An official website of the United States government
The role of negative hydroxyl ions in liquid-phase plasma discharge formation is investigated using an inhouse modeling framework. Two tunneling sources for electrons are considered—tunneling ionization of water molecules and tunneling detachment of negative hydroxyl ions together with additional reaction steps. The simulations are conducted for a needle-like powered electrode with two different nanosecond rise time voltage profiles—a linear and an exponential rise. Both the profiles have a maximum voltage of 15 kV. The predictions show that the electron detachment, which has a much lower threshold energy requirement, provides a stream of electrons at low applied voltage during the initial rise time. The electrical forces from the electron detachment process generate stronger compression but a weaker expansion regime in the liquid resulting in ∼40% increase in the density and only ∼1% decrease. The electron detachment tunneling process is found to be not limited by the electric field, but rather by the availability of negative hydroxyl ions in the system and ceases when these ions are depleted. The tunnel ionization of water molecules forms the electron wave at a higher applied voltage, but the resulting peak electron number density is typically six orders of magnitude larger than the detachment tunneling. The higher electron number density allows the recycling of depleted negative hydroxyl ions in the system and can reestablish tunneling detachment. In addition, the system experiences a larger variation in density; specifically, a decrease in density due to tunnel ionization. The prediction also shows that irrespective of the initial electron sources (i.e. tunnel ionization or tunnel detachment) the reduced electric field is not sufficient enough to allow electron impact ionization to be active and make a significant contribution. Path flux analysis is conducted to determine the kinetics responsible for the recycling of the negative hydroxyl ions.
more »
« less
Controlling the breakdown delay time in pulsed gas discharge
Abstract In experiment and 2D3V PIC MCC simulations, the breakdown development in a pulsed discharge in helium is studied forU= 3.2 kV and 10 kV andP= 100 Torr. The breakdown process is found to have a stochastic nature, and the electron avalanche develops in different experimental and simulation runs with time delays ranging from 0.3 to 8μs. Nevertheless our experiments demonstrate that the breakdown delay time distribution can be controlled with a change of the pulse discharge frequency. The simulation results show that the breakdown process can be distinguished in three stages with (a) the ionization by seed electrons, (b) the ions drift to the cathode and (c) the enhanced ionization within the cathode sheath by the electrons emitted from the cathode. The effects of variation of seed electron concentrations, voltage rise times, voltage amplitudes and ion–electron emission coefficients on the breakdown development in the pulsed gas discharge are reported.
more »
« less
- Award ID(s):
- 1747760
- PAR ID:
- 10364516
- Publisher / Repository:
- IOP Publishing
- Date Published:
- Journal Name:
- Plasma Sources Science and Technology
- Volume:
- 31
- Issue:
- 3
- ISSN:
- 0963-0252
- Page Range / eLocation ID:
- Article No. 03LT01
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract This study delves into the dynamics of cold atmospheric plasma and their interaction within conductive solutions under the unique conditions of nanosecond pulsed discharges (22 kV peak voltage, 10 ns FWHM, 4.5 kV ns−1rate-of-rise). The research focuses on the electrical response, breakdown, and discharge propagation in an argon bubble, submerged in a NaCl solution of varying conductivity. Full or partial discharges were observed at conductivities of 1.5µS cm−1(deionized water) to 1.6 mS cm−1, but no breakdown was observed at 11.0 mS cm−1when reducing the electrode gap. It is demonstrated that at higher conductivity electric breakdown is observed only when the gas bubble comes into direct contact with the electrode and multiple emission nodes were observed at different timescales. These nodes expanded in the central region of the bubble over timescales longer than the initial high-voltage pulse. This work offers a temporal resolution of 2 ns exposure times over the first 30 ns of the initial voltage pulse, and insight into plasma formation over decaying reflected voltage oscillations over 200 ns.more » « less
-
Abstract High voltage (∼2 kV) Al0.64Ga0.36N-channel high electron mobility transistors were fabricated with an on-resistance of ∼75 Ω. mm (∼21 mΩ. cm2). Two field plates of variable dimensions were utilized to optimize the breakdown voltage. The breakdown voltage reached >3 kV (tool limit) before passivation however it reduced to ∼2 kV after Si3N4surface passivation and field plate deposition. The breakdown voltage and on-resistance demonstrated a strong linear correlation in a scattered plot of ∼50 measured transistors. The fabricated transistors were electrically characterized and benchmarked against the state-of-the-art high-voltage (> 1 kV) Al-rich (>40%) AlGaN-channel transistors in breakdown voltage and on-resistance, indicating significant progress.more » « less
-
Abstract Contact electrification in a gas medium is usually followed by partial surface charge dissipation caused by dielectric breakdown of the gas triggered during separation of the surfaces. It is widely assumed that such discharge obeys the classical Paschen’s law, which describes the general dependence of the breakdown voltage on the product of gas pressure and gap distance. However, quantification of this relationship in contact electrification involving insulators is impeded by challenges in nondestructive in situ measurement of the gap voltage. The present work implements an electrode-free strategy for capturing discrete discharge events by monitoring the gap voltage via Coulomb force, providing experimental evidence of Paschen curves governing nitrogen breakdown in silicone-acrylic and copper-nylon contact electrification. It offers an alternative approach for characterizing either the ionization energies of gases or the secondary-electron-emission properties of surfaces without the requirement of a power supply, which can potentially benefit applications ranging from the design of insulative materials to the development of triboelectric sensors and generators.more » « less
-
Abstract The time dynamics of positive corona ignition from an initial seed electron to the appearance of space charge effects is studied at atmospheric pressure in a spherically symmetrical geometry. The time-dependent model incorporates a recent photoionization model and boundary conditions to properly treat the corona discharge in the proximity of the anode surface. The applied voltage satisfying the self-sustainability condition of the discharge is first calculated. Then, the time dynamics of the discharge is studied for higher and lower applied voltages. The exponential growth in electron density is identified before space charge effects significantly shield the applied electric field. The related characteristic time of exponential growth in electron density is calculated as a function of applied voltage. The time scale can be tens of nanoseconds when applied voltage is close to the threshold or less than one nanosecond when increasing voltage 10% above the threshold for atmospheric pressure. Analogous to the equality of ionization timescale and dielectric relaxation time in stable streamers, a characteristic timescale is used to predict the behavior of the discharge. When the characteristic time is about one-tenth of the dielectric relaxation time, a one-tenth reduction in the applied field on the anode is observed. As the dielectric relaxation time drops below ten times the characteristic time, the discharge behavior diverges for different applied voltages, and the characteristic time is not a good predictor of further discharge dynamics.more » « less
