An official website of the United States government
Subglacial till can deform when overriding ice exerts shear traction at the ice–till interface. This deformation leaves a strain signature in the till, aligning grains in the direction of ice flow and producing a range of diagnostic microstructures. Constraining the conditions that produce these kinematic indicators is key to interpreting the myriad of features found in basal till deposits. Here, we used a cryogenic ring shear device with transparent sample chamber walls to slip a ring of temperate ice over a till bed from which we examined the strain signature in the till. We used cameras mounted to the side of the ring shear and bead strings inserted in the till to estimate the strain distribution within the till layer. Following the completion of the experiment, we extracted and analyzed anisotropy of magnetic susceptibility (AMS) samples and created thin sections of the till bed for microstructure analysis. We then compared the AMS and microstructures with the observed strain history to examine the relationship between kinematic indicators and strain in a setting where shear traction is supplied by ice. We found that AMS fabrics show a high degree of clustering in regions of high strain near the ice–till interface. In the uppermost zone of till, k 1 eigenvector azimuths are generally aligned with ice flow, and S 1 eigenvalues are high. However, S 1 eigenvalues and the alignment of the k 1 eigenvector with ice flow decrease nonlinearly with distance from the ice–till interface. There is a high occurrence of microshears in the zone of increased deformation.
more »
« less
Magnetic Fabrics and Petrography of Rocksalts Reveal Preferred Orientation of Anhydrites within a Halite Matrix
We investigate the magnetic fabrics and microstructures of diamagnetic rocksalt samples from the Sedom salt wall (diapir), Dead Sea Basin, as possible strain markers. A comprehensive study of anisotropy of magnetic susceptibility (AMS), combined with magnetic, microtextural, geochemical and mineralogical analyses allows us to depict the deformation mechanisms and to reveal the mineral sources of the AMS. The rocksalts are composed of halite as the major mineral phase (>80%) and anhydrite as a minor phase (5–20%), and have an average magnetic susceptibility value of −13.4 ± 0.7 × 10−6 SI. Ferromagnetic and paramagnetic minerals make a negligible contribution to the bulk magnetic properties of the samples. The AMS indicates and reveals significant anisotropy with the maximum susceptibility axis (K1) subparallel to the bedding strike, although the cubic halite crystals are isotropic. Polarizing microscope and SEM images show preferred alignment of needle-like anhydrite crystals parallel to the direction of the K1 axis. Petrographic investigation of gamma irradiated thin sections reveals the deformation recorded in the microstructures of the rocksalts and points to a dominant contribution by dislocation creep, although both dislocation creep and pressure solution were active deformation mechanisms. We infer that during dislocation creep, the thin bands of anhydrite crystals deform along with the surrounding halite grains. We suggest that although the shape preferred orientation of halite grains is not indicative of finite strain because of resetting by grain boundary migration, the preferred orientation of the anhydrite crystals may be. These results suggest that the AMS of the rocksalts provides a textural proxy that reflects deformation processes of the rocksalts, despite their very low magnetic susceptibility.
more »
« less
- Award ID(s):
- 1642268
- PAR ID:
- 10318852
- Date Published:
- Journal Name:
- Minerals
- Volume:
- 12
- Issue:
- 2
- ISSN:
- 2075-163X
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Mantle xenoliths from the Southern Alps, New Zealand, provide insight into the origin of mantle seismic anisotropy related to the Australian‐Pacific plate boundary. Most xenoliths from within 100 km lateral distance of the Alpine Fault are coarse grained, but a small number are finer grained protomylonites. The protomylonites contain connected networks of fine grains with a different crystallographic preferred orientation (CPO) to coarse porphyroclasts in the same xenolith, suggesting that protomylonites and coarse‐grained samples record different deformation kinematics. The CPOs of fine grains in protomylonites have monoclinic symmetry, with the 2‐fold rotation axis normal to a plane that contains olivine [010] and orthopyroxene [100] maxima, suggesting that the protomylonite deformation involved significant simple shear. Some coarse‐grained samples contain unconnected lenses and layers of fine grains with the same CPO as the coarse grains. Microstructures suggest that these fine grains formed by subgrain rotation recrystallization and that protomylonites may represent an up‐strain progression of this microstructure, where the connectivity of fine grains has allowed them to localize shear and develop a new Alpine Fault CPO. The samples tell us about the state of the mantle at 25 Ma, in the early history of the plate boundary. If this suite of samples is representative of the mantle beneath the Alpine Fault in the present day, then we can interpret the complex seismic anisotropy patterns in the lithospheric mantle as representative of blocks containing variably rotated older CPOs juxtaposed by narrow shear zones associated with Alpine Fault deformation.more » « less
