An official website of the United States government
Abstract. The hydrology of thawing permafrost affects the fate of the vast amount of permafrost carbon due to its controls on waterlogging, redox status, and transport. However, regional mapping of soil water storage in the soil layer that experiences the annual freeze-thaw cycle above permafrost, known as the active layer, remains a formidable challenge over remote arctic regions. This study shows that Interferometric Synthetic Aperture Radar (InSAR) observations can be used to estimate the amount of soil water originating from the active layer seasonal thaw. Our ALOS InSAR results, validated by in situ observations, show that the thickness of the soil water that experiences the annual freeze-thaw cycle ranges from 0 to 75 cm in a 60-by-100-km area near the Toolik Field Station on the North Slope of Alaska. Notably, the spatial distribution of the soil water correlates with surface topography and land vegetation cover types. We found that pixel-mismatching of the topographic map and radar images is the primary error source in the Toolik ALOS InSAR data. The amount of pixel misregistration, the local slope, and the InSAR perpendicular baseline influence the observed errors in InSAR Line-Of-Sight (LOS) distance measurements non-linearly. For most of the study area with a percent slope of less than 5%, the LOS error from pixel misregistration is less than 1 cm, translating to less than 14 cm of error in the soil water estimates.
more »
« less
Extraction of Absolute Water Level Using TanDEM-X Bistatic Observations With a Large Perpendicular Baseline
The application of Wetland synthetic aperture radar interferometry (InSAR) has often been restricted in practical hydrological monitoring because it is based on relative estimates of water level changes between two synthetic aperture radar acquisitions, as opposed to absolute water levels obtained by ground measurements. TanDEM-X bistatic observations can provide absolute water level estimates using simultaneous phase measurements by a two-satellite constellation with TerraSAR-X. We evaluated two datasets of TanDEM-X bistatic observations acquired during an experimental science phase on August 26 and 31, 2015, with a very large baseline configuration to extract absolute water levels of Everglades wetland in southern Florida, USA. The perpendicular baselines are 1.43 and 1.36 km, and the ambiguities of height were calculated as 3.61 and 3.90 m in each interferometric pair, respectively. Hourly water level measurements provided by the Everglades depth estimation network (EDEN) were used to verify the estimated absolute water levels. Several stage stations located in densely vegetated areas that showed incoherence were excluded from the verification as outliers. The verification results show an excellent agreement (degree of determination > 0.95) between the InSAR derived absolute water levels and the stage station measurements. The root mean square error (RMSE) between the TanDEM-X results and stage records was 0.77 and 0.66 m, respectively. Severe volume decorrelations over the vegetated area, owing to the large perpendicular baselines, were detected, despite near zero temporal baseline of the bistatic observations. The absolute water levels can be used as excellent constraints for wetland surface flow models.
more »
« less
- PAR ID:
- 10300920
- Date Published:
- Journal Name:
- IEEE Geoscience and Remote Sensing Letters
- ISSN:
- 1545-598X
- Page Range / eLocation ID:
- 1 to 5
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Using interferometric synthetic aperture radar (InSAR) to observe slow ground deformation can be challenging due to many sources of error, with tropospheric phase delay and unwrapping errors being the most significant. While analytical methods, weather models, and data exist to mitigate tropospheric error, most of these techniques are unsuitable for all InSAR applications (e.g., complex tropospheric mixing in the tropics) or are deficient in spatial or temporal resolution. Likewise, there are methods for removing the unwrapping error, but they cannot resolve the true phase when there is a high prevalence (>40%) of unwrapping error in a set of interferograms. Applying tropospheric delay removal techniques is unnecessary for C-band Sentinel-1 InSAR time series studies, and the effect of unwrapping error can be minimized if the full dataset is utilized. We demonstrate that using interferograms with long temporal baselines (800 days to 1600 days) but very short perpendicular baselines (<5 m) (LTSPB) can lower the velocity detection threshold to 2 mm y−1 to 3 mm y−1 for long-term coherent permanent scatterers. The LTSPB interferograms can measure slow deformation rates because the expected differential phases are larger than those of small baselines and potentially exceed the typical noise amplitude while also reducing the sensitivity of the time series estimation to the noise sources. The method takes advantage of the Sentinel-1 mission length (2016 to present), which, for most regions, can yield up to 300 interferograms that meet the LTSPB baseline criteria. We demonstrate that low velocity detection can be achieved by comparing the expected LTSPB differential phase measurements to synthetic tests and tropospheric delay from the Global Navigation Satellite System. We then characterize the slow (~3 mm/y) ground deformation of the Socorro Magma Body, New Mexico, and the Tampa Bay Area using LTSPB InSAR analysis. The method we describe has implications for simplifying the InSAR time series processing chain and enhancing the velocity detection threshold.more » « less
-
