This study examines biodegradability (BD) and optimum conditions for the solid-state anaerobic digestion (SS-AD) of organic solid poultry waste (organs, intestines, offal, and unprocessed meat) to maximize biomethane production. Three main parameters, substrate-to-inoculum (S/I) ratio, pH, and temperature, were evaluated for the SS-AD of organic solid poultry waste. pH was evaluated at non-adjusted pH, initially adjusted pH, and controlled pH conditions at a constant S/I ratio of 0.5 and temperature of 35 ± 1 °C. The S/I ratios were examined at (0.3, 0.5, 1, and 2) at a controlled pH of ≈7.9 and temperature of 35 ± 1 °C. The temperature was assessed at mesophilic (35 ± 1 °C) and thermophilic (55 ± 1 °C) conditions with a constant S/I ratio of 0.5 and controlled pH of ≈7.9. The results demonstrate that the highest biomethane production and BD were achieved with a controlled pH of ≈7.9 (689 ± 10 mg/L, 97.5 ± 1.4%). The initially adjusted pH (688 ± 14 mg/L, 97.3 ± 1.9%) and an S/I ratio of 0.3 (685 ± 8 mg/L, 96.8 ± 1.2%) had approximately equivalent outcomes. The thermophilic conditions yielded 78% lower biomethane yield than mesophilic conditions. The challenge of lower biomethane yield under thermophilic conditions will be resolved in future studies by determining the rate-limiting step. These observations highlight that SS-AD is a promising technology for biomethane production from solid organic poultry waste.
more »
« less
Dihydronicotinamide riboside: synthesis from nicotinamide riboside chloride, purification and stability studies
In the present work, we describe an efficient method for scalable synthesis and purification of 1,4-dihydronicotinamide riboside (NRH) from commercially available nicotinamide riboside chloride (NRCl) and in the presence of sodium dithionate as a reducing agent. NRH is industrially relevant as the most effective, synthetic NAD + precursor. We demonstrated that solid phase synthesis cannot be used for the reduction of NRCl to NRH in high yield, whereas a reduction reaction in water at room temperature under anaerobic conditions is shown to be very effective, reaching a 55% isolation yield. For the first time, by using common column chromatography, we were able to highly purify this sensitive bio-compound with good yield. A series of identifications and analyses including HPLC, NMR, LC-MS, FTIR, and UV-vis spectroscopy were performed on the purified sample, confirming the structure of NRH as well as its purity to be 96%. Thermal analysis of NRH showed higher thermal stability compared to NRCl, and with two major weight losses, one at 218 °C and another at 805 °C. We also investigated the long term stability effects of temperature, pH, light, and oxygen (as air) on the NRH in aqueous solutions. Our results show that NRH can be oxidized in the presence of oxygen, and it hydrolyzed quickly in acidic conditions. It was also found that the degradation rate is lower under a N 2 atmosphere, at lower temperatures, and under basic pH conditions.
more »
« less
- Award ID(s):
- 1719875
- PAR ID:
- 10325712
- Date Published:
- Journal Name:
- RSC Advances
- Volume:
- 11
- Issue:
- 34
- ISSN:
- 2046-2069
- Page Range / eLocation ID:
- 21036 to 21047
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Including a multifunctional, bioregenerative algal photobioreactor for simultaneous air revitalization and thermal control may aid in carbon loop closure for long-duration surface habitats. However, using water-based algal media as a cabin heat sink may expose the contained culture to a dynamic, low temperature environment. Including psychrotolerant microalgae, native to these temperature regimes, in the photobioreactor may contribute to system stability. This paper assesses the impact of a cycled temperature environment, reflective of spacecraft thermal loops, to the oxygen provision capability of temperate Chlorella vulgaris and eurythermic Antarctic Chlorophyta. The tested 28-min temperature cycles reflected the internal thermal control loops of the International Space Station ( C . vulgaris , 9–27°C; Chlorophyta-Ant, 4–14°C) and included a constant temperature control (10°C). Both sample types of the cycled temperature condition concluded with increased oxygen production rates ( C . vulgaris ; initial: 0.013 mgO 2 L –1 , final: 3.15 mgO 2 L –1 and Chlorophyta-Ant; initial: 0.653 mgO 2 L –1 , final: 1.03 mgO 2 L –1 ) and culture growth, suggesting environmental acclimation. Antarctic sample conditions exhibited increases or sustainment of oxygen production rates normalized by biomass dry weight, while both C . vulgaris sample conditions decreased oxygen production per biomass. However, even with the temperature-induced reduction, cycled temperature C . vulgaris had a significantly higher normalized oxygen production rate than Antarctic