrier generation and transfer, discusses both theoretical and experimental means for interrogating these processes, and discusses several potential societally important applications of hot-carrier-driven chemistry to solar fuels and sustainable chemistry.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1049/tje2.12338
