An official website of the United States government
Abstract. The climatic and health effects of aerosols are strongly dependent on the intra-annual variations in their loading and properties. While the seasonal variations of regional aerosol optical depth (AOD) have been extensively studied, understanding the temporal variations in aerosol vertical distribution and particle types is also important for an accurate estimate of aerosol climatic effects. In this paper, we combine the observations from four satellite-borne sensors and several ground-based networks to investigate the seasonal variations of aerosol column loading, vertical distribution, and particle types over three populous regions: the Eastern United States (EUS), Western Europe (WEU), and Eastern and Central China (ECC). In all three regions, column AOD, as well as AOD at heights above 800m, peaks in summer/spring, probably due to accelerated formation of secondary aerosols and hygroscopic growth. In contrast, AOD below 800m peaks in winter over WEU and ECC regions because more aerosols are confined to lower heights due to the weaker vertical mixing. In the EUS region, AOD below 800m shows two maximums, one in summer and the other in winter. The temporal trends in low-level AOD are consistent with those in surface fine particle (PM2.5) concentrations. AOD due to fine particles ( < 0.7µm diameter) is much larger in spring/summer than in winter over all three regions. However, the coarse mode AOD ( > 1.4µm diameter), generally shows small variability, except that a peak occurs in spring in the ECC region due to the prevalence of airborne dust during this season. When aerosols are classified according to sources, the dominant type is associated with anthropogenic air pollution, which has a similar seasonal pattern as total AOD. Dust and sea-spray aerosols in the WEU region peak in summer and winter, respectively, but do not show an obvious seasonal pattern in the EUS region. Smoke aerosols, as well as absorbing aerosols, present an obvious unimodal distribution with a maximum occurring in summer over the EUS and WEU regions, whereas they follow a bimodal distribution with peaks in August and March (due to crop residue burning) over the ECC region.
more »
« less
High‐Latitude Stratospheric Aerosol Geoengineering Can Be More Effective if Injection Is Limited to Spring
Abstract Stratospheric aerosol geoengineering focused on the Arctic could substantially reduce local and worldwide impacts of anthropogenic global warming. Because the Arctic receives little sunlight during the winter, stratospheric aerosols present in the winter at high latitudes have little impact on the climate, whereas stratospheric aerosols present during the summer achieve larger changes in radiative forcing. Injecting SO2in the spring leads to peak aerosol optical depth (AOD) in the summer. We demonstrate that spring injection produces approximately twice as much summer AOD as year‐round injection and restores approximately twice as much September sea ice, resulting in less increase in stratospheric sulfur burden, stratospheric heating, and stratospheric ozone depletion per unit of sea ice restored. We also find that differences in AOD between different seasonal injection strategies are small compared to the difference between annual and spring injection.
more »
« less
- PAR ID:
- 10391720
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Geophysical Research Letters
- Volume:
- 48
- Issue:
- 9
- ISSN:
- 0094-8276
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Atmospheric deposition is an important pathway for delivering micronutrient and pollutant trace elements (TEs) to the surface ocean. In the central Arctic, much of this supply takes place onto sea ice during winter, before eventual delivery to the ocean during summertime melt. However, the seasonality of aerosol TE loading, solubility, and deposition flux are poorly studied over the Arctic Ocean, due to the difficulties of wintertime sampling. As part of the Multidisciplinary drifting Observatory for the Study of Arctic Climate (MOSAiC) expedition, aerosols collected during winter and spring (December–May) were analyzed for soluble, labile, and total TE concentrations. Despite low dust loading, mineral aerosol accounted for most of the variation in total Fe, Al, Ti, V, Mn, and Th concentrations. In contrast, soluble TE concentrations were more closely linked to non‐sea‐salt sulfate, and Fe solubility was significantly higher during Arctic winter (median = 6.5%) than spring (1.9%), suggesting an influence from Arctic haze. Beryllium‐7 data were used to calculate an average bulk deposition velocity of 613 ± 153 m d−1over most of the study period, which was applied to calculate seasonal deposition fluxes of total, labile, and soluble TEs to the central Arctic. Total TE fluxes (173 ± 145 nmol m−2 d−1for Fe) agreed within a factor of two or three with earlier summertime estimates, with generally higher wintertime concentrations offset by a lower deposition velocity. Cumulative seasonal deposition of total, labile, and soluble Fe to the central Arctic Ocean was calculated at 25 ± 21, 5 ± 3, and 2 ± 2 μmol m−2, respectively.more » « less
