More Like this

1. Thermal noise and mechanical loss of SiO ₂ /Ta ₂ O ₅ optical coatings at cryogenic temperatures

   https://doi.org/10.1364/OL.413758  

   Robinson, John_M; Oelker, Eric; Milner, William_R; Kedar, Dhruv; Zhang, Wei; Legero, Thomas; Matei, Dan_G; Häfner, Sebastian; Riehle, Fritz; Sterr, Uwe; et al (January 2021, Optics Letters)

   Mechanical loss of dielectric mirror coatings sets fundamental limits for both gravitational wave detectors and cavity-stabilized optical local oscillators for atomic clocks. Two approaches are used to determine the mechanical loss: ringdown measurements of the coating quality factor and direct measurement of the coating thermal noise. Here we report a systematic study of the mirror thermal noise at 4, 16, 124, and 300 K by operating reference cavities at these temperatures. The directly measured thermal noise is used to extract the mechanical loss for ${\mathrm{S}\mathrm{i}\mathrm{O}}_2/{\mathrm{T}\mathrm{a}}_2{\mathrm{O}}_5$coatings, which are compared with previously reported values. 

   more » « less
2. Modifications of ion beam sputtered tantala thin films by secondary argon and oxygen bombardment

   https://doi.org/10.1364/AO.59.00A150  

   Yang, Le; Randel, Emmett; Vajente, Gabriele; Ananyeva, Alena; Gustafson, Eric; Markosyan, Ashot; Bassiri, Riccardo; Fejer, Martin; Menoni, Carmen (January 2020, Applied Optics)

   Amorphous tantala ( ${\mathrm{T}\mathrm{a}}_2{\mathrm{O}}_5$) thin films were deposited by reactive ion beam sputtering with simultaneous low energy assist ${\mathrm{A}\mathrm{r}}^{+}$or ${\mathrm{A}\mathrm{r}}^{+}/{\mathrm{O}}_2^{+}$bombardment. Under the conditions of the experiment, the as-deposited thin films are amorphous and stoichiometric. The refractive index and optical band gap of thin films remain unchanged by ion bombardment. Around 20% improvement in room temperature mechanical loss and 60% decrease in absorption loss are found in samples bombarded with 100-eV ${\mathrm{A}\mathrm{r}}^{+}$. A detrimental influence from low energy ${\mathrm{O}}_2^{+}$bombardment on absorption loss and mechanical loss is observed. Low energy ${\mathrm{A}\mathrm{r}}^{+}$bombardment removes excess oxygen point defects, while ${\mathrm{O}}_2^{+}$bombardment introduces defects into the tantala films. 

   more » « less
3. Growth and characterization of Sc ₂ O ₃ doped Ta ₂ O ₅ thin films

   https://doi.org/10.1364/AO.59.00A106  

   Fazio, Mariana; Yang, Le; Markosyan, Ashot; Bassiri, Riccardo; Fejer, Martin_M; Menoni, Carmen_S (December 2019, Applied Optics)

   We present the optical and structural characterization of films of ${\mathrm{T}\mathrm{a}}_2{\mathrm{O}}_5$, ${\mathrm{S}\mathrm{c}}_2{\mathrm{O}}_3$, and ${\mathrm{S}\mathrm{c}}_2{\mathrm{O}}_3$doped ${\mathrm{T}\mathrm{a}}_2{\mathrm{O}}_5$with a cation ratio around 0.1 grown by reactive sputtering. The addition of ${\mathrm{S}\mathrm{c}}_2{\mathrm{O}}_3$as a dopant induces the formation of tantalum suboxide due to the “oxygen getter” property of scandium. The presence of tantalum suboxide greatly affects the optical properties of the coating, resulting in higher absorption loss at $\mathrm{\lambda <\#comment/>}=1064\mathrm{n}\mathrm{m}$. The refractive index and optical band gap of the mixed film do not correspond to those of a mixture of ${\mathrm{T}\mathrm{a}}_2{\mathrm{O}}_5$and ${\mathrm{S}\mathrm{c}}_2{\mathrm{O}}_3$, given the profound structural modifications induced by the dopant. 

