An official website of the United States government
Low bond coordination of surface atoms facilitates the injection of oxygen interstitial atoms into the bulk near room temperature from the clean surfaces of semiconducting metal oxides when exposed to liquid water, opening new prospects for postsynthesis defect engineering and isotopic fractionation. The injection rate and penetration depth vary considerably under identical experimental conditions, however, with the adsorption of adventitious carbon suggested as the cause. For water-submerged rutile TiO2(110) and wurtzite ZnO(0001), this work bolsters and refines that hypothesis by combining the isotopic self-diffusion measurements of oxygen with characterization by x-ray photoelectron spectroscopy and atomic force microscopy. Adventitious carbon likely diminishes injection rates by poisoning small concentrations of exceptionally active surface sites that either inject O or dissociate adsorbed OH to injectable O. These effects propagate into the penetration depth via the progressive saturation of Oi traps near the surface, which occurs less extensively as the injected flux decreases.
more »
« less
Influence of interstitial cluster families on post-synthesis defect manipulation and purification of oxides using submerged surfaces
Injection of interstitial atoms by specially prepared surfaces submerged in liquid water near room temperature offers an attractive approach for post-synthesis defect manipulation and isotopic purification in device structures. However, this approach can be limited by trapping reactions that form small defect clusters. The compositions and dissociation barriers of such clusters remain mostly unknown. This communication seeks to address this gap by measuring the dissociation energies of oxygen interstitial traps in rutile TiO2 and wurtzite ZnO exposed to liquid water. Isotopic self-diffusion measurements using 18O, combined with progressive annealing protocols, suggest the traps are small interstitial clusters with dissociation energies ranging from 1.3 to 1.9 eV. These clusters may comprise a family incorporating various numbers, compositions, and configurations of O and H atoms; however, in TiO2, native interstitial clusters left over from initial synthesis may also play a role. Families of small clusters are probably common in semiconducting oxides and have several consequences for post-synthesis defect manipulation and purification of semiconductors using submerged surfaces.
more »
« less
- Award ID(s):
- 2322121
- PAR ID:
- 10628294
- Publisher / Repository:
- AIP Publishing
- Date Published:
- Journal Name:
- The Journal of Chemical Physics
- Volume:
- 161
- Issue:
- 12
- ISSN:
- 0021-9606
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Semiconductor surfaces provide efficient pathways for injecting native point defects into the underlying bulk. In the case of interstitial atoms in rutile, the TiO 2 (110) surface exemplifies this behavior, although extended defects in the bulk such as platelets and crystallographic shear planes act as net sources or sinks depending upon specific conditions. The present work constructs a quantitative microkinetic model to describe diffusion and based upon isotopic gas–solid exchange experiments. Key activation barriers for are 0.55 eV for surface injection, 0.50 eV for site-to-site hopping diffusion, and 3.3 eV for dissociation of titanium interstitials from extended defects.more » « less
-
Quartz-based minerals in earth’s crust are well-known to contain water-related defects within their volume-constrained lattice, and they are responsible for strength-loss. Experimental observations of natural α-quartz indicate that such defects appear as hydroxyl groups attached to Si atoms, called Griggs defect (Si-OH), and molecular water (H2O) located at the interstitial sites. However, factors contributing to the formation of Griggs and interstitial H2O defects remain unclear. For example, the role of point defects like vacancy sites (O2− and Si4+), and substitutional (Al3+) and interstitial (Li+, K+, Ca2+, Mg2+, etc.) ions has remained largely unexplored. Here, we performed ab initio molecular dynamics at 300 K to examine the energetics and structure of water-related defects in volume-constrained α-quartz. Several configurations were systematically interrogated by incorporating interstitial H2O, O2− and Si4+ vacancies, substitutional Al3+, and interstitial Li+, Ca2+ and Mg2+ ions within α-quartz. Interstitial H2O defect was found to be energetically favorable in the presence of Substitutional Al3+, and interstitial Ca2+, Mg2+, and Li1+. In the presence of O2− and Si4+ vacancies, H2O showed a strong tendency to dissociate into OH—to form Griggs defect—and a proton; even in the presence of substitutional and interstitial ions. These ions distorted the α-quartz lattice and, in the extreme case, disrupted long-range order to form local amorphous domains; consistent with experimental reports. Our study provides an initial framework for understanding the impact of water within the crystal lattice of an anhydrous silicate mineral such as quartz. We provide not only thermodynamic and process-related information on observed defects, but also provides guidelines for future studies of water’s impact on the behavior of silicate minerals.more » « less
-
In area-selective processes, such as area-selective atomic layer deposition (AS-ALD), there is renewed interest in designing surface modification schemes allowing to tune the reactivity of the nongrowth (NG) substrates. Many efforts are directed toward small molecule inhibitors or atomic layers, which would modify selected surfaces to delay nucleation and provide NG properties in the target AS-ALD processes allowing for the manufacturing of smaller sized features than those produced with alternative approaches. Bromine termination of silicon surfaces, specifically Si(100) and Si(111), is evaluated as a potential pathway to design NG substrates for the deposition of metal oxides, and TiO2 (from cycles of sequential exposures of tetrakis-dimethylamido-titanium and water) is tested as a prototypical deposition material. Nucleation delays on the surfaces produced are comparable to those on H-terminated silicon that is commonly used as an NG substrate. However, the silicon surfaces produced by bromination are more stable, and even oxidation does not change their chemical reactivity substantially. Once the NG surface is eventually overgrown after a large number of ALD cycles, bromine remains at the interface between silicon and TiO2. The NG behavior of different crystal faces of silicon appears to be similar, albeit not identical, despite different arrangements and coverage of bromine atoms.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1063/5.0230224
