skip to main content
US FlagAn official website of the United States government
dot gov icon
Official websites use .gov
A .gov website belongs to an official government organization in the United States.
https lock icon
Secure .gov websites use HTTPS
A lock ( lock ) or https:// means you've safely connected to the .gov website. Share sensitive information only on official, secure websites.

Explore Research Products in the PAR
It may take a few hours for recently added research products to appear in PAR search results.


Title: DC Polarity Control in Radio Frequency Synchronous Rectifier Circuits
In this letter, two different switching modes are identified for RF synchronous rectifier circuits which lead to a change in the polarity of the rectified output voltage. The operation of the two modes is defined in terms of the dynamic current-voltage (I-V) characteristics of the switching device and the polarity of the output load voltage. In one mode, the dc output voltage is positive and associated with a switching condition where the device is ON in quadrant-III and OFF in quadrant-I. This mode of operation has been reported widely in the literature. In the second mode, the quadrants associated with the on- and off-state are swapped leading to a polarity reversal across the load. Theoretical justification for the two modes is given and the experimental results are shown to confirm the two different switching modes in the synchronous rectifier. Experiments with a GaN inverse class-F rectifier were made to verify the theory, and both modes have similar measured peak rectification efficiencies of 77% at a frequency of 1.8 GHz.  more » « less
Award ID(s):
1705026
PAR ID:
10057552
Author(s) / Creator(s):
; ;
Date Published:
Journal Name:
IEEE microwave and wireless components letters
Volume:
27
Issue:
12
ISSN:
1531-1309
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. ; (, 2020 IEEE 21st Workshop on Control and Modeling for Power Electronics (COMPEL))
    null (Ed.)
    In wireless power transfer (WPT) applications, the multi-level switched capacitor topology achieves significant advantages in terms of efficiency, system loading, THD, and output regulation. The topology requires dual-loop control in order to harness these benefits. First, a small signal discrete time model for the 7-level rectifier WPT system is developed. Then, a control loop is designed that enables the rectifier to regulate DC load voltage by varying its modulation scheme. Next, the WPT carrier frequency is sensed and a phase-locked loop is used in combination with the small signal power stage model to design a closed-loop controller that synchronizes frequency and regulates control phase through adjustments of the switching period. Finally, cross-coupling interactions between the two control loops are modeled, and stable dual-loop operation is shown. 
    more » « less
  2. ; ; ; ; (, IEEE Transactions on Power Electronics)
    This article proposes a matrix auto-transformer switched-capacitor dc–dc converter to achieve a high voltage conversion ratio, high efficiency, and high power density for 48-V data-center applications. On the high-voltage side, the proposed converter can fully leverage the benefits of high-performance low voltage stress devices similar to the multilevel modular switched-capacitor converter. Compared with the traditional isolated LLC converter with a matrix transformer, the proposed solution utilized a matrix autotransformer concept with merged primary and secondary side windings, thus leading to reduced transformer winding loss. The resonant inductor could be integrated into the transformer similar to the LLC converter. Because of the matrix autotransformer design, it can achieve a current doubler rectifier on the low voltage side. For less than 8-V low output voltage application, the current doubler rectifier design can fully utilize the best figure-of-merit 25-V device, which is more efficient than the full-bridge rectifier solution using two 25-V devices during the operation. All the devices can achieve zero voltage switching or zero current switching and can be naturally clamped without additional clamping circuits. A 500-W 48-V to 6-V dc–dc converter hardware prototype has been developed with optimized device selection and integrated matrix autotransformer design. Both simulation and experiment results have been provided to validate the features and benefits of the proposed converter. The maximum efficiency of the proposed converter can reach 98.33%. 
    more » « less
  3. ; (, physica status solidi (a))
    A diode is fabricated using poly(3,4‐ethylenedioxythiophene) doped with poly(styrene sulfonic acid) (PEDOT‐PSS) and n‐doped Si. Using an ionic liquid (IL) gel as the gate dielectric, the diode rectification ratio is tunable up to four orders of magnitude at very low operating voltages. Both p–n and Schottky type diodes are observed in the same device depending on the polarity of the gate voltage. IL‐gated electrostatic/electrochemical doping in PEDOT‐PSS is believed to be responsible for this switch. The turn‐on voltage in the first quadrant of the current–voltage (I–V) curve for the p–n diode is in the range 0.2–0.4 V. The Schottky diode operates in the third quadrant. This is the first report on a tunable diode using an IL to control its operation, and the low operating voltages make these diodes excellent candidates for use in reduced power consumption electronics. 
    more » « less
  4. ; ; ; ; (, 2017 IEEE Energy Conversion Congress and Exposition (ECCE))
    The focus of this study is on the design of a full-bridge unidirectional resonant LLC Solid State Transformer. The proposed topology uses a high-frequency transformer to optimize the size and weight of the converter. This converter has the capability of operating at fluctuating load conditions while it keeps the voltage regulated in different operation point. The converter is designed to maintain soft switching by using a resonant circuit in this design to minimize the switching loss of the high frequency converter. ZVS in the leading leg for turn on mode and ZCS commutation in the lagging leg for all of the modes are achieved in the H-bridge through the suggested circuitry which is analyzed mathematically in detail in this study. A combination of Pulse frequency modulation (PFM) and Phase Shifting Modulation (PSM) are utilized to control this resonant converter. The experimental setup for the suggested configuration was implemented and the results of the simulation and calculations have been verified with test results. The hardware set up was tested with two different power levels and the output results confirm that the control method works properly to feed the load and keeps the converter working in the expected frequency range and maintaining the soft switching to decrease switching loss. The results shows conversion efficiency of 97.18% is achieved. 
    more » « less
  5. ; ; (, IEEE Transactions on Power Electronics)
    This article proposes a predictive modulation scheme for a differential mode resonant switched capacitor rectifier (DMRSCR) to achieve high efficiency and power factor correction (PFC) for wide voltage gain. The modulation scheme ensures extensive zero-voltage switching (ZVS) turn-ON on all the switches under varying sinusoidal input voltage without requiring additional circuits or sensors. Four key control parameters, namely, phase shift ratio, duty cycle ratios, and switching frequency, are controlled for the converter to maintain ZVS turn-ON, PFC, output voltage regulation, and reduced resonant inductor current ripple. The article outlines a detailed DMRSCR model to deduce the dependency of the four control and converter design parameters on the converter operation. Based on the model, a complete converter design process is provided. A DMRSCR prototype rated at 1.1 kW was built using the underscored design methodology to validate the proposed modulation scheme, reaching a peak efficiency of 98.27% 
    more » « less
  • Citation Formats
  • MLA
  • APA
  • Chicago
  • BibTeX
  • Save / Share this Record
  • Send to Email