Chlorophyta. Chlorophyll fluorometry measurements showed that the cycled temperature conditions did not overly stress both sample types (F V /F M : 0.6–0.75), but the Antarctic Chlorophyta sample had significantly higher fluorometry readings than its C . vulgaris counterpart ( F = 6.26, P < 0.05). The steady state C . vulgaris condition had significantly lower fluorometry readings than all other conditions (F V /F M : 0.34), suggesting a stressed culture. This study compares the results to similar experiments conducted in steady state or diurnally cycled temperature conditions. Recommendations for surface system implementation are based off the presented results. The preliminary findings imply that both C . vulgaris and Antarctic Chlorophyta can withstand the dynamic temperature environment reflective of a thermal control loop and these data can be used for future design models.more » « less
-
Ligand selectivity to specific lanthanide (Ln) ions is key to the separation of rare earth elements from each other. Ligand selectivity can be quantified with relative stability constants (measured experimentally) or relative binding energies (calculated computationally). The relative stability constants of EDTA (ethylenediaminetetraacetic acid) with La 3+ , Eu 3+ , Gd 3+ , and Lu 3+ were predicted from relative binding energies, which were quantified using electronic structure calculations with relativistic effects and based on the molecular structures of Ln–EDTA complexes in solution from density functional theory molecular dynamics simulations. The protonation state of an EDTA amine group was varied to study pH ∼7 and ∼11 conditions. Further, simulations at 25 °C and 90 °C were performed to elucidate how structures of Ln–EDTA complexes varying with temperature are related to complex stabilities at different pH conditions. Relative stability trends are predicted from computation for varying Ln 3+ ions (La, Eu, Gd, Lu) with a single ligand (EDTA at pH ∼11), as well as for a single Ln 3+ ion (La) with varying ligands (EDTA at pH ∼7 and ∼11). Changing the protonation state of an EDTA amine site significantly changes the solution structure of the Ln–EDTA complex resulting in a reduction of the complex stability. Increased Ln–ligand complex stability is correlated to reduced structural variations in solution upon an increase in temperature.more » « less
-
Nadeem, Habibullah (Ed.)Phytate is a dominant form of organic phosphorus (P) in the environment. Complexation and precipitation with polyvalent metal ions can stabilize phytate, thereby significantly hinder the hydrolysis by enzymes. Here, we studied the stability and hydrolyzability of environmentally relevant metal phytate complexes (Na, Ca, Mg, Cu, Zn, Al, Fe, Al/Fe, Mn, and Cd) under different pHs, presence of metal chelators, and thermal conditions. Our results show that the order of solubility of metal phytate complexes is as follows: i) for metal species: Na, Ca, Mg > Cu, Zn, Mn, Cd > Al, Fe, ii) under different pHs: pH 5.0 > pH 7.5), and iii) in the presence of chelators: EDTA> citric acid. Phytate-metal complexes are mostly resistant towards acid hydrolysis (except Al-phytate), and dry complexes are generally stable at high pressure and temperature under autoclave conditions (except Ca phytate). Inhibition of metal complex towards enzymatic hydrolysis by Aspergillus niger phytase was variable but found to be highest in Fe phytate complex. Strong chelating agents such as EDTA are insufficient for releasing metals from the complexes unless the reduction of metals (such as Fe) occurs first. The insights gained from this research are expected to contribute to the current understanding of the fate of phytate in the presence of various metals that are commonly present in agricultural soils.more » « less
-
Iron hexacyanoferrate (FeHCF) particles were synthesized at room temperature with ethylenediaminetetraacetic acid (EDTA) at varying pH. The presence of EDTA produced faceted particles and increasing synthesis pH resulted in slower reaction kinetics and larger particles with lower water content and fewer anion vacancies determined by TGA and Mössbauer spectroscopy. Electrochemical testing of sodium metal half cells revealed higher capacity in FeHCF particles grown at lower pH with EDTA, obtaining a maximum discharge capacity of 151 mA h g −1 with 79% capacity retention after 100 cycles at 100 mA g −1 and a rate capability of 122 mA h g −1 at 3.2 A g −1 . In contrast, particles grown at higher pH had stunted low-spin Fe redox activity but with improved long-term cyclic stability. These findings demonstrate that small changes in synthesis pH can greatly affect the growth and electrochemical properties of FeHCF when using a pH sensitive chelating agent such as EDTA.more » « less
An official website of the United States government

