Second-order ripples occur in the voltage and current during any DC–AC power conversion. These conversions occur in the voltage source inverters (VSIs), current source inverters (CSIs), and various single-stage inverters (SSIs) topologies. The second-order ripples lead to oscillating source node currents and DC bus voltages when there is an interconnection between the AC and DC microgrids or when an AC load is connected to the DC bus of the microgrid. Second-order ripples have various detrimental effects on the sources and the battery storage. In the storage battery, they lead to the depletion of electrodes. They also lead to stress in the converter or inverter components. This may lead to the failure of a component and hence affect the reliability of the system. Furthermore, the second-order ripple currents (SRCs) lead to ripple torque in wind turbines and lead to mechanical stress. SRCs cause a rise in the temperature of photovoltaic panels. An increase in the temperature of PV panels leads to a reduction in the power generated. Furthermore, the second-order voltage and current oscillations lead to a varying maximum power point in PV panels. Hence, the maximum power may not be extracted from it. To mitigate SRCs, oversizing of the components is needed. To improve the lifespan of the sources, storage, and converter components, the SRCs must be mitigated or kept within the desired limits. In the literature, different methodologies have been proposed to mitigate and regulate these second-order ripple components. This manuscript presents a comprehensive review of different effects of second-order ripples on different sources and the methodologies adopted to mitigate the ripples. Different active power decoupling methodologies, virtual impedance-based methodologies, pulse width modulation-based signal injection methodologies, and control methods adopted in distributed power generation methods for DC microgrids have been presented. The application of ripple control methods spans from single converters such as SSIs and VSIs to a network of interconnected converters. Furthermore, different challenges in the field of virtual impedance control and ripple mitigation in distributed power generation environments are discussed. This paper brings a review regarding control methodologies to mitigate and regulate second-order ripples in DC–AC conversions and microgrids.
more »
« less
Chill Out: Freezing Attacks on Capacitors and DC/DC Converters
This paper introduces a non-invasive, low-cost, and trace-free capacitor freezing attack on DC/DC converters, which uses off-the-shelf electronics cooling sprays to rapidly decrease the capacitors' temperature. Due to the temperature drop, the converters are unable to maintain their specified output voltages, and their transient behavior changes. When the attack has finished, the temperature of the capacitors quickly returns to normal, while any evidence of the attack vanishes.
more »
« less
- Award ID(s):
- 1901901
- NSF-PAR ID:
- 10225315
- Date Published:
- Journal Name:
- European Test Symposium (ETS)
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
This paper presents a new dual inductor hybrid converter (DIHC) that is capable of efficient direct non-isolated DC-DC conversions with extremely large voltage conversion ratios. The converter employs two interleaved inductors and a switched-capacitor (SC) network to bring several significant topological benefits. Capacitance of the flying capacitors of this new topology can be optimally sized to achieve natural, complete soft-charging for all capacitors. This novel capacitor soft-charging feature is a key contribution of this work and can be exploited to overcome the limitations of conventional SC converters suffering from capacitor hard charging losses. The converter topology and its operation are verified in an 36-W converter prototype for 40-120V input to 0.9V-1.8V output up to 20A of current load that achieves peak efficiencies of 91.5% for 120V-to-1.8V and 87.3% for 120V-to-0.9V conversion. Its advantages and performance at extreme conversion ratios push the limit of point-of-load converters, reducing complexity and cost for bus voltage distributions, as well as enabling fewer conversion stages and thus higher efficiency for data centers and high-performance digital systems.more » « less
-
null (Ed.)Efficient high-conversion-ratio power delivery is needed for many portable computing applications which require sub-volt supply rails but operate from batteries or USB power sources. In such applications, the power management unit should have a small volume, area, and height while providing fast transient response. Past work has shown favorable performance of hybrid switched-capacitor (SC) converters to reduce the size of needed inductor(s), which can soft-charge high-density SC networks while supporting efficient voltage regulation [1-5]. However, the hybrid approach has its own challenges including balancing the voltage of the flying capacitor and achieving safe but fast startup. Rapid supply transients, including startup, can cause voltage stress on power switches if flying capacitors are not quickly regulated. Past approaches such as precharge networks [3] or fast balancing control [5] have startup times that are on the order of milliseconds. This paper presents a two-stage cascaded hybrid SC converter that features a fast transient response with automatic flying capacitor balancing for low-voltage applications (i.e., 5V:0.4 to 1.2V from a USB interface). The converter is nearly standalone and all gate drive supplies are generated internally. Measured results show a peak efficiency of 96.9%, <; 36mV under/overshoot for 1A/μs load transients, and self-startup time on the order of 10μs (over 100× faster than previous works).more » « less
-
more » « less
Summary Inductive power transfer has become an emerging technology for its significant benefits in many applications, including mobile phones, laptops, electric vehicles, implanted bio‐sensors, and internet of things (IoT) devices. In modern applications, a direct current–direct current (DC–DC) converter is one of the essential components to regulate the output supply voltage for achieving the desired characteristics, that is, steady voltage with lower peak ripples. This paper presents a switched‐capacitor (SC) DC–DC converter using complementary architecture to provide a regulated DC voltage with an increased dynamic response. The proposed topology enhances the converter efficiency by decreasing the equivalent output resistance to half by connecting two symmetric SC single ladder converters. The proposed converter is designed using the standard 130‐nm BiCMOS process. The results show that the proposed architecture produces 327‐mV DC output with a rise time of 60.1 ns and consumes 3.449‐nW power for 1.0‐V DC supply. The output settling time is 43.6% lower than the single‐stage SC DC–DC converter with an input frequency of 200 MHz. The comparison results show that the proposed converter has a higher power conversion efficiency of 93.87
% and a lower power density of 0.57 mW/mm2compared to the existing works. -
This paper proposes a unified distributed secondary control for the grid-forming (GFM) and grid-feeding (GFE) converters in DC microgrids. An optimization problem is formulated for the secondary control and the objective function considers regulating the global average of the GFM and GFE converter output voltages and proportional current sharing among all GFM and GFE converters. A unified distributed control is then designed to generate voltage and current references respectively for GFM and GFE converters based on the formulated optimization problem. The dynamic model of the DC microgrid under the proposed control is also developed, and steady-state analysis is performed to show that the proposed distributed control can achieve the control objectives in steady state. The performance of the proposed control is validated through real-time simulations in OPAL-RT on an 8-DG DC microgrid system.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Conference Paper:
- The DOI is not currently available.
