An official website of the United States government
Abstract Ocean wave-powered reverse osmosis (RO) desalination is an emerging field of study that combines the utilization of ocean energy and RO desalination techniques. However, due to the significant fluctuations in pressure and flow rate within the hydraulic system, an accurate transient model is necessary to estimate its performance accurately and effectively. This paper presents a two-dimensional transient model based on the pressure-correction algorithm to simulate the channel flow with porous walls and time-dependent inlet conditions. The coupled pressure, velocity, and salt concentration problem is solved iteratively by decoupling each term and updating them separately. The model is validated by comparing the results with analytical film theory which estimates the formation of the concentration polarization layer under constant inlet conditions. The performance of the RO systems, especially the concentration polarization phenomenon at the member surface, is investigated using different input conditions, including constant flow condition and sinusoidal flow condition. The salt concentration and permeate flux at the membrane boundary are studied to understand the effect of the dynamic inputs. Results show that the system can reach a higher maximum wall concentration and higher average recovery ratio in sinusoidal signal compared with the constant input. The model’s adaptability to different flow regimes, from steady to sinusoidal, underscores its potential as a valuable tool in optimizing RO desalination powered by ocean wave energy.
more »
« less
This content will become publicly available on March 1, 2027
Analysis of feed fluctuations on Ocean Wave-Powered Reverse Osmosis (WPRO) desalination using transient model
Wave-Powered Reverse Osmosis (WPRO) represents a promising convergence of ocean energy harvesting and advanced Reverse Osmosis (RO) desalination techniques. The significant fluctuations in pressures and flow rates within the integrated WPRO system present a critical challenge, necessitating an accurate transient model for effective performance estimation. This study presents a two-dimensional transient model based on pressure-correction algorithm to simulate channel flow with membrane boundary conditions under varying inlet conditions. The coupled dynamics of pressure, velocity, and salt concentration are addressed iteratively by decoupling and updating each term separately. The model investigates the performance of RO systems under different input conditions, including constant, sinusoidal, and irregular flow. The results indicate that constant input with higher pressure and lower flow rate achieves a better Recovery Ratio (RR). It is emphasized that for WPRO systems, a fair comparison requires choosing the same average power or pressure when evaluating different inputs. Under equivalent input power, sinusoidal waves result in a lower RR compared to constant inputs due to reduced average pressure. Conversely, under equivalent inlet pressure and flow rate, sinusoidal waves achieve a higher RR than constant inputs due to the phase difference between pressuredriven permeate velocity and diffusion-driven Concentration Polarization (CP). Specifically, sinusoidal inputs with higher frequency and higher amplitude display a higher RR. Additionally, irregular input yields a higher RR than constant inputs, as mean pressure and power can be maintained at levels comparable to those of constant input. The model’s adaptability to diverse flow regimes — from steady to sinusoidal and irregular fluctuations — highlights its potential as a critical tool for optimizing RO desalination processes powered by renewable ocean energy.
more »
« less
- Award ID(s):
- 2246608
- PAR ID:
- 10658859
- Publisher / Repository:
- Elsevier
- Date Published:
- Journal Name:
- Desalination
- Volume:
- 621
- Issue:
- C
- ISSN:
- 0011-9164
- Page Range / eLocation ID:
- 119676
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
null (Ed.)Seawater desalination has become an important tool to attain global water security and sustainability. Among the available technologies, reverse osmosis (RO) has become the golden standard for seawater desalination due to its unparalleled energy efficiency. While RO is already efficient after development for half a century, there remains room for over 50% further reduction in energy consumption that can translate into tens of terawatt hours of potential annual energy saving. However, this significant energy saving cannot be achieved under the conventional paradigm of on-ground RO. In this analysis, we assess the idea of operating RO with open modules several hundred meters below the ocean surface ( i.e. , the mesopelagic zone). This new process, namely mesopelagic open reverse osmosis (MORO), can potentially push the energy consumption of seawater desalination to its theoretical limit. We first describe the concept of MORO, and then examine both the theoretical potential of energy saving and the practical challenges facing the implementation of MORO. Our analysis provides a theoretical framework for the future development of MORO for more sustainable desalination.more » « less
-
A unique aqueous silica removal process using naturally occurring diatoms for water reuse and desalination is described. Several strains of brackish water diatoms have been isolated and tested. Among them Pseudostaurosira and Nitzschia species showed promise. Reverse osmosis (RO) concentrate samples from two full-scale advanced water purification facilities and one brackish groundwater RO plant in Southern California have been successfully treated by this process. This new photobiological process could remove aqueous silica, as well as phosphate, ammonia, nitrate, calcium, iron and manganese very effectively. Under non-optimized conditions, 95% of 78 mg·L-1 reactive silica in an RO concentrate sample could be removed within 72 hours. In most cases, addition of nutrients was not necessary because the RO concentrate typically contains sufficient concentrations of macronutrients derived from the source water (i.e., treated wastewater and brackish groundwater). Preliminary characterization of organics indicated that there was no major generation of dissolved organics, which could potentially foul membranes in the subsequent RO process. This new algal process has a strong potential for its application in desalination and water reuse in the United States and around the world.more » « less
-
The paper presents a new methodology for short-term (5–25 min) benchtop tests to evaluate the effectiveness of magnetic treatment of feed water for reducing mineral scaling on a reverse osmosis (RO) membrane. Scale deposition is measured at a controlled level of salt supersaturation in water flowing through an RO unit in once-through mode. A magnetic water conditioner is tested in a transient flow regime when variations of the permeate flux along the flow path are insignificant. Scale formation under these conditions is governed by salt crystallization on the membrane surface. The proposed method was implemented to investigate the influence of magnetic treatment on gypsum deposition on RO membranes in supersaturated aqueous CaSO4/NaCl solutions. The effects of magnetic water treatment on scale formation under our experimental conditions were found to be statistically insignificant with a confidence level of 95%. However, this outcome should not be considered to negate the potential efficiency of magnetic water treatment in specific applications. The proposed methodology of testing under a controlled level of salt supersaturation will also be useful for evaluating the efficiency of other water treatment technologies.more » « less
-
The pressure-recovery (P-Y) diagram used in reverse osmosis (RO) literature to compare energy consumptions in different RO configurations has a flaw of not holding the design flux constant. In this work, the P-Y diagrams are constructed with the aid of transport models. It is shown that the area underneath the P-Y curve represents the specific energy consumption (SEC) imposed by design flux and thermodynamics, which may be reduced by improving spatial uniformity in flux. The trend generally observes the equipartition of entropy production theorem. For seawater RO (SWRO) in which pressure drop relative to feed osmotic pressure is small and operation is near the thermodynamic limit, staged designs with interstage booster pumps enable a more uniform flux, thus reducing the SEC. However, for low-salinity brackish water RO (BWRO), improving flux uniformity may lead to a higher SEC as the increased friction loss often outweighs the reduced energy requirement imposed by system flux.more » « less
