An official website of the United States government
Abstract This paper is Part II of a two‐part paper that documents the Climate Model version 4X (CM4X) hierarchy of coupled climate models developed at the Geophysical Fluid Dynamics Laboratory. Part I of this paper is presented in Griffies et al. (2025a,https://doi.org/10.1029/2024MS004861). Here we present a suite of case studies that examine ocean and sea ice features that are targeted for further research, which include sea level, eastern boundary upwelling, Arctic and Southern Ocean sea ice, Southern Ocean circulation, and North Atlantic circulation. The case studies are based on experiments that follow the protocol of version 6 from the Coupled Model Intercomparison Project. The analysis reveals a systematic improvement in the simulation fidelity of CM4X relative to its CM4.0 predecessor, as well as an improvement when refining the ocean/sea ice horizontal grid spacing from the of CM4X‐p25 to the of CM4X‐p125. Even so, there remain many outstanding biases, thus pointing to the need for further grid refinements, enhancements to numerical methods, and/or advances in parameterizations, each of which target long‐standing model biases and limitations.
more »
« less
This content will become publicly available on October 1, 2026
The GFDL‐CM4X Climate Model Hierarchy, Part I: Model Description and Thermal Properties
Abstract We present the GFDL‐CM4X (Geophysical Fluid Dynamics Laboratory Climate Model version 4X) coupled climate model hierarchy. The primary application for CM4X is to investigate ocean and sea ice physics as part of a realistic coupled Earth climate model. CM4X utilizes an updated MOM6 (Modular Ocean Model version 6) ocean physics package relative to CM4.0, and there are two members of the hierarchy: one that uses a horizontal grid spacing of (referred to as CM4X‐p25) and the other that uses a grid (CM4X‐p125). CM4X also refines its atmospheric grid from the nominally 100 km (cubed sphere C96) of CM4.0–50 km (C192). Finally, CM4X simplifies the land model to allow for a more focused study of the role of ocean changes to global mean climate. CM4X‐p125 reaches a global ocean area mean heat flux imbalance of within years in a pre‐industrial simulation, and retains that thermally equilibrated state over the subsequent centuries. This 1850 thermal equilibrium is characterized by roughly less ocean heat than present‐day, which corresponds to estimates for anthropogenic ocean heat uptake between 1870 and present‐day. CM4X‐p25 approaches its thermal equilibrium only after more than 1000 years, at which time its ocean has roughlymoreheat than its early 21st century ocean initial state. Furthermore, the root‐mean‐square sea surface temperature bias for historical simulations is roughly 20% smaller in CM4X‐p125 relative to CM4X‐p25 (and CM4.0). We offer themesoscale dominance hypothesisfor why CM4X‐p125 shows such favorable thermal equilibration properties.
more »
« less
- PAR ID:
- 10653523
- Author(s) / Creator(s):
- ; ; ; ; ; ; ; ; ; ; ; ; ; ; ; ; ; ; ; more »
- Publisher / Repository:
- AGU
- Date Published:
- Journal Name:
- Journal of Advances in Modeling Earth Systems
- Volume:
- 17
- Issue:
- 10
- ISSN:
- 1942-2466
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract To explore the interactions among column processes in the Community Atmosphere Model (CAM), the single‐column version of CAM (SCAM) is integrated for 1000 days in radiative‐convective equilibrium (RCE) with tropical values of boundary conditions, spanning a parameter or configuration space of model physics versions (v5 vs. v6), vertical resolution (standard and 60 levels), sea surface temperature (SST), and some interpretation‐driven experiments. The simulated time‐mean climate is reasonable, near observations and RCE of a cyclic cloud‐resolving model. Updraft detrainment in the deep convection scheme produces distinctive grid‐scale structures in humidity and cloud, which also interact with radiative transfer processes. These grid artifacts average out in multi‐column RCE results reported elsewhere, illustrating the nuts‐and‐bolts interpretability that SCAM adds to the hierarchy of model configurations. Multi‐day oscillations of precipitation arise from descent of warm convection‐capping layers starting near the tropopause, eventually reset by a burst of convective deepening. Experiments reveal how these oscillations depend critically on an internal parameter that controls the number of neutral buoyancy levels allowed for determining cloud top and computing dilute convective available potential energy in the deep convection scheme, and merely modified a little by disabling cloud‐base radiation (heating of cloud base). This strong dependence of transient behavior in 1D on this parameter will be tested in the second part of this work, in which SCAM is coupled to a parameterized dynamics of two‐dimensional, linearized gravity wave, and in the 3D simulations in future study.more » « less
-
