An official website of the United States government
Abstract We present the transverse coherence minimization method (TCM)—an approach to estimate the back-azimuth of infrasound signals that are recorded on an infrasound microphone and a colocated three-component seismometer. Accurate back-azimuth information is important for a variety of monitoring efforts, but it is currently only available for infrasound arrays and for seismoacoustic sensor pairs separated by 10 s of meters. Our TCM method allows for the analysis of colocated sensor pairs, sensors located within a few meters of each other, which may extend the capabilities of existing seismoacoustic networks and supplement operating infrasound arrays. This approach minimizes the coherence of the transverse component of seismic displacement with the infrasound wave to estimate the infrasound back-azimuth. After developing an analytical model, we investigate seismoacoustic signals from the August 2012 Humming Roadrunner experiment and the 26 May 2021 eruption of Great Sitkin Volcano, Alaska, U.S.A., at the ranges of 6.5–185 km from the source. We discuss back-azimuth estimates and potential sources of deviation (1°–15°), such as local terrain effects or deviation from common analytical models. This practical method complements existing seismoacoustic tools and may be suitable for routine application to signals of interest.
more »
« less
Evaluating the temporal capability of empirical climatologies for rapid long-range volcanic infrasound propagation estimates using a multidecadal data set of persistent Vanuatu volcanic eruptions
SUMMARY Powerful infrasound (acoustic waves $$\lt $$20 Hz) can be produced by explosive volcanic eruptions. The long-range propagation capability, over hundreds to thousands of kilometers, of atmospheric infrasound motivates the development of regional or even global scale volcano-infrasound monitoring systems. Infrasound propagation paths are subject to spatiotemporal atmospheric dynamics, which lead to deviations in the direction-of-arrival (back-azimuth) observed at sensor arrays and contribute to source location uncertainty. Here, we further investigate the utility of empirical climatologies combined with 3-D ray tracing for providing first-order estimates of infrasound propagation paths and back-azimuth deviation corrections. The intended application is in scenarios requiring rapid or pre-computed infrasound propagation calculations, such as for a volcano-infrasound monitoring system. Empirical climatologies are global observationally based function fitting models of the atmosphere, representing robust predictors of the bulk diurnal to seasonal atmospheric variability. Infrasound propagation characteristics have previously been shown to have strong seasonal and diurnal components. At the International Monitoring System infrasound station IS22, New Caledonia, quasi-continuous multiyear infrasound array detections show oscillating azimuthal variations for arrivals from volcanoes in Vanuatu, including Yasur ($$\sim$$400 km range), Ambrym ($$\sim$$670 km range) and Lopevi ($$\sim$$650 km range). We perform 3-D ray tracing to model infrasound propagation from the Ambrym and Yasur volcano locations to IS22 every six hours (00:00, 06:00, 12:00 and 18:00 UTC) for every day of 2004 and 2019 for Ambrym and Yasur, respectively and evaluate the results as compared to the multiyear observations. We assess a variety of models and parametrizations, including both empirical climatologies and hybrid descriptions; range-independent and range-dependent atmospheric discretizations; and unperturbed and perturbed range-independent empirical climatologies. The hybrid atmospheric descriptions are composed of fifth generation reanalysis descriptions (ERA 5) from the European Centre for Medium-Range Weather Forecasts below $$\sim$$80 km altitude combined with empirical climatologies above. We propose and employ simple parametric perturbations to the empirical climatologies, which are designed to enhance the stratospheric duct and compensate for missing gravity wave perturbations not included in the climatologies, and thereby better match observations. We build year-long back-azimuth deviation interpolations from the simulations and compare them with three different multiyear array detection data sets from IS22 covering from 2003 up to 2022. Through a systematic comparison, we find that the range-independent empirical climatologies can capture bulk azimuth deviation variability and could thus be useful for rapid infrasound propagation calculation scenarios, particularly during favourable sustained propagation ducting conditions. We show that the hybrid models better describe infrasound propagation during periods of weak stratospheric ducting and during transient atmospheric changes such as stratospheric wind reversals. Overall, our results support the notion that climatologies, if perturbed to compensate for missing gravity wave structure, can improve rapid low-latency and pre-computed infrasound source discrimination and location procedures.