null (Ed.)Extensive efforts have been made to observe the accumulation and melting of seasonal snow. However, making accurate observations of snow water equivalent (SWE) at global scales is challenging. Active radar systems show promise, provided the dielectric properties of the snowpack are accurately constrained. The dielectric constant (k) determines the velocity of a radar wave through snow, which is a critical component of time-of-flight radar techniques such as ground penetrating radar and interferometric synthetic aperture radar (InSAR). However, equations used to estimate k have been validated only for specific conditions with limited in situ validation for seasonal snow applications. The goal of this work was to further understand the dielectric permittivity of seasonal snow under both dry and wet conditions. We utilized extensive direct field observations of k, along with corresponding snow density and liquid water content (LWC) measurements. Data were collected in the Jemez Mountains, NM; Sandia Mountains, NM; Grand Mesa, CO; and Cameron Pass, CO from February 2020 to May 2021. We present empirical relationships based on 146 snow pits for dry snow conditions and 92 independent LWC observations in naturally melting snowpacks. Regression results had r2 values of 0.57 and 0.37 for dry and wet snow conditions, respectively. Our results in dry snow showed large differences between our in situ observations and commonly applied equations. We attribute these differences to assumptions in the shape of the snow grains that may not hold true for seasonal snow applications. Different assumptions, and thus different equations, may be necessary for varying snowpack conditions in different climates, suggesting that further testing is necessary. When considering wet snow, large differences were found between commonly applied equations and our in situ measurements. Many previous equations assume a background (dry snow) k that we found to be inaccurate, as previously stated, and is the primary driver of resulting uncertainty. Our results suggest large errors in SWE (10–15%) or LWC (0.05–0.07 volumetric LWC) estimates based on current equations. The work presented here could prove useful for making accurate observations of changes in SWE using future InSAR opportunities such as NISAR and ROSE-L.more » « less
-
Highway slopes are susceptible to various geohazards, including landslides, rockfalls, and soil creep, necessitating early detection to minimize disruptions, prevent collisions, and ensure road safety. Conventional methods, such as visual inspections and periodic surveys, may overlook subtle changes or fail to provide timely alerts. This research aims to enhance slope movement and instability detection by leveraging advanced remote-sensing technologies such as interferometric synthetic aperture radar (InSAR), light detection and ranging (LiDAR), and uncrewed aerial vehicles (UAV). The primary objective is to develop an integrated approach combining multiple data sources to detect and predict highway slope movement effectively. InSAR offers surface deformation measurements over time, capturing nuanced slope movements, while LiDAR and UAVs provide high-resolution elevation information, including slope angles, curvature, and vegetation cover. This study explores methods to integrate these complementary data sets to validate the slope movement detection from InSAR. The research involves establishing a baseline ground motion scenario using historical open-access Sentinel-1 satellite data spanning 10 years (20182024) for the central Mississippi region, characterized by expansive clay prone to volume changes, then comparing the ground motions with those observed from near-surface remote sensing. The baseline ground motion scenario is compared with ground truthing from near-surface remote sensing surveys conducted by LiDAR and UAV photogrammetry. The point cloud and imagery obtained from LiDAR and UAVs facilitated cross-verification and validation of the InSAR ground displacements. This study provides a comprehensive and innovative methodology for monitoring highway infrastructure using InSAR and near-surface remote sensing techniques such as LiDAR and UAV. Continuous ground motion analysis provides immediate feedback on slope performance, helping to prevent potential failures. LiDAR change detection allows for detailed evaluation of highway slopes and precise identification of potential failure locations. Integrating remote sensing techniques into geotechnical asset management programs is crucial for proactively assessing risks and enhancing highway safety and resilience. Future studies will use this data set to create finite-element-based numerical models, aiding in developing surrogate models for highway embankments based on observed InSAR ground motion patterns. This study will also serve as a foundation for future machine-learning classification models for detecting vulnerable geo-infrastructure assets.more » « less
-
Abstract We explore the potential for repeat‐pass SAR Interferometry (InSAR) correlation to track volcanic activity on Venus' surface motivated by future SAR missions to Earth's sister planet. We use Hawai'i as a natural laboratory to test whether InSAR can detect lava flows assuming orbital and instrument parameters similar to that of a Venus mission. Hawai'i was chosen because lava flows are frequent, and well documented by the United States Geological Survey, and because Hawai'i is a SAR supersite, where space agencies have offered open radar data sets for analysis. These data sets have different wavelengths (L, C, and X bands), bandwidths, polarizations, look angles, and a variety of orbital baselines, giving opportunity to assess the suitability of parameters for detecting lava flows. We analyze data from ALOS‐2 (L‐band), Sentinel‐1 (C‐band), and COSMO‐SkyMed (X‐band) spanning 2018 and 2022. We perform SAR amplitude and InSAR correlation analysis over temporal baselines and perpendicular baselines similar to those of a Venus mission. Fresh lava flows create a sharp, noticeable decrease in InSAR correlation that persists indefinitely for images spanning the event. The same lava flows are not always visible in the corresponding amplitude images. Moreover, noticeable decorrelation persists in image pairs acquired months after the events due to post‐emplacement contraction of flows. Post‐emplacement effects are hypothesized to last longer on the Venusian surface, increasing the likelihood of detecting Venus lava flows using InSAR. We argue for further focus on repeat‐pass InSAR capabilities in upcoming Venus missions, to detect and quantify volcanic activity on Earth's hotter twin.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1109/LGRS.2021.3086875