-
Abstract We use a tracer method involving the cosmogenic radioisotope beryllium‐7 (half‐life = 53.3 days) to follow the deposition of aerosols and the fate of snow on the MOSAiC ice floe during winter and spring 2019–2020. When examined alongside data from earlier studies in the Arctic Ocean that covered summer and fall, Be‐7 inventories indicate a summertime peak for aerosol Be‐7 deposition fluxes coinciding with seasonal minima boundary‐level aerosol concentrations, which suggests that deposition fluxes are primarily controlled by precipitation. This conclusion is supported by the linear relationship between Be‐7 fluxes and precipitation rates derived from data from the MOSAiC and SHEBA expeditions. Inventories of Be‐7 within the snow column exhibited evidence of significant redistribution. Be‐7 deficits, relative to the flux, were observed in areas of level sea ice while excess Be‐7 was found associated with deformed ice features such as pressure ridges, leading to the following estimates for the distribution of snow on the ice floe in May 2020: 75–93% of the snow mass is found on deformed sea ice with the remainder on level ice. Furthermore, uncertainties associated with measurements of Be‐7 concentrations within the ocean mixed layer would allow for losses of snow through open leads of up to approximately 20% of the flux. Our snow distribution estimates agree with data from repeat snow depth transect measurements. These results suggest that Be‐7 can be a useful tool in studying snow redistribution.more » « less
-
Abstract Arctic and Antarctic sea ice has undergone significant and rapid change with the changing climate. Here, we present preindustrial and historical results from the newly released Community Earth System Model Version 2 (CESM2) to assess the Arctic and Antarctic sea ice. Two configurations of the CESM2 are available that differ only in their atmospheric model top and the inclusion of comprehensive atmospheric chemistry, including prognostic aerosols. The CESM2 configuration with comprehensive atmospheric chemistry has significantly thicker Arctic sea ice year‐round and better captures decreasing trends in sea ice extent and volume over the satellite period. In the Antarctic, both CESM configurations have similar mean state ice extent and volume, but the ice extent trends are opposite to satellite observations. We find that differences in the Arctic sea ice between CESM2 configurations are the result of differences in liquid clouds. Over the Arctic, the CESM2 configuration without prognostic aerosol formation has fewer aerosols to form cloud condensation nuclei, leading to thinner liquid clouds. As a result, the sea ice receives much more shortwave radiation early in the melt season, driving a stronger ice albedo feedback and leading to additional sea ice loss and significantly thinner ice year‐round. The aerosols necessary for the Arctic liquid cloud formation are produced from different precursor emissions and transported to the Arctic. Thus, the main reason sea ice differs in the Arctic is the transport of cloud‐impacting aerosols into the region, while the Antarctic remains relatively pristine from extrapolar aerosol transport.more » « less
-
Abstract Stratospheric aerosol injection (SAI) has been shown in climate models to reduce some impacts of global warming in the Arctic, including the loss of sea ice, permafrost thaw, and reduction of Greenland Ice Sheet (GrIS) mass; SAI at high latitudes could preferentially target these impacts. In this study, we use the Community Earth System Model to simulate two Arctic‐focused SAI strategies, which inject at 60°N latitude each spring with injection rates adjusted to either maintain September Arctic sea ice at 2030 levels (“Arctic Low”) or restore it to 2010 levels (“Arctic High”). Both simulations maintain or restore September sea ice to within 10% of their respective targets, reduce permafrost thaw, and increase GrIS surface mass balance by reducing runoff. Arctic High reduces these impacts more effectively than a globally focused SAI strategy that injects similar quantities of SO2at lower latitudes. However, Arctic‐focused SAI is not merely a “reset button” for the Arctic climate, but brings about a novel climate state, including changes to the seasonal cycles of Northern Hemisphere temperature and sea ice and less high‐latitude carbon uptake relative to SSP2‐4.5. Additionally, while Arctic‐focused SAI produces the most cooling near the pole, its effects are not confined to the Arctic, including detectable cooling throughout most of the northern hemisphere for both simulations, increased mid‐latitude sulfur deposition, and a southward shift of the location of the Intertropical Convergence Zone. For these reasons, it would be incorrect to consider Arctic‐focused SAI as “local” geoengineering, even when compared to a globally focused strategy.more » « less