Abstract Idealized models can reveal insights into Earth’s climate system by reducing its complexities. However, their potential is undermined by the scarcity of fully coupled idealized models with components comparable to contemporary, comprehensive Earth System Models. To fill this gap, we compare and contrast the climates of two idealized planets which build on the Simpler Models initiative of the Community Earth System Model (CESM). Using the fully coupled CESM, the Aqua configuration is ocean‐covered except for two polar land caps, and the Ridge configuration has an additional pole‐to‐pole grid‐cell‐wide continent. Contrary to most sea surface temperature profiles assumed for atmosphere‐only aquaplanet experiments with the thermal maximum on the equator, the coupled Aqua configuration is characterized by a global cold belt of wind‐driven equatorial upwelling, analogous to the eastern Pacific cold tongue. The presence of the meridional boundary on Ridge introduces zonal asymmetry in thermal and circulation features, similar to the contrast between western and eastern Pacific. This zonal asymmetry leads to a distinct climate state from Aqua, cooled by ∼2°C via the radiative feedback of clouds and water vapor. The meridional boundary of Ridge is also crucial for producing a more Earth‐like climate state compared to Aqua, including features of atmospheric and ocean circulation, the seasonal cycle of the Intertropical Convergence Zone, and the meridional heat transport. The mean climates of these two basic configurations provide a baseline for exploring other idealized ocean geometries, and their application for investigating various features and scale interactions in the coupled climate system.more » « less
-
Abstract This study investigates the formation mechanism of the ocean surface warming pattern in response to a doubling CO2with a focus on the role of ocean heat uptake (or ocean surface heat flux change, ΔQnet). We demonstrate that thetransientpatterns of surface warming and rainfall change simulated by the dynamic ocean–atmosphere coupled model (DOM) can be reproduced by theequilibriumsolutions of the slab ocean–atmosphere coupled model (SOM) simulations when forced with the DOM ΔQnetdistribution. The SOM is then used as a diagnostic inverse modeling tool to decompose the CO2-induced thermodynamic warming effect and the ΔQnet(ocean heat uptake)–induced cooling effect. As ΔQnetis largely positive (i.e., downward into the ocean) in the subpolar oceans and weakly negative at the equator, its cooling effect is strongly polar amplified and opposes the CO2warming, reducing the net warming response especially over Antarctica. For the same reason, the ΔQnet-induced cooling effect contributes significantly to the equatorially enhanced warming in all three ocean basins, while the CO2warming effect plays a role in the equatorial warming of the eastern Pacific. The spatially varying component of ΔQnet, although globally averaged to zero, can effectively rectify and lead to decreased global mean surface temperature of a comparable magnitude as the global mean ΔQneteffect under transient climate change. Our study highlights the importance of air–sea interaction in the surface warming pattern formation and the key role of ocean heat uptake pattern.more » « less
-
Abstract Assessing uncertainty in future climate projections requires understanding both internal climate variability and external forcing. For this reason, single‐model initial condition large ensembles (SMILEs) run with Earth System Models (ESMs) have recently become popular. Here we present a new 20‐member SMILE with the Energy Exascale Earth System Model version 1 (E3SMv1‐LE), which uses a “macro” initialization strategy choosing coupled atmosphere/ocean states based on inter‐basin contrasts in ocean heat content (OHC). The E3SMv1‐LE simulates tropical climate variability well, albeit with a muted warming trend over the twentieth century due to overly strong aerosol forcing. The E3SMv1‐LE's initial climate spread is comparable to other (larger) SMILEs, suggesting that maximizing inter‐basin ocean heat contrasts may be an efficient method of generating ensemble spread. We also compare different ensemble spread across multiple SMILEs, using surface air temperature and OHC. The Community Earth system Model version 1, the only ensemble which utilizes a “micro” initialization approach perturbing only atmospheric initial conditions, yields lower spread in the first ∼30 years. The E3SMv1‐LE exhibits a relatively large spread, with some evidence for anthropogenic forcing influencing spread in the late twentieth century. However, systematic effects of differing “macro” initialization strategies are difficult to detect, possibly resulting from differing model physics or responses to external forcing. Notably, the method of standardizing results affects ensemble spread: control simulations for most models have either large background trends or multi‐centennial variability in OHC. This spurious disequlibrium behavior is a substantial roadblock to understanding both internal climate variability and its response to forcing.more » « less