   more » « less
4. In-vacuum measurements of optical scatter versus annealing temperature for amorphous Ta ₂ O ₅ and TiO ₂ :Ta ₂ O ₅ thin films

   https://doi.org/10.1364/JOSAA.415665  

   Capote, Elenna_M; Gleckl, Amy; Guerrero, Jazlyn; Rezac, Michael; Wright, Robert; Smith, Joshua_R (March 2021, Journal of the Optical Society of America A)

   Optical coatings formed from amorphous oxide thin films have many applications in precision measurements. The Advanced Laser Interferometer Gravitational-Wave Observatory (LIGO) and Advanced Virgo use coatings of $\mathrm{S}\mathrm{i}{\mathrm{O}}_2$(silica) and $\mathrm{T}\mathrm{i}{\mathrm{O}}_2:\mathrm{T}{\mathrm{a}}_2{\mathrm{O}}_5$(titania-doped tantala) and post-deposition annealing to 500°C to achieve low thermal noise and low optical absorption. Optical scattering by these coatings is a key limit to the sensitivity of the detectors. This paper describes optical scattering measurements for single-layer, ion-beam-sputtered thin films on fused silica substrates: two samples of $\mathrm{T}{\mathrm{a}}_2{\mathrm{O}}_5$and two of $\mathrm{T}\mathrm{i}{\mathrm{O}}_2:\mathrm{T}{\mathrm{a}}_2{\mathrm{O}}_5$. Using an imaging scatterometer at a fixed scattering angle of 12.8°, in-situ changes in the optical scatter of each sample were assessed during post-deposition annealing to 500°C in vacuum. The scatter of three of the four coated optics was observed to decrease during the annealing process, by 25–30% for tantala and up to 74% for titania-doped tantala, while the scatter from the fourth sample held constant. Angle-resolved scatter measurements performed before and after vacuum annealing suggest some improvement in three of the four samples. These results demonstrate that post-deposition, high-temperature annealing of single-layer tantala and titania-doped tantala thin films in vacuum does not lead to an increase in scatter, and may actually improve their scatter. 

   more » « less
5. High Pressure Synthesis of Rubidium Superhydrides

   https://doi.org/10.1103/PhysRevLett.134.196102  

   Kuzovnikov, Mikhail A; Wang, Busheng; Wang, Xiaoyu; Marqueño, Tomas; Shuttleworth, Hannah A; Strain, Calum; Gregoryanz, Eugene; Zurek, Eva; Peña-Alvarez, Miriam; Howie, Ross T (May 2025, Physical Review Letters)

   Through laser-heated diamond anvil cell experiments, we synthesize a series of rubidium superhydrides and explore their properties with synchrotron x-ray powder diffraction and Raman spectroscopy measurements, combined with density functional theory calculations. Upon heating rubidium monohydride embedded in ${\mathrm{H}}_2$at a pressure of 18 GPa, we form ${\mathrm{RbH}}_9\text{−}\mathrm{I}$, which is stable upon decompression down to 8.7 GPa, the lowest stability pressure of any known superhydride. At 22 GPa, another polymorph, ${\mathrm{RbH}}_9\text{−}\mathrm{II}$is synthesised at high temperature. Unique to the Rb-H system among binary metal hydrides is that further compression does not promote the formation of polyhydrides with higher hydrogen content. Instead, heating above 87 GPa yields ${\mathrm{RbH}}_5$, which exhibits two polymorphs ( ${\mathrm{RbH}}_5\text{−}\mathrm{I}$and ${\mathrm{RbH}}_5\text{−}\mathrm{II}$). All of the crystal structures comprise a complex network of quasimolecular ${\mathrm{H}}_2$units and ${\mathrm{H}}^{-}$anions, with ${\mathrm{RbH}}_5$providing the first experimental evidence of linear ${\mathrm{H}}_3^{-}$anions. Published by the American Physical Society2025 

   more » « less