The recent demonstration of W mm−1output power at 94 GHz in AlN/GaN/AlN high‐electron‐mobility transistors (HEMTs) has established AlN as a promising platform for millimeter‐wave electronics. The current state‐of‐art AlN HEMTs using ex situ‐deposited silicon nitride (SiN) passivation layers suffer from soft gain compression due to trapping of carriers by surface states. Reducing surface state dispersion in these devices is thus desired to access higher output powers. Herein, a potential solution using a novel in situ crystalline AlN passivation layer is provided. A thick, 30+ nm‐top AlN passivation layer moves the as‐grown surface away from the 2D electron gas (2DEG) channel and reduces its effect on the device. Through a series of metal‐polar AlN/GaN/AlN heterostructure growths, it is found that pseudomorphically strained 15 nm thin GaN channels are crucial to be able to grow thick AlN barriers without cracking. The fabricated recessed‐gate HEMTs on an optimized heterostructure with 50 nm AlN barrier layer and 15 nm GaN channel layer show reduction in dispersion down to compared with in current state‐of‐art ex situ SiN‐passivated HEMTs. These results demonstrate the efficacy of this unique in situ crystalline AlN passivation technique and should unlock higher mm‐wave powers in next‐generation AlN HEMTs.
- NSF-PAR ID:
- 10188502
- Date Published:
- Journal Name:
- Applied Physics Express
- ISSN:
- 1882-0778
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
-
The ultra-wide bandgap of Al-rich AlGaN is expected to support a significantly larger breakdown field compared to GaN, but the reported performance thus far has been limited by the use of foreign substrates. In this Letter, the material and electrical properties of Al 0.85 Ga 0.15 N/Al 0.6 Ga 0.4 N high electron mobility transistors (HEMT) grown on a 2-in. single crystal AlN substrate are investigated, and it is demonstrated that native AlN substrates unlock the potential for Al-rich AlGaN to sustain large fields in such devices. We further study how Ohmic contacts made directly to a Si-doped channel layer reduce the knee voltage and increase the output current density. High-quality AlGaN growth is confirmed via scanning transmission electron microscopy, which also reveals the absence of metal penetration at the Ohmic contact interface and is in contrast to established GaN HEMT technology. Two-terminal mesa breakdown characteristics with 1.3 μm separation possess a record-high breakdown field strength of ∼11.5 MV/cm for an undoped Al 0.6 Ga 0.4 N-channel layer. The breakdown voltages for three-terminal devices measured with gate-drain distances of 4 and 9 μm are 850 and 1500 V, respectively.more » « less
-
We present a thermodynamic analysis of the recently discovered nitride ferroelectric materials using the classic Landau–Devonshire approach. Electrostrictive and dielectric stiffness coefficients of Al 1− x Sc x N with a wurtzite structure ( 6 mm) are determined using a free energy density function assuming a hexagonal parent phase (6/ mmm), with the first-order phase transition based on the dielectric stiffness relationships. The results of this analysis show that the strain sensitivity of the energy barrier is one order of magnitude larger than that of the spontaneous polarization in these wurtzite ferroelectrics, yet both are less sensitive to strain compared to classic perovskite ferroelectrics. These analysis results reported here explain experimentally reported sensitivity of the coercive field to elastic strain/stress in Al 1− x Sc x N films and would enable further thermodynamic analysis via phase field simulation and related methods.more » « less
-
more » « less
Abstract The residue of common photo‐ and electron‐beam resists, such as poly(methyl methacrylate) (PMMA), is often present on the surface of 2D crystals after device fabrication. The residue degrades device properties by decreasing carrier mobility and creating unwanted doping. Here, MoS2and WSe2field effect transistors (FETs) with residue are cleaned by contact mode atomic force microscopy (AFM) and the impact of the residue on: 1) the intrinsic electrical properties, and 2) the effectiveness of electric double layer (EDL) gating are measured. After cleaning, AFM measurements confirm that the surface roughness decreases to its intrinsic state (i.e., ≈0.23 nm for exfoliated MoS2and WSe2) and Raman spectroscopy shows that the characteristic peak intensities (E2gand A1g) increase. PMMA residue causes p‐type doping corresponding to a charge density of ≈7 × 1011cm−2on back‐gated MoS2and WSe2FETs. For FETs gated with polyethylene oxide (PEO)76:CsClO4, removing the residue increases the charge density by 4.5 × 1012cm−2, and the maximum drain current by 247% (statistically significant,
p < 0.05). Removing the residue likely allows the ions to be positioned closer to the channel surface, which is essential for achieving the best possible electrostatic gate control in ion‐gated devices. -
more » « less
Abstract Originally based on phenomenological observations, the Janovec–Kay–Dunn (JKD) scaling law has been historically used to describe the dependence of the ferroelectric coercive fields (
E c ) on a critical length scale of the material, wherein the film thickness (t ) is considered the length scale, andE c ∝t −2/3. Here, for the first time, a JKD‐type scaling behavior is reported in an antiferroelectric material, using the ultra‐thin films of prototypical flourite‐structure binary oxide, zirconia. In these films, a decrease in the ZrO2layer thickness from 20 nm to 5.4 nm leads to an increase in critical fields for both nonpolar‐to‐polar (E a ), and polar‐to‐nonpolar (E f ) transitions, accompanied by a decrease in the average crystallite size, and an increase in the tetragonal distortion of the non‐polarP 42/nmc ground state structure. Notably, the ‐2/3 power law as in the JKD law holds when average crystallite size (d ), measured from glancing‐incident X‐ray diffraction, is considered as the critical length scale—i .e .,E a ,E f ∝d −2/3. First principles calculations suggest that the increase of tetragonality in thinner films contributes to an increase of the energy barrier for the transition from the non‐polar tetragonal ground state to the field‐induced polar orthorhombic phase, and in turn, an increase inE a critical fields. These results suggest a de‐stabilization of the ferroelectric phase with a decreasing thickness in antiferroelectric ZrO2, which is contrary to the observations in its fluorite‐structure ferroelectric counterparts. With the recent interests in utilizing antiferroelectricity for advanced semiconductor applications, our fundamental exposition of the thickness dependence of functional responses therein can accelerate the development of miniaturized, antiferroelectric electronic memory elements for the complementary metal‐oxide‐semiconductor based high‐volume manufacturing platforms.
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.35848/1882-0786/abb1c8
