An official website of the United States government
Abstract Complex shear wave splitting (SWS) patterns in subduction zones are often interpreted geodynamically as resulting from complex mantle flow; however, this may not always be necessary. We analyzed 7,093 high‐quality SWS measurements from teleseismic S waves recorded by Hi‐net stations across the Ryukyu arc in Japan. Our findings show a systematic rotation of the fast S polarization from trench‐parallel to trench‐perpendicular depending on the earthquake backazimuth. For the same earthquake, the measured splitting patterns also vary spatially across the southwest Japan. Using full‐wave seismic modeling, we showed that a dipping slab with ∼30% shear anisotropy of the tilted transverse isotropy (TTI) type, with a symmetry axis perpendicular to the slab interface, can predict the observed delay times and polarization rotation. Our results highlight the importance of considering dipping anisotropic slabs in interpreting SWS at subduction zones.
more »
« less
Analysis of Shear Wave Splitting Patterns in Alaska: Evidence for Strong Intra‐Slab Anisotropy
Abstract Shear wave splitting (SWS) patterns at subduction zones are often interpreted by complex mantle flow above or below the slab. However, our recent previous work shows dipping anisotropic slabs can explain observed patterns in Japan. Here, we extend this analysis to the Alaska subduction zone, using 2,567 high‐quality teleseismic SWS measurements from 195 broadband stations. As was found in Japan, the observed SWS patterns in Alaska depend on earthquake backazimuth. The fast‐S polarization directions are either trench parallel or perpendicular in southeastern Alaska and form a prominent circular pattern in central Alaska. We found that a dipping anisotropic slab following the Slab 2.0 geometry, with 30% shear anisotropy, and exhibiting tilted transverse isotropy with a symmetry axis normal to the slab interface, predicts both the fast‐S polarizations and delay times (δt = 1.0–1.5 s). This suggests that intra‐slab anisotropy can be the primary control on SWS, without requiring complex mantle flow.
more »
« less
- Award ID(s):
- 2027150
- PAR ID:
- 10645037
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Geophysical Research Letters
- Volume:
- 52
- Issue:
- 20
- ISSN:
- 0094-8276
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Shear‐wave splitting observations can provide insight into mantle flow, due to the link between the deformation of mantle rocks and their direction‐dependent seismic wave velocities. We identify anisotropy in the Cook Inlet segment of the Alaska subduction zone by analyzing splitting parameters of S waves from local intraslab earthquakes between 50 and 200 km depths, recorded from 2015–2017 and emphasizing stations from the Southern Alaska Lithosphere and Mantle Observation Network experiment. We classify 678 high‐quality local shear‐wave splitting observations into four regions, from northwest to southeast: (L1b) splitting measurements parallel to Pacific plate motion, (L1a) arc‐perpendicular splitting pattern, (L2) sharp transition to arc‐parallel splitting, and (L3) splitting parallel to Pacific plate motion. Forward modeling of splitting from various mantle fabrics shows that no one simple model fully explains the observed splitting patterns. An A‐type olivine fabric with fast direction dipping 45° to the northwest (300°)—aligned with the dipping slab—predicts fast directions that fit L1a observations well, but not L2. The inability of the forward model fabrics to fit all the observed splitting patterns suggests that the anisotropy variations are not due to variable ray angles, but require distinct differences in the anisotropy regime below the arc, forearc, and subducting plate.more » « less
-
Abstract Using numerical models, we compute the evolution of the mantle flow field and the crystal preferred orientation (CPO) of mineral aggregates in the mantle wedge of generic subduction systems from their nascent to mature stage and investigate shear wave splitting (SWS) through the forearc mantle wedge corner and overriding crust. Upon subduction initiation, the maximum depth of slab‐mantle decoupling (MDD) is relatively shallow (∼20 km depth), resulting in mantle flow and CPO development in the wedge corner. As subduction continues, the MDD deepens, the wedge corner cools and stagnates, and the olivine CPO becomes frozen‐in. In the cool wedge corner, antigorite can form if water is available. In non‐deforming mantle, antigorite CPO develops relative to the host olivine CPO through topotactic growth. We calculate splitting parameters of synthetic local S waves based on the model‐predicted A‐ and B‐type olivine CPOs and topotactically grown antigorite CPO that replaces A‐type olivine CPO in the wedge corner. The fast direction is trench‐normal for A‐type olivine and antigorite CPOs and trench‐parallel for B‐type. When the delay times are long enough (>0.1 s), we find them positively correlated with the thickness of the mantle wedge corner. In NE Japan, where the results of detailed analyses on the spatial variation of the SWS parameters are available, such correlation is not observationally reported. However, the addition of an anisotropic overriding crust provides delay times (∼0.1 s) and trench‐normal fast directions that are consistent with the local SWS observations.more » « less
-
Abstract This study represents the first campaign‐style teleseismic shear wave splitting (SWS) investigation of central Myanmar, an area that is tectonically controlled by the oblique subduction of the Indian Plate underneath the Eurasian Plate. The resulting 678 well‐defined and 247 null SWS measurements obtained from recently deployed 71 broadband seismic stations show that the Indo‐Burma Ranges (IBR) possess mostly N‐S fast orientations that are parallel to the trend of the depth contours of the subducted slab. Relative to the global average of 1.0 s, extremely large splitting times with station‐averaged values ranging from 1.28 to 2.79 s and an area‐averaged value of 2.09 ± 0.55 s are observed in the IBR. In contrast, the Central Basin (CB) and the Shan Plateau (SP) are characterized by slightly larger than normal splitting times. The fast orientations observed in the CB are mostly NE‐SW in the northern part of the study area, N‐S in the central part, and NW‐SE in the southern part. The fast orientations change from nearly N‐S along the N‐S oriented Sagaing Fault, to NW‐SE in the central and eastern portions of the SP. These observations, together with SWS measurements using local S events, crustal anisotropy measurements using P‐to‐S receiver functions, and the estimated depth of the source of anisotropy using the spatial coherency of the splitting parameters, suggest the presence of a trench‐parallel sub‐slab flow system driven by slab rollback, a trench‐perpendicular corner flow, and a trench‐parallel flow possibly entering the mantle wedge through a slab window or gap.more » « less
-
Abstract To systematically investigate seismic azimuthal anisotropy in the Sumatra subduction zone and probe mantle dynamics associated with the subduction of the Australian Plate beneath the Sunda Plate, a total of 169 pairs of teleseismic XKS (including PKS, SKKS, SKS) and 115 pairs of localSsplitting parameters are obtained using broadband seismic data recorded at ~70 stations. Additionally, crustal anisotropy in the overriding Sunda Plate is measured by analyzing the moveout ofP‐to‐Sconversions from the Moho using a sinusoidal function. Comparison between the three sets of anisotropy measurements obtained using shear waves with different depths of origin suggests that (1) the crust of the Sunda Plate is anisotropic with mostly trench‐parallel fast orientations and a mean splitting time of 0.28 ± 0.05 s; (2) the mantle wedge is azimuthally anisotropic with dominantly trench‐parallel fast orientations and splitting times ranging from 0.22 to 0.81 s, which generally increase with the focal depth; and (3) subslab anisotropy is mostly trench‐normal beneath the fore‐arc region with an averaged splitting time of 1.48 ± 0.06 s, and becomes trench‐parallel beneath the arc and back‐arc areas with a mean splitting time of 0.33 ± 0.04 s. The resulting lateral and vertical distributions of anisotropy obtained using splitting of three types of shear waves advocate the presence of an entrained subslab flow that is deflected by the mantle transition zone. The flow enters the mantle wedge through a slab window and flows horizontally parallel to the trench.more » « less