-
null (Ed.)Abstract We performed deformation experiments on dry natural single crystals of magnetite and ilmenite to determine the rheological behavior of these oxide minerals as a function of temperature, orientation, and oxygen fugacity. Samples were deformed at temperatures of 825–1150 $$\,^{\circ }$$ ∘ C to axial strains of up to 15–24% under approximately constant stress conditions up to 120 MPa in a dead-load-type creep rig at ambient pressure in a controlled gas atmosphere. Oxygen fugacity ranged from 10 $$^{-9.4}$$ - 9.4 to 10 $$^{-4}$$ - 4 atm. Ilmenite creep was insensitive to oxygen fugacity, while magnetite displayed a strong, non-monotonic oxygen fugacity dependence, with creep rates varying as $$f_{O_{2}}^{-0.7}$$ f O 2 - 0.7 and $$f_{O_{2}}^{0.4}$$ f O 2 0.4 at more reducing and more oxidizing conditions, respectively. Dislocation creep rates of magnetite single crystals were weakly dependent on crystallographic orientation with stress exponents that varied between 2.8 and 4.3 (mean 3.5 ± 0.4). Magnetite compressed parallel to <100>, <110>, and <111> axes exhibited apparent activation energies of 315±5, 345±30, and 290±5 kJ/mol, respectively. We estimated $${f_O}_2$$ f O 2 -independent magnetite activation energies of 715 ± 150, 725 ± 145, and 690 ± 150 kJ/mol for <100>, <110>, and <111> orientations, respectively, in the region of negative $${f_O}_2$$ f O 2 -dependence. Ilmenite single crystals were compressed parallel, normal, and inclined to the c-axis. Stress exponents of 3.4, 4.3, and 3.9 indicate dislocation creep with activation energies of 420 ± 35, 345 ± 30, and 360 ± 40 kJ/mol, respectively, for these orientations. Mechanical anisotropy in ilmenite is notably higher than in magnetite, as expected from its lower crystal symmetry. Constitutive equations were formulated for ilmenite and magnetite creep.more » « less
-
Abstract Nepheline syenites from the ∼1.2 Ga Ilímaussaq Complex of southern Greenland are examined to assess the utility of anisotropy of magnetic susceptibility (AMS) fabrics as proxies for silicate petrofabrics. Mineral lamination is a relatively common structural feature in cumulate rocks, including in the Ilímaussaq intrusion, but there is little consensus on the process (or processes) responsible for its formation. The Ilímaussaq AMS data are combined with rock magnetic experiments and electron backscatter diffraction (EBSD) measurements to characterize the magnetic mineralogy and compare the magnetic fabrics obtained to the silicate petrofabric. The data show that Na-amphibole (arfvedsonite) is most likely the dominant control on the AMS fabrics in the coarse-grained nepheline syenites (referred to as kakortokites), and that the AMS fabric is inverse relative to the observed silicate fabric. The EBSD data for a kakortokite sample suggests that the petrofabric is defined by arfvedsonite and is wholly planar, with evidence of only weak cross-lineation of c axes. The fine-grained nepheline syenites (lujavrites), two of which have a well-developed lamination carried by Na-pyroxene (aegirine), appear to have composite AMS fabrics that are considered to be a consequence of a mixed aegirine (normal) and arfvedsonite (inverse) response. The combined datasets shed light on the mechanisms of fabric acquisition in both lithologies. In the kakortokites, the AMS fabrics and silicate crystallographic preferred orientations, as well as the lack of observed microstructural evidence for subsolidus intra-crystal deformation, support models invoking gravitationally controlled crystal mats in the development of the macro-rhythmic layering of these rocks. In the lujavrites, the strong planar fabrics revealed by both the AMS and EBSD datasets, with some evidence of subsolidus deformation, point to fabric formation and perhaps even aegirine crystallization at the postcumulus stage. The combination of EBSD and AMS fabric datasets is a powerful means of deciphering the processes responsible for mineral alignment in igneous cumulates.more » « less
-
Abstract Episodic tremor and slow slip (ETS) downdip of the subduction seismogenic zone are poorly understood slip behaviors of the seismic cycle. Talc, a common metasomatic mineral at the subduction interface, is suggested to host slow slip but this hypothesis has not been tested in the rock record. We investigate actinolite microstructures from talc‐bearing and talc‐free rocks exhumed from the depths of modern ETS (Pimu'nga/Santa Catalina Island, California). Actinolite deformed by dissolution‐reprecipitation creep in the talc‐free rock and dislocation creep ± cataclasis in the talc‐bearing rock. This contrast results from stress amplification in the talc‐bearing rock produced by high strain rates in surrounding weak talc. We hypothesize that higher strain rates in the talc‐bearing sample represent episodic slow slip, while lower strain rates in the talc‐free sample represent intervening aseismic creep. This work highlights the need to consider fluid‐mediated chemical change in studies of subduction zone deformation and seismicity.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.3390/min12020192
