BaTiO 3 (BTO) is considered the most commonly used ceramic material in multilayer ceramic capacitors due to its desirable dielectric properties. Considering that the miniaturization of electronic devices represents an expanding field of research, modification of BTO has been performed to increase dielectric constant and DC bias characteristic/sensitivity. This research presents the effect of N 2 and air atmospheres on morphological and dielectric properties of BTO nanoparticles modified with organometallic salt at sintering temperatures of [Formula: see text]C, [Formula: see text]C, [Formula: see text]C, and [Formula: see text]C. Measured dielectric constants were up to 35,000, with achieved very high values in both atmospheres. Field emission scanning electron microscopy (FESEM) was used for morphological characterization, revealing a porous structure in all the samples. The software image analysis of FESEM images showed a connection between particle and pore size distribution, as well as porosity. Based on the data from the image analysis, the prediction of dielectric properties in relation to morphology indicated that yttrium-based organometallic salt reduced oxygen vacancy generation in N 2 atmosphere. DC bias sensitivity measurements showed that samples with higher dielectric constant had more pronounced sensitivity to voltage change, but most of the samples were stable up to 100 V, making our modified BTO a promising candidate for capacitors.
more »
« less
Investigating the dielectric constant of barium titanate in a polymer-matrix nanocomposite
Abstract Barium titanate (BTO) is a ferroelectric material used in capacitors because of its high bulk dielectric constant. However, the impact of the size of BTO on its dielectric constant is not yet fully understood and is highly contested. Here, we present an investigation into the dielectric constant of BTO nanoparticles with diameters ranging between 50 and 500 nm. BTO nanoparticles were incorporated into acrylonitrile butadiene styrene and injection molded into parallel plate capacitors, which were used to determine nanocomposite dielectric constants. The dielectric constants of BTO nanoparticles were obtained by combining experimental measurements with computational results from COMSOL simulations of ABS-matrix nanocomposites containing BTO. The dielectric constant of BTO was observed to be relatively constant at nanoparticle diameters as small as 200 nm but sharply declined at smaller nanoparticle sizes. These results will be useful in the development of improved energy storage and power conditioning systems utilizing BTO nanoparticles. Graphical abstract
more »
« less
- Award ID(s):
- 1943599
- PAR ID:
- 10406730
- Date Published:
- Journal Name:
- MRS Advances
- Volume:
- 7
- Issue:
- 31
- ISSN:
- 2059-8521
- Page Range / eLocation ID:
- 799 to 804
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
more » « less
Chalcogenide hybrid inorganic/organic polymers (CHIPs) are a new class of optical polymeric materials for imaging and photonic applications due to their high refractive indices and high optical transmission at visible and infrared wavelengths. In this study, we characterize these polymers to study the refractive index and delve into the electronic properties by way of measurements of their dielectric constants. Ellipsometry is used to determine the refractive indices for wavelengths from 500 nm to 12 µm, while we use capacitance measurements on thin film capacitors with a range of areas to find the dielectric constant. The results are in line with expectations based on the sulfur composition of the polymers-indices range from 1.7 to 1.85, and dielectric constants range from 2.6 to 3. With these measurements, these sulfur polymer materials are established to be good candidates for optical and photonic applications, particularly with respect to telecommunications. The dielectric constants suggest that applications such as electro-optic devices and capacitors may also be viable.
-
more » « less
Abstract Barium titanate (BTO) is a ferroelectric perovskite used in electronics and energy storage systems because of its high dielectric constant. Decreasing the BTO particle size was shown to increase the dielectric constant of the perovskite, which is an intriguing but contested result. We investigated this result by fabricating silicone-matrix nanocomposite specimens containing BTO particles of decreasing diameter. Furthermore, density functional theory modeling was used to understand the interactions at the BTO particle surface. Combining results from experiments and modeling indicated that polymer type, particle surface interactions, and particle surface structure can influence the dielectric properties of polymer-matrix nanocomposites containing BTO.
Graphical abstract -
One major challenge in the development of nanoparticle-based therapeutics, including viral vectors for the delivery of gene therapies, is the development of cost-effective purification technologies. The objective of this study was to examine fouling and retention behaviors during the filtration of model nanoparticles through membranes of different pore sizes and the effect of solution conditions. Data were obtained with 30 nm fluorescently labeled polystyrene latex nanoparticles using both cellulosic and polyethersulfone membranes at a constant filtrate flux, and both pressure and nanoparticle transmission were evaluated as a function of cumulative filtrate volume. The addition of NaCl caused a delay in nanoparticle transmission and an increase in fouling. Nanoparticle transmission was also a function of particle hydrophobicity. These results provide important insights into the factors controlling transmission and fouling during nanoparticle filtration as well as a framework for the development of membrane processes for the purification of nanoparticle-based therapeutics.more » « less
-
Abstract Incorporation of metallic nanoparticles (NPs) in polymer matrix has been used to enhance and control dissolution and release of drugs, for targeted drug delivery, as antimicrobial agents, localized heat sources, and for unique optoelectronic applications. Gold NPs in particular exhibit a plasmonic response that has been utilized for photothermal energy conversion. Because plasmonic nanoparticles typically exhibit a plasmon resonance frequency similar to the visible light spectrum, they present as good candidates for direct photothermal conversion with enhanced solar thermal efficiency in these wavelengths. In our work, we have incorporated ∼3-nm-diameter colloidal gold (Au c ) NPs into electrospun polyethylene glycol (PEG) fibers to utilize the nanoparticle plasmonic response for localized heating and melting of the polymer to release medical treatment. Au c and Au c in PEG (PEG+Au c ) both exhibited a minimum reflectivity at 522 nm or approximately green wavelengths of light under ultraviolet-visible (UV-Vis) spectroscopy. PEG+Au c ES fibers revealed a blue shift in minimum reflectivity at 504 nm. UV-Vis spectra were used to calculate the theoretical efficiency enhancement of PEG+Au c versus PEG alone, finding an approximate increase of 10 % under broad spectrum white light interrogation, and ∼14 % when illuminated with green light. Au c enhanced polymers were ES directly onto resistance temperature detectors and interrogated with green laser light so that temperature change could be recorded. Results showed a maximum increase of 8.9 °C. To further understand how gold nanomaterials effect the complex optical properties of our materials, spectroscopic ellipsometry was used. Using spectroscopic ellipsometry and modeling with CompleteEASE® software, the complex optical constants of our materials were determined. The complex optical constant n (index of refraction) provided us with optical density properties related to light wavelength divided by velocity, and k (extinction coefficient) was used to show the absorptive properties of the materials.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1557/s43580-022-00319-x
