skip to main content


Title: A Baseband Feedback Approach to Linearization of a UHF Power Amplifier
This work presents a power amplifier (PA) linearization approach based on baseband feedback. The modulated signal envelope is fed back from the transistor's drain to its gate with an applied amplitude and phase shift selected to reduce the intermodulation distortion (IMD3) product at the output. The design targets IMD3 improvement near the PA's 1-dB compression point (P1dB), enabling linear operation at a higher output power level and therefore improved device periphery utilization and efficiency. This approach offers a potential linearization alternative to digital pre-distortion, which cannot be applied in some systems, without affecting the RF performance. The 850-MHz proof-of-concept prototype based on a 15-W GaN device is characterized with a two-tone measurement with 5-MHz spacing, and demonstrates 9-dB improvement of the lower IMD3 tone near the P1dB point.  more » « less
Award ID(s):
1846507
NSF-PAR ID:
10130706
Author(s) / Creator(s):
;
Date Published:
Journal Name:
IEEE MTT-S International Microwave Symposium
Page Range / eLocation ID:
75 to 78
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. An analytic theory for dual-input outphasing power amplifiers that incorporate in one unified treatment, the continuum of solutions for power combining including the Doherty and Chireix modes is presented. This unified theory developed at the current-source reference planes reveals the performance trade-off achieved by all of the possible power amplifier (PA) combiners within the continuum of solutions. Furthermore, it identifies a novel type of dual-input hybrid Chireix-Doherty PA that combines key features of the Doherty and Chireix operations such that the fundamental drain voltages applied to both the main and auxiliary transistors remain constant. This hybrid PA relies on an input outphasing angle varying with the input power level to obtain the correct load modulation behavior. A 2-GHz dual-input hybrid Chireix-Doherty PA is implemented using nonlinear embedding and experimentally evaluated to validate the theory. A drain efficiency of 61% at 9-dB backoff power and a maximum output power of about 43 dBm are obtained for continuous-wave (CW) measurements. The efficiency increases monotonously with output power unlike that of the Doherty PA used for comparison. When excited with a 20-MHz LTE signal with 9.5-dB peak-to-average power ratio (PAPR), the dual-input PA yields a 60.0% average drain efficiency and -48.1-dBc adjacent-channel power-leakage ratio (ACLR) after linearization. 
    more » « less
  2. This work presents a novel power amplifier (PA) architecture employing a feedforward-like loop structure for the linearization of a load-modulated PA. The load-modulating loop combiner (LMLC) is related to a feedforward amplifier, but with the interaction between the main and auxiliary amplifiers to generate both distortion cancellation and load modulation. A brief overview of the underlying theory is presented, followed by a hardware demonstrator operating at 3.5 GHz with 42-dBm peak output power and 55% peak drain efficiency in CW. When excited by a 100-MHz LTE signal, it maintains a 3-ppt EVM improvement and a 2–5-ppt average drain efficiency improvement compared to its standalone main amplifier. 
    more » « less
  3. The challenges associated with efficiently and effectively linearizing a nonlinear power amplifier (PA) over wide signal bandwidths are increasingly important to the design of 5G front-ends. Conventional digital linearization techniques are limited by absolute bandwidth, while the RF-domain nonlinear PA typically exhibits consistent fractional bandwidth even as the carrier frequency is increased. Therefore, RF-domain design techniques, like those focusing on bias-line impedance selection, are critical for overall distortion reduction. To evaluate bias-line effects, a demonstrator PA is here investigated over a range of Class-AB biases and over a range of drain inductance values. The characterization under two-tone and LTE-like modulated excitations with 10-MHz and 100-MHz instantaneous bandwidth shows that the conventional linear-efficiency trade-off in bias design does not necessarily hold true for wide instantaneous bandwidths. Additionally, techniques to synthesize a negative baseband impedance using low frequency feedback are discussed. 
    more » « less
  4. Modulation-based control and locking of lasers, filters and other photonic components is a ubiquitous function across many applications that span the visible to infrared (IR), including atomic, molecular and optical (AMO), quantum sciences, fiber communications, metrology, and microwave photonics. Today, modulators used to realize these control functions consist of high-power bulk-optic components for tuning, sideband modulation, and phase and frequency shifting, while providing low optical insertion loss and operation from DC to 10s of MHz. In order to reduce the size, weight and cost of these applications and improve their scalability and reliability, modulation control functions need to be implemented in a low loss, wafer-scale CMOS-compatible photonic integration platform. The silicon nitride integration platform has been successful at realizing extremely low waveguide losses across the visible to infrared and components including high performance lasers, filters, resonators, stabilization cavities, and optical frequency combs. Yet, progress towards implementing low loss, low power modulators in the silicon nitride platform, while maintaining wafer-scale process compatibility has been limited. Here we report a significant advance in integration of a piezo-electric (PZT, lead zirconate titanate) actuated micro-ring modulation in a fully-planar, wafer-scale silicon nitride platform, that maintains low optical loss (0.03 dB/cm in a 625 µm resonator) at 1550 nm, with an order of magnitude increase in bandwidth (DC - 15 MHz 3-dB and DC - 25 MHz 6-dB) and order of magnitude lower power consumption of 20 nW improvement over prior PZT modulators. The modulator provides a >14 dB extinction ratio (ER) and 7.1 million quality-factor (Q) over the entire 4 GHz tuning range, a tuning efficiency of 162 MHz/V, and delivers the linearity required for control applications with 65.1 dB·Hz2/3and 73.8 dB·Hz2/3third-order intermodulation distortion (IMD3) spurious free dynamic range (SFDR) at 1 MHz and 10 MHz respectively. We demonstrate two control applications, laser stabilization in a Pound-Drever Hall (PDH) lock loop, reducing laser frequency noise by 40 dB, and as a laser carrier tracking filter. This PZT modulator design can be extended to the visible in the ultra-low loss silicon nitride platform with minor waveguide design changes. This integration of PZT modulation in the ultra-low loss silicon nitride waveguide platform enables modulator control functions in a wide range of visible to IR applications such as atomic and molecular transition locking for cooling, trapping and probing, controllable optical frequency combs, low-power external cavity tunable lasers, quantum computers, sensors and communications, atomic clocks, and tunable ultra-low linewidth lasers and ultra-low phase noise microwave synthesizers.

     
    more » « less
  5. This work presents a novel approach for reducing the out-of-band distortion generated in a concurrent dualband power amplifier (PA) without penalty to output power or efficiency using a filter between a driver amplifier and final-stage PA that manipulates the driver amplifier out-of-band distortion such that the overall distortion of the cascade is minimized. The cascaded PA operates at 2.4-GHz and 3.5-GHz with peak output power and drain efficiency of 41.6/40.4 and 65.2/55.1 respectively. The filter reduces the out-of-band distortion of the cascade when excited by dual 10-MHz LTE-like signals by 10 dB while improving average drain efficiency by 5 percentage points. 
    more » « less