An official website of the United States government
The lithium iron phosphate (LFP) battery has more nonlinear characteristic than other battery type. For this reason, when we use electrical equivalent circuit model and the extended Kalman filter (EKF) for estimating the SOC, the estimation performance can be decreased in the nonlinear region. This paper proposes an advance estimation method of state of charge (SOC) for lithium iron phosphate (LFP) batteries. To improve the model accuracy, this paper utilizes the nonlinear observer for identifying the internal parameters of batteries. Furthermore, to reduce the nonlinear effect of the LFP batteries, this paper recast the Kalman process. Therefore, through the proposed method, the performance of SOC estimation can be more accurate and the computational burden is decreased when we apply the embedded system.
more »
« less
This content will become publicly available on September 1, 2026
Cell State-of-Charge Estimation with Limited Voltage Sensor Measurements
This paper presents a practical experiment for estimating the state-of-charge (SOC) of individual cells in a series-connected heterogeneous lithium-ion battery pack, where only the terminal voltage of the battery pack is measured. To deal with real-time computation constraints, the dense extended Kalman filter (DEKF) algorithm has been proposed in the literature, which has a significantly lower computational complexity compared to the regular extended Kalman filter for this specific estimation problem. This work supplements the existing work by conducting a real-world experiment to validate the performance of the DEKF. Specifically, experiments involving a battery pack of three cells connected in series were conducted, where the battery pack was discharged under a constant current load. A genetic algorithm was applied to identify missing model parameters, as well as tuning the DEKF for optimal convergence and accurate SOC estimation. Our experimental results confirm that the proposed DEKF accurately estimates the SOC of each cell regardless of the hardware limitations and uncertainty, making it suitable for low-cost, real-time battery management systems. In particular, the SOC estimation error can be kept well under 1% even if the initial estimate is far from the true SOC.
more »
« less
- PAR ID:
- 10652030
- Publisher / Repository:
- MDPI
- Date Published:
- Journal Name:
- Applied Sciences
- Volume:
- 15
- Issue:
- 18
- ISSN:
- 2076-3417
- Page Range / eLocation ID:
- 10127
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Uwe Sauer, Dirk (Ed.)A B S T R A C T This paper proposes a model for parameter estimation of Vanadium Redox Flow Battery based on both the electrochemical model and the Equivalent Circuit Model. The equivalent circuit elements are found by a newly proposed optimization to minimized the error between the Thevenin and KVL-based impedance of the equivalent circuit. In contrast to most previously proposed circuit models, which are only introduced for constant current charging, the proposed method is applicable for all charging procedures, i.e., constant current, constant voltage, and constant current-constant voltage charging procedures. The proposed model is verified on a nine-cell VRFB stack by a sample constant current-constant voltage charging. As observed, in constant current charging mode, the terminal voltage model matches the measured data closely with low deviation; however, the terminal voltage model shows discrepancies with the measured data of VRFB in constant voltage charging. To improve the proposed circuit model’s discrepancies in constant voltage mode, two Kalman filters, i.e., hybrid extended Kalman filter and particle filter estimation algorithms, are used in this study. The results show the accuracy of the proposed equivalent with an average deviation of 0.88% for terminal voltage model estimation by the extended KF-based method and the average deviation of 0.79% for the particle filter-based estimation method, while the initial equivalent circuit has an error of 7.21%. Further, the proposed procedure extended to estimate the state of charge of the battery. The results show an average deviation of 4.2% in estimating the battery state of charge using the PF method and 4.4% using the hybrid extended KF method, while the electrochemical SoC estimation method is taken as the reference. These two Kalman Filter based methods are more accurate compared to the average deviation of state of charge using the Coulomb counting method, which is 7.4%.more » « less
-
Abstract This paper addresses the parameter estimation problem for lithium-ion battery pack models comprising cells in series. This valuable information can be exploited in fault diagnostics to estimate the number of cells that are exhibiting abnormal behaviour, e.g. large resistances or small capacities. In particular, we use a Bayesian approach to estimate the parameters of a two-cell arrangement modelled using equivalent circuits. Although our modeling framework has been extensively reported in the literature, its structural identifiability properties have not been reported yet to the best of the authors’ knowledge. Moreover, most contributions in the literature tackle the estimation problem through point-wise estimates assuming Gaussian noise using e.g. least-squares methods (maximum likelihood estimation) or Kalman filters (maximum a posteriori estimation). In contrast, we apply methods that are suitable for nonlinear and non-Gaussian estimation problems and estimate the full posterior probability distribution of the parameters. We study how the model structure, available measurements and prior knowledge of the model parameters impact the underlying posterior probability distribution that is recovered for the parameters. For two cells in series, a bimodal distribution is obtained whose modes are centered around the real values of the parameters for each cell. Therefore, bounds on the model parameters for a battery pack can be derived.more » « less
-
Designing robust algorithms in the face of estimation uncertainty is a challenging task. Indeed, controllers seldom consider estimation uncertainty and only rely on the most likely estimated state. Consequently, sudden changes in the environment or the robot’s dynamics can lead to catastrophic behaviors. Leveraging recent results in risk-sensitive optimal control, this paper presents a risk-sensitive Extended Kalman Filter that can adapt its estimation to the control objective, hence allowing safe output-feedback Model Predictive Control (MPC). By taking a pessimistic estimate of the value function resulting from the MPC controller, the filter provides increased robustness to the controller in phases of uncertainty as compared to a standard Extended Kalman Filter (EKF). The filter has the same computational complexity as an EKF and can be used for real-time control. The paper evaluates the risk-sensitive behavior of the proposed filter when used in a nonlinear MPC loop on a planar drone and industrial manipulator in simulation, as well as on an external force estimation task on a real quadruped robot. These experiments demonstrate the ability of the approach to significantly improve performance in face of uncertainties.more » « less
-
To perform power system monitoring and control using synchrophasor measurements, various dynamic state estimators have been proposed in the literature, including the extended Kalman filter (EKF) and the unscented Kalman filter (UKF). However, they are unable to handle system model parameter errors and any type of outliers, precluding them from being adopted for power system real-time applications. In this paper, we develop a robust iterated extended Kalman filter based on the generalized maximum likelihood approach (termed GM-IEKF) for dynamic state estimation. The proposed GM-IEKF can effectively suppress observation and innovation outliers, which may be induced by model parameter gross errors and cyber attacks. We assess its robustness by carrying out extensive simulations on the IEEE 39-bus test system. From the results, we find that the GM-IEKF is able to cope with at least 25% outliers, including in position of leverage.more » « less