more »
« less
- Award ID(s):
- 1847736
- PAR ID:
- 10587272
- Publisher / Repository:
- Geophysical Journal International; Oxford University Press
- Date Published:
- Journal Name:
- Geophysical Journal International
- Volume:
- 241
- Issue:
- 1
- ISSN:
- 0956-540X
- Page Range / eLocation ID:
- 268 to 290
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
null (Ed.)Infrasound data are routinely used to detect and locate volcanic and other explosions, using both arrays and single sensor networks. However, at local distances (<15 km) topography often complicates acoustic propagation, resulting in inaccurate acoustic travel times leading to biased source locations when assuming straight-line propagation. Here we present a new method, termed Reverse Time Migration-Finite-Difference Time Domain (RTM-FDTD), that integrates numerical modeling into the standard RTM back-projection process. Travel time information is computed across the entire potential source grid via FDTD modeling to incorporate the effects of topography. The waveforms are then back-projected and stacked at each grid point, with the stack maximum corresponding to the likely source. We apply our method to three volcanoes with different network configurations, source-receiver distances, and topography. At Yasur Volcano, Vanuatu, RTM-FDTD locates explosions within ∼20 m of the source and differentiates between multiple vents. RTM-FDTD produces a more accurate location for the two Yasur subcraters than standard RTM and doubles the number of detected events. At Sakurajima Volcano, Japan, RTM-FDTD locates the source within 50 m of the active vent despite notable topographic blocking. The RTM-FDTD location is similar to that from the Time Reversal Mirror method, but is more computationally efficient. Lastly, at Shishaldin Volcano, Alaska, RTM and RTM-FDTD both produce realistic source locations (<50 m) for ground-coupled airwaves recorded on a four-station seismic network. We show that RTM is an effective method to detect and locate infrasonic sources across a variety of scenarios, and by integrating numerical modeling, RTM-FDTD produces more accurate source locations and increases the detection capability.more » « less
-
Abstract Volcano infrasound data contain a wealth of information about eruptive patterns, for which machine learning (ML) is an emerging analysis tool. Although global catalogs of labeled infrasound events exist, the application of supervised ML to local (<15 km) volcano infrasound signals has been limited by a lack of robust labeled datasets. Here, we automatically generate a labeled dataset of >7500 explosions recorded by a five-station infrasound network at the highly active Yasur Volcano, Vanuatu. Explosions are located via backprojection and associated with one of Yasur’s two summit subcraters. We then apply a supervised ML approach to classify the subcrater of origin. When trained and tested on data from the same station, our chosen algorithm is >95% accurate; when training and testing on different stations, accuracy drops to about 75%. The choice of waveform features provided to the algorithm strongly influences classification performance.more » « less
-
Abstract The global 3‐dimensional structure of the concentric traveling ionospheric disturbances (CTIDs) triggered by 2022 Tonga volcano was reconstructed by using the 3‐dimensional computerized ionospheric tomography (3DCIT) technique and extensive global navigation satellite system (GNSS) observations. This study provides the first estimation of the CTIDs vertical wavelengths, ∼736 km, which was much larger than the gravity wave (GW) vertical wavelength, 240–400 km, estimated using ICON neutral wind observations. Notable trend with the variation of azimuth was also found in horizontal speeds at 200 and 500 km altitudes and differences between them. These results imply that (a) the global propagation of Lamb waves determined the arrival time of local ionospheric disturbances, and (b) the arriving Lamb waves caused vertical atmospheric perturbations that are not typical of GWs, resulting in local thermospheric horizontal wave propagation which is faster than the Lamb wave propagation at lower altitudes.more » « less
-
Abstract Volcanic eruption source parameters may be estimated from acoustic pressure recordings dominant at infrasonic frequencies (< 20 Hz), yet uncertainties may be high due in part to poorly understood propagation dynamics. Linear acoustic propagation of volcano infrasound is commonly assumed, but nonlinear processes such as wave steepening may distort waveforms and obscure the sourcing process in recorded waveforms. Here we use a previously developed frequency-domain nonlinearity indicator to quantify spectral changes due to nonlinear propagation primarily in 80 signals from explosions at Yasur Volcano, Vanuatu. We find evidence for $$\le$$ ≤ 10 −3 dB/m spectral energy transfer in the band 3–9 Hz for signals with amplitude on the order of several hundred Pa at 200–400 m range. The clarity of the nonlinear spectral signature increases with waveform amplitude, suggesting stronger nonlinear changes for greater source pressures. We observe similar results in application to synthetics generated through finite-difference wavefield simulations of nonlinear propagation, although limitations of the model complicate direct comparison to the observations. Our results provide quantitative evidence for nonlinear propagation that confirms previous interpretations made on the basis of qualitative observations of asymmetric waveforms.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript
- Journal Article:
- https://doi.org/10.1093/gji/ggaf027
