An official website of the United States government
Abstract Supershear earthquakes, propagating faster than the Earth's shear wave velocity, can generate strong ground motion at distances far from the ruptured fault. Despite the hazards associated with these earthquakes, the exact fault properties that govern their occurrence are not well constrained. Although early studies associated supershear ruptures with simple fault geometries, recent dynamic rupture models have revealed a supershear transition mechanism over complex fault geometries such as fault stepovers. Here we present the first observation of a supershear transition on a fault stepover system during the 2017 Mw7.7 Komandorsky Islands earthquake. Using a high‐resolution back‐projection technique, we find that the earthquake's rupture velocity accelerates from 2.1 to 5.0 km/s between two offset faults, demonstrating the viability of a new supershear transition mechanism occurring in nature. Given the fault complexity of the Earth's transform plate boundaries, this result may improve our understanding of supershear rupture processes and their associated hazards.
more »
« less
Weak, Vertically Stronger Main Himalayan Thrust in the India‐Asia Collision
Abstract Megathrusts at convergent plate boundaries generate the largest and some of the most hazardous earthquakes on Earth. However, their physical properties, including those influencing fault slip accumulation and release and earthquake‐related surface displacements, are still poorly constrained at critical depths. Here, we combine seismic imaging and geodetic modeling to investigate the structure and mechanical behavior of the Main Himalayan Thrust fault (MHT) in the center of the 2015 Mw 7.8 Gorkha rupture in Nepal. Our results from two independent observations consistently suggest the presence of a channel associated with the MHT with high compliance (shear modulus as low as ∼4 GPa) and strain anisotropy (stiffer in the vertical orientation than in the horizontal), likely arising from a weak subducting layer with north‐dipping foliation. Such mechanical heterogeneity significantly influences the quantification of short‐term fault kinematics and associated earthquake potential, with implications on across‐scale dynamics of plate boundaries in Himalaya and elsewhere.
more »
« less
- PAR ID:
- 10585001
- Publisher / Repository:
- American Geophysical Union
- Date Published:
- Journal Name:
- Geophysical Research Letters
- Volume:
- 51
- Issue:
- 16
- ISSN:
- 0094-8276
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Tectonic tremor tracks the repeated slow rupture of certain major plate boundary faults. One of the most perplexing aspects about tremor is that some fault segments produce strongly periodic, spatially extensive tremor episodes, while others have more disorganized, asynchronous activity. Here, we measure the size of segments that activate synchronously during tremor episodes and the relationship to regional earthquake rate on major plate boundaries. Tremor synchronization in space seems to be limited by the activity of small, nearby crustal and intraslab earthquakes. This observation can be explained by a competition between the self-synchronization of fault segments and perturbation by regional earthquakes. Our results imply previously unrecognized interactions across subduction systems, in which earthquake activity far from the fault influences whether it breaks in small or large segments.more » « less
-
The 11 March 2011 M 9.0 Tohoku-oki earthquake was one of the largest earthquakes ever recorded and was accompanied by a devastating tsunami. Slip during the earthquake was exceptionally large at shallow depth on the plate boundary fault, which was one of the primary factors that contributed to the extreme tsunami amplitudes that inundated the coast of Japan. International Ocean Discovery Program Expedition 405 aims to investigate the conditions and processes that facilitated the extremely shallow slip on the subduction interface in the 2011 Tohoku-oki earthquake. Proposed work includes coring and logging operations at two sites in a transect across the trench. The first site, located within the overriding plate, will access the fault zone in the region of large shallow slip, targeting the plate boundary décollement, overlying frontal prism, and subducted units cut by the décollement. The second site, located on the Pacific plate, will access the undisturbed sedimentary and volcanic inputs to the subduction zone. A borehole observatory will be installed into the décollement and surrounding rocks to provide measurements of the temperature in and around the fault over the following several years. Sampling, geophysical logs, and the observatory temperature time series will document the compositional, structural, mechanical, and frictional properties of the rocks in the décollement and adjacent country rock, as well as the hydrogeologic structure and pore fluid pressure of the fault zone and frontal prism—key properties that influence the effective stress to facilitate earthquake slip and potential for large slip. Results from Expedition 405 will address fundamental questions about earthquake slip on subduction zones that may directly inform earthquake and tsunami hazard assessments around the world.more » « less
-
ABSTRACT:We study the influence of an upper-plate fault on the stress state of accreting sediments under large-scale deformation. We develop drained evolutionary geomechanical models using the Finite Element program Elfen. We simulate sediments as porous-elastoplastic material, and we model the fault as a pre-existing contact surface with a varying frictional strength that is lower than the intact sediment. The weaker fault results in a decrease in sediment differential stress near and especially seaward of the fault. A significant section of the wedge is affected by this stress variation. In contrast, the stress ratio is that of Coulomb failure further away from the fault. We also show that the maximum principal stress the sediments can support decreases with decreasing fault strength. This study offers a significant improvement over previous models of continuum wedge sediments that predict Coulomb failure throughout the wedge. Our results improve our understanding of near-fault stress state, hence improving our understanding of seismic hazards in subduction zones and providing practical insights for reservoir quality and the design of safe and economic well trajectories. 1 INTRODUCTIONAccretionary wedges are geological structures that develop at convergent plate boundaries, particularly at subduction zones. They form as a result of offscraping sediments from the subducting oceanic plate, which then accumulates on the leading edge of the overriding plate (e.g., Moore et al., 2011; Buiter et al., 2016; Gao et al., 2018).Understanding the state of stress in accretionary wedges is crucial for the study of earthquake mechanics in subduction zones (e.g., Brodsky et al., 2017; Huffman and Saffer, 2016; Suppe, 2007). It provides insights for earthquake occurrence, large or slow-slip events (e.g., Kodaira et al., 2012; Tobin et al., 2022; Liu and Rice, 2007) and tsunami potential (e.g., Dean et al., 2010; Riedel et al., 2016). In addition, estimates of mean and differential stress, as well as porosity evolution can help improve the assessment of reservoir quality and the design of safe and economic well trajectories (e.g., Morley et al., 2011).The accumulation of sediments in an accretionary wedge resembles a bulldozer gathering snow as it moves. Hence, wedge sediments are often assumed to be at compressional failure (e.g., Davis et al., 1983; Dahlen et al., 1984; Flemings and Saffer, 2018). Several field observations of faulting, folding and lateral compression as seen in seismic images and drilling measurements (e.g., Flemings and Saffer, 2018; Henry et al., 2003; Moore et al., 1990; Westbrook et al., 1988) provide evidence that the accretionary wedge is at a state of failure in compression.more » « less
-
Abstract The Alaska Peninsula section of the Alaska-Aleutian subduction zone shows significant along-strike variations in seismic activity and interseismic plate coupling. This region experienced the 2020 Mw 7.8 Simeonof megathrust, Mw 7.6 Sand Point strike-slip, and 2021 Mw 8.2 Chignik megathrust earthquakes. This study, utilizing deep learning techniques, presents a high-precision earthquake catalog, providing insights into background seismicity, aftershocks, and slab geometry. An abrupt change in the slab dip angle at 30–40 km depths in the Shumagin segment acted as a barrier to the Simeonof and Sand Point earthquake ruptures. The Simeonof event triggered more aftershocks in the overriding plate than the Chignik event, suggesting the overriding plate is more deformed and hydrated in the Shumagin segment. The Sand Point earthquake triggered numerous aftershocks in the overriding plate, delineating a fault in the overriding plate with similar geometry as the intraslab mainshock fault, but activated around seven days after the mainshock.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1029/2024GL110222
