Here, the radiation hardness of metal halide perovskite solar cells exposed to space conditions versus the effects of environmental degradation are assessed. The relative response of the constituent layers of the architecture to radiation is analyzed, revealing a general resilience of the structure when assessed across varying proton energy levels and fluences. However, despite the tolerance of the structure to irradiation, sensitivity to environmental degradation is observed during the transit of the device between the radiation and characterization facilities. Experimental evidence suggests the NiO
This content will become publicly available on February 1, 2025
ACIGS solar cells are exposed to targeted radiation to probe the front and back interfaces of the absorber to assess the impact of space environments on these systems. These data suggest ACIGS cells are more radiation‐hard than early CIGS devices likely due to the lower defect densities and more ideal interfaces in the ACIGS system. A combination of
- Award ID(s):
- 2210722
- PAR ID:
- 10539030
- Publisher / Repository:
- Advance Science News, Solar RRL
- Date Published:
- Journal Name:
- Solar RRL
- Volume:
- 8
- Issue:
- 3
- ISSN:
- 2367-198X
- Page Range / eLocation ID:
- 2300756
- Subject(s) / Keyword(s):
- ACIGS, interfaces, radiation, stability, temperatures
- Format(s):
- Medium: X Size: 2.5MB Other: pdf
- Size(s):
- 2.5MB
- Sponsoring Org:
- National Science Foundation
More Like this
-
Irvine, John (Ed.)more » « less
Abstract x /perovskite interface is particularly sensitive to the effects of humidity and/or temperature exposure, while the irradiation of the devices appears to induce thermally activated annealing: improving the solar cells upon radiation exposure. -
more » « less
The high tolerance and stability of triple halide perovskite solar cells is demonstrated in practical space conditions at high irradiation levels. The solar cells were irradiated for a range of proton energies (75 keV, 300 keV, and 1 MeV) and fluences (up to 4 × 1014 p/cm2). The fluences of the energy proton irradiations were varied to induce the same amount of vacancies in the absorber layer due to non-ionizing nuclear energy loss (predominant at <300 keV) and electron ionization loss (predominant at >300 keV). While proton irradiation of the solar cells initially resulted in degradation of the photovoltaic parameters, self-healing was observed after two months where the performance of the devices was shown to return to their pristine operation levels. Their ability to recover upon radiation exposure supports the practical potential of perovskite solar cells for next-generation space missions.
-
more » « less
Abstract Radiation susceptibility of electronic devices is commonly studied as a function of radiation energetics and device physics. Often overlooked is the presence or magnitude of the electrical field, which we hypothesize to play an influential role in low energy radiation. Accordingly, we present a comprehensive study of low-energy proton irradiation on gallium nitride high electron mobility transistors (HEMTs), turning the transistor ON or OFF during irradiation. Commercially available GaN HEMTs were exposed to 300 keV proton irradiation at fluences varying from 3.76 × 1012to 3.76 × 1014cm2, and the electrical performance was evaluated in terms of forward saturation current, transconductance, and threshold voltage. The results demonstrate that the presence of an electrical field makes it more susceptible to proton irradiation. The decrease of 12.4% in forward saturation and 19% in transconductance at the lowest fluence in ON mode suggests that both carrier density and mobility are reduced after irradiation. Additionally, a positive shift in threshold voltage (0.32 V and 0.09 V in ON and OFF mode, respectively) indicates the generation of acceptor-like traps due to proton bombardment. high-resolution transmission electron microscopy and energy dispersive x-ray spectroscopy analysis reveal significant defects introduction and atom intermixing near AlGaN/GaN interfaces and within the GaN layer after the highest irradiation dose employed in this study. According to
in-situ Raman spectroscopy, defects caused by irradiation can lead to a rise in self-heating and a considerable increase in (∼750 times) thermoelastic stress in the GaN layer during device operation. The findings indicate device engineering or electrical biasing protocol must be employed to compensate for radiation-induced defects formed during proton irradiation to improve device durability and reliability. -
more » « less
The impact of 1.8 MeV proton irradiation on metalorganic chemical vapor deposition grown (010) β-Ga2O3 Schottky diodes is presented. It is found that after a 10.8×1013cm−2 proton fluence the Schottky barrier height of (1.40±0.05 eV) and the ideality factor of (1.05±0.05) are unaffected. Capacitance–voltage extracted net ionized doping curves indicate a carrier removal rate of 268±10cm−1. The defect states responsible for the observed carrier removal are studied through a combination of deep level transient and optical spectroscopies (DLTS/DLOS) as well as lighted capacitance–voltage (LCV) measurements. The dominating effect on the defect spectrum is due to the EC-2.0 eV defect state observed in DLOS and LCV. This state accounts for ∼75% of the total trap introduction rate and is the primary source of carrier removal from proton irradiation. Of the DLTS detected states, the EC-0.72 eV state dominated but had a comparably smaller contribution to the trap introduction. These two traps have previously been correlated with acceptor-like gallium vacancy-related defects. Several other trap states at EC-0.36, EC-0.63, and EC-1.09 eV were newly detected after proton irradiation, and two pre-existing states at EC-1.2 and EC-4.4 eV showed a slight increase in concentration after irradiation, together accounting for the remainder of trap introduction. However, a pre-existing trap at EC-0.40 eV was found to be insensitive to proton irradiation and, therefore, is likely of extrinsic origin. The comprehensive defect characterization of 1.8 MeV proton irradiation damage can aid the modeling and design for a range of radiation tolerant devices.
-
Nanocrystalline and nanolaminated materials show enhanced radiation tolerance compared with their coarse-grained counterparts, since grain boundaries and layer interfaces act as effective defect sinks. Although the effects of layer interface and layer thickness on radiation tolerance of crystalline nanolaminates have been systematically studied, radiation response of crystalline/amorphous nanolaminates is rarely investigated. In this study, we show that irradiation can lead to formation of nanocrystals and nanotwins in amorphous CuNb layers in Cu/amorphous-CuNb nanolaminates. Substantial element segregation is observed in amorphous CuNb layers after irradiation. In Cu layers, both stationary and migrating grain boundaries effectively interact with defects. Furthermore, there is a clear size effect on irradiation-induced crystallization and grain coarsening. In situ studies also show that crystalline/amorphous interfaces can effectively absorb defects without drastic microstructural change, and defect absorption by grain boundary and crystalline/amorphous interface is compared and discussed. Our results show that tailoring layer thickness can enhance radiation tolerance of crystalline/amorphous nanolaminates and can provide insights for constructing crystalline/amorphous nanolaminates under radiation environment.more » « less
