An official website of the United States government
Abstract Understanding the chemical and physical properties of particles is an important scientific, engineering, and medical issue that is crucial to air quality, human health, and environmental chemistry. Of special interest are aerosol particles floating in the air for both indoor virus transmission and outdoor atmospheric chemistry. The growth of bio- and organic-aerosol particles in the air is intimately correlated with chemical structures and their reactions in the gas phase at aerosol particle surfaces and in-particle phases. However, direct measurements of chemical structures at aerosol particle surfaces in the air are lacking. Here we demonstrate in situ surface-specific vibrational sum frequency scattering (VSFS) to directly identify chemical structures of molecules at aerosol particle surfaces. Furthermore, our setup allows us to simultaneously probe hyper-Raman scattering (HRS) spectra in the particle phase. We examined polarized VSFS spectra of propionic acid at aerosol particle surfaces and in particle bulk. More importantly, the surface adsorption free energy of propionic acid onto aerosol particles was found to be less negative than that at the air/water interface. These results challenge the long-standing hypothesis that molecular behaviors at the air/water interface are the same as those at aerosol particle surfaces. Our approach opens a new avenue in revealing surface compositions and chemical aging in the formation of secondary organic aerosols in the atmosphere as well as chemical analysis of indoor and outdoor viral aerosol particles.
more »
« less
Extending surface enhanced Raman spectroscopy (SERS) of atmospheric aerosol particles to the accumulation mode (150–800 nm)
Due to their small size, measurements of the complex composition of atmospheric aerosol particles and their surfaces are analytically challenging. This is particularly true for microspectroscopic methods, where it can be difficult to optically identify individual particles smaller than the diffraction limit of visible light (∼350 nm) and measure their vibrational modes. Recently, surface enhanced Raman spectroscopy (SERS) has been applied to the study of aerosol particles, allowing for detection and characterization of previously undistinguishable vibrational modes. However, atmospheric particles analyzed via SERS have primarily been >1 μm to date, much larger than the diameter of the most abundant atmospheric aerosols (∼100 nm). To push SERS towards more relevant particle sizes, a simplified approach involving Ag foil substrates was developed. Both ambient particles and several laboratory-generated model aerosol systems (polystyrene latex spheres (PSLs), ammonium sulfate, and sodium nitrate) were investigated to determine SERS enhancements. SERS spectra of monodisperse, model aerosols between 400–800 nm were compared with non-SERS enhanced spectra, yielding average enhancement factors of 10 2 for both inorganic and organic vibrational modes. Additionally, SERS-enabled detection of 150 nm size-selected ambient particles represent the smallest individual aerosol particles analyzed by Raman microspectroscopy to date, and the first time atmospheric particles have been measured at sizes approaching the atmospheric number size distribution mode. SERS-enabled detection and identification of vibrational modes in smaller, more atmospherically-relevant particles has the potential to improve understanding of aerosol composition and surface properties, as well as their impact on heterogeneous and multiphase reactions involving aerosol surfaces.
more »
« less
- Award ID(s):
- 1654149
- PAR ID:
- 10118787
- Date Published:
- Journal Name:
- Environmental Science: Processes & Impacts
- Volume:
- 20
- Issue:
- 11
- ISSN:
- 2050-7887
- Page Range / eLocation ID:
- 1570 to 1580
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Surface-enhanced Raman spectroscopy (SERS) has great potential as an analytical technique for environmental analyses. In this study, we fabricated highly porous gold (Au) supraparticles ( i.e. , ∼100 μm diameter agglomerates of primary nano-sized particles) and evaluated their applicability as SERS substrates for the sensitive detection of environmental contaminants. Facile supraparticle fabrication was achieved by evaporating a droplet containing an Au and polystyrene (PS) nanoparticle mixture on a superamphiphobic nanofilament substrate. Porous Au supraparticles were obtained through the removal of the PS phase by calcination at 500 °C. The porosity of the Au supraparticles was readily adjusted by varying the volumetric ratios of Au and PS nanoparticles. Six environmental contaminants (malachite green isothiocyanate, rhodamine B, benzenethiol, atrazine, adenine, and gene segment) were successfully adsorbed to the porous Au supraparticles, and their distinct SERS spectra were obtained. The observed linear dependence of the characteristic Raman peak intensity for each environmental contaminant on its aqueous concentration reveals the quantitative SERS detection capability by porous Au supraparticles. The limit of detection (LOD) for the six environmental contaminants ranged from ∼10 nM to ∼10 μM, which depends on analyte affinity to the porous Au supraparticles and analyte intrinsic Raman cross-sections. The porous Au supraparticles enabled multiplex SERS detection and maintained comparable SERS detection sensitivity in wastewater influent. Overall, we envision that the Au supraparticles can potentially serve as practical and sensitive SERS devices for environmental analysis applications.more » « less
-
Secondary organic aerosol (SOA) is a significant component of atmospheric fine particulate matter (PM2.5) globally that can form through multiphase chemistry of oxidized volatile organic compounds (VOC) leading to lower‐volatility particulate species. Condensed phase reactions of certain SOA constituents with inorganic sulfate derived from SO2 oxidation will lead to the formation of organosulfates, which can account for up to 10 – 15% of the organic mass within PM2.5. Despite the ubiquitous presence of atmospheric fine particulate organosulfates, our fundamental understanding of the molecular structure of organosulfates is limited, including for 2‐methyltetrol organosulfates (2‐MTSs), which are typically the single most abundant organosulfates measured in PM2.5, formed from isoprene oxidation products. As atmospheric aerosol pH varies widely (0 – 6), it is important to know whether organosulfates exist primarily in their protonated (ROSO3H) or deprotonated (ROSO3 ‐) forms. In this study, vibrational modes of synthetically‐pure 2‐MTSs were spectroscopically probed using Raman and infrared (IR) spectroscopies, supported by density functional theory (DFT) of the protonated and deprotonated structures. Vibrational bands at 1035 and 1059 cm‐1 were seen in both the IR and Raman spectra, and were associated with the ROSO3 ‐ anion by comparison to DFT calculations. Analysis of Raman spectra across a range of acidities (pH = 0 – 10) shows that 2‐MTSs are deprotonated (ROSO3 ‐) at those pH values. Additional DFT calculations for organosulfates derived from isoprene, α‐pinene, β‐caryophyllene, and toluene suggest that most organosulfates exist in their deprotonated form (ROSO3 ‐) in atmospheric particles. These charged species may have significant implications for our understanding of aerosol acidity and should be considered in thermodynamic model calculations.more » « less
-
Chen, Zan (Ed.)Inelastic scattering from molecules because of vibrational modes produces unique Raman shifts, allowing these analytes to be detected with high specificity. Because Raman scattering is weak, surface-enhanced Raman scattering (SERS) has been used as a label-free technique for the detection of a variety of analytes at low concentrations. Using simple solution-based colloidal processing techniques, we have fabricated gold-coated carbon-black nanoparticles that show enhanced Raman activity. By varying the fabrication conditions, we create particles of different surface morphologies, allowing control over the peak wavelength for localized surface plasmon resonance (LSPR). By matching the LSPR wavelength to the incident laser wavelength, we get the highest signal from two model analytes, 4-nitrobenzenethiol (4-NBT) and Congo Red (CR). Our straightforward room temperature solution-based approach for making tunable SERS-active particles expands the range of incident radiation wavelengths that can be used for the detection of analytes using Raman scattering.more » « less
-
Mubarak, Nabisab M.; Walvekar, Rashmi; Arshid, Numan; and Khalid, Mohammad (Ed.)Metal oxides are useful for the detection and sensing of combustible and toxic gases, and for use in lithium batteries and solar cells. The present study focuses on the spectroscopic investigation of commercial and in-house laboratory synthesized tetragonal tin dioxide (SnO2), aimed at studying its physical and chemical properties at nanoscale levels and in bulk. We have investigated the pure powder form and thin films prepared on two different types of substrate, silicon and UV-Quartz, each with five different thicknesses (i.e. 41, 78, 96.5, 373, and 908 nm). Raman spectroscopy with two different laser excitation wavelengths, namely 780 and 532 nm, has been used to investigate the various SnO2 vibrational modes. Thermal effects on the primary vibrational features in the Raman spectra have been studied in the range 30–170 °C. X-ray diffraction (XRD) spectra have been recorded to confirm the rutile structure of tin dioxide and to obtain information on the spherical grain particle size of SnO2 with EDS analysis for the thin film samples. Scanning Electron Microscope (SEM) images have been recorded in order to understand the morphology of the particles of SnO2 at the nanoscale level. In addition, FT-IR spectra have been obtained to study the IR-active vibrational modes for the bulk and thin film samples on the two substrates. Moreover, UV-VIS spectra have been employed to determine the energy band gap for the SnO2 film samples by an efficient process facilitated by a Tauc plot technique utilizing an in-house developed python script.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1039/c8em00276b